| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/hwmon/ |
| D | adt7475.yaml | 43 "^adi,bypass-attenuator-in[0-4]$":
45 Configures bypassing the individual voltage input attenuator. If
46 set to 1 the attenuator is bypassed if set to 0 the attenuator is
47 not bypassed. If the property is absent then the attenuator
79 adi,bypass-attenuator-in0 = <1>;
80 adi,bypass-attenuator-in1 = <0>;
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/hwmon/ |
| D | adt7475.yaml | 55 "^adi,bypass-attenuator-in[0-4]$":
57 Configures bypassing the individual voltage input attenuator. If
58 set to 1 the attenuator is bypassed if set to 0 the attenuator is
59 not bypassed. If the property is absent then the attenuator
99 adi,bypass-attenuator-in0 = <1>;
100 adi,bypass-attenuator-in1 = <0>;
|
| /kernel/linux/linux-6.6/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-frequency-admv1014 | 5 Read/write value for the digital attenuator gain (IF_I) with coarse steps.
11 Read/write value for the digital attenuator gain (IF_Q) with coarse steps.
17 Read/write value for the digital attenuator gain (IF_I) with fine steps.
23 Read/write value for the digital attenuator gain (IF_Q) with fine steps.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/iio/amplifiers/ |
| D | adi,hmc425a.yaml | 7 title: HMC425A 6-bit Digital Step Attenuator
14 Digital Step Attenuator IIO device with gpio interface.
15 HMC425A 0.5 dB LSB GaAs MMIC 6-BIT DIGITAL POSITIVE CONTROL ATTENUATOR, 2.2 - 8.0 GHz
|
| /kernel/linux/linux-5.10/Documentation/hwmon/ |
| D | powr1220.rst | 27 An in-line attenuator allows measurements from 0 to 6 V. The
28 attenuator is enabled or disabled depending on the setting of the
29 input's max value. The driver will enable the attenuator for any
|
| /kernel/linux/linux-6.6/Documentation/hwmon/ |
| D | powr1220.rst | 27 An in-line attenuator allows measurements from 0 to 6 V. The
28 attenuator is enabled or disabled depending on the setting of the
29 input's max value. The driver will enable the attenuator for any
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/iio/amplifiers/ |
| D | adi,hmc425a.yaml | 7 title: HMC425A 6-bit Digital Step Attenuator
13 Digital Step Attenuator IIO device with gpio interface.
14 HMC425A 0.5 dB LSB GaAs MMIC 6-BIT DIGITAL POSITIVE CONTROL ATTENUATOR, 2.2 - 8.0 GHz
|
| /kernel/linux/linux-6.6/drivers/iio/amplifiers/ |
| D | Kconfig | 21 HMC792A 0.25 dB LSB GaAs MMIC 6-Bit Digital Attenuator
22 HMC1119 0.25 dB LSB, 7-Bit, Silicon Digital Attenuator
|
| D | ad8366.c | 8 * HMC792A 0.25 dB LSB GaAs MMIC 6-Bit Digital Attenuator
9 * HMC1119 0.25 dB LSB, 7-Bit, Silicon Digital Attenuator
|
| /kernel/linux/linux-6.6/drivers/hwmon/ |
| D | powr1220.c | 119 * figure out if we need to use the attenuator for in powr1220_read_adc()
121 * for. We dynamically set the attenuator depending on the in powr1220_read_adc()
128 /* set the attenuator and mux */ in powr1220_read_adc()
|
| D | adt7475.c | 202 u8 bypass_attn; /* Bypass voltage attenuator */
1577 set_property_bit(client, "adi,bypass-attenuator-in0", in load_attenuators()
1579 set_property_bit(client, "adi,bypass-attenuator-in1", in load_attenuators()
1581 set_property_bit(client, "adi,bypass-attenuator-in3", in load_attenuators()
1583 set_property_bit(client, "adi,bypass-attenuator-in4", in load_attenuators()
1590 set_property_bit(client, "adi,bypass-attenuator-in1", in load_attenuators()
1725 dev_warn(&client->dev, "Error configuring attenuator bypass\n"); in adt7475_probe()
|
| /kernel/linux/linux-6.6/drivers/input/mouse/ |
| D | cyapa_gen6.c | 624 /* 2. IDAC and RX Attenuator Calibration Data (Center Frequency). */ in cyapa_gen6_show_baseline()
633 data[0], /* RX Attenuator Mutual */ in cyapa_gen6_show_baseline()
635 data[2], /* RX Attenuator Self RX */ in cyapa_gen6_show_baseline()
637 data[4], /* RX Attenuator Self TX */ in cyapa_gen6_show_baseline()
641 /* 3. Read Attenuator Trim. */ in cyapa_gen6_show_baseline()
649 /* set attenuator trim values. */ in cyapa_gen6_show_baseline()
|
| /kernel/linux/linux-5.10/drivers/input/mouse/ |
| D | cyapa_gen6.c | 624 /* 2. IDAC and RX Attenuator Calibration Data (Center Frequency). */ in cyapa_gen6_show_baseline()
633 data[0], /* RX Attenuator Mutual */ in cyapa_gen6_show_baseline()
635 data[2], /* RX Attenuator Self RX */ in cyapa_gen6_show_baseline()
637 data[4], /* RX Attenuator Self TX */ in cyapa_gen6_show_baseline()
641 /* 3. Read Attenuator Trim. */ in cyapa_gen6_show_baseline()
649 /* set attenuator trim values. */ in cyapa_gen6_show_baseline()
|
| /kernel/linux/linux-5.10/drivers/hwmon/ |
| D | powr1220.c | 116 * figure out if we need to use the attenuator for in powr1220_read_adc()
118 * for. We dynamically set the attenuator depending on the in powr1220_read_adc()
125 /* set the attenuator and mux */ in powr1220_read_adc()
|
| D | adt7475.c | 201 u8 bypass_attn; /* Bypass voltage attenuator */
1486 set_property_bit(client, "adi,bypass-attenuator-in0", in load_attenuators()
1488 set_property_bit(client, "adi,bypass-attenuator-in1", in load_attenuators()
1490 set_property_bit(client, "adi,bypass-attenuator-in3", in load_attenuators()
1492 set_property_bit(client, "adi,bypass-attenuator-in4", in load_attenuators()
1500 set_property_bit(client, "adi,bypass-attenuator-in1", in load_attenuators()
1633 dev_warn(&client->dev, "Error configuring attenuator bypass\n"); in adt7475_probe()
|
| /kernel/linux/linux-5.10/drivers/iio/amplifiers/ |
| D | Kconfig | 21 HMC1119 0.25 dB LSB, 7-Bit, Silicon Digital Attenuator
|
| D | ad8366.c | 8 * HMC1119 0.25 dB LSB, 7-Bit, Silicon Digital Attenuator
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/clock/ |
| D | renesas,versaclock7.yaml | 14 jitter attenuator ICs with fractional and integer dividers.
|
| /kernel/linux/linux-5.10/sound/soc/codecs/ |
| D | ak4458.h | 75 /* DAC Digital attenuator transition time setting
|
| D | cs42l56.c | 92 { 32, 0x00 }, /* r20 - ADCA Attenuator */
93 { 33, 0x00 }, /* r21 - ADCB Attenuator */
|
| /kernel/linux/linux-6.6/sound/soc/codecs/ |
| D | ak4458.h | 75 /* DAC Digital attenuator transition time setting
|
| D | cs42l56.c | 92 { 32, 0x00 }, /* r20 - ADCA Attenuator */
93 { 33, 0x00 }, /* r21 - ADCB Attenuator */
|
| /kernel/linux/linux-5.10/Documentation/admin-guide/media/ |
| D | si476x.rst | 98 0x04 fmagc1 FMAGC1 attenuator resistance
|
| /kernel/linux/linux-6.6/Documentation/admin-guide/media/ |
| D | si476x.rst | 98 0x04 fmagc1 FMAGC1 attenuator resistance
|
| /kernel/linux/linux-6.6/drivers/clk/ |
| D | Kconfig | 406 and jitter attenuator ICs with fractional and integer dividers.
|