Searched full:celsius (Results 1 – 25 of 534) sorted by relevance
12345678910>>...22
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/power/supply/ |
| D | battery.yaml | 91 - description: the temperature in degree Celsius 94 A table providing the temperature in degree Celsius 99 ocv-capacity-celsius: 101 An array containing the temperature in degree Celsius, 104 operating-range-celsius: 110 ambient-celsius: 116 alert-celsius: 162 ocv-capacity-celsius = <(-10) 0 10>; 163 /* table for -10 degree Celsius */ 165 /* table for 0 degree Celsius */ [all …]
|
| D | maxim,max77693.yaml | 42 maxim,thermal-regulation-celsius: 44 Temperature in Celsius for entering high temperature charging mode. 46 reduced by 105 mA/Celsius.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/power/supply/ |
| D | battery.yaml | 75 An array providing the temperature in degree Celsius 80 ocv-capacity-celsius: 82 An array containing the temperature in degree Celsius, 85 operating-range-celsius: 92 ambient-celsius: 99 alert-celsius: 146 ocv-capacity-celsius = <(-10) 0 10>; 147 /* table for -10 degree Celsius */ 149 /* table for 0 degree Celsius */ 151 /* table for 10 degree Celsius */ [all …]
|
| D | summit,smb347-charger.yaml | 64 summit,chip-temperature-threshold-celsius: 137 summit,chip-temperature-threshold-celsius = <110>; 150 operating-range-celsius = <0 45>; 151 alert-celsius = <3 42>;
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/iio/afe/ |
| D | temperature-sense-rtd.yaml | 15 (usually 0 to 100 degrees Celsius). 62 alpha-ppm-per-celsius: 64 alpha can also be expressed in micro-ohms per ohm Celsius. It's a linear 66 between 0 and 100 degrees Celsius. 70 Where, R_100 is the resistance of the sensor at 100 degrees Celsius, and 72 Celsius. 79 Resistance of the sensor at 0 degrees Celsius. 87 - alpha-ppm-per-celsius 98 alpha-ppm-per-celsius = <3908>;
|
| D | temperature-transducer.yaml | 67 This offset is commonly used to convert from Kelvins to degrees Celsius. 78 alpha-ppm-per-celsius: 83 degrees Celsius or micro-volts per degrees Celsius. The is the main 92 - alpha-ppm-per-celsius 101 sense-offset-millicelsius = <(-273150)>; /* Kelvin to degrees Celsius */ 103 alpha-ppm-per-celsius = <1>; /* 1 uA/K */ 111 sense-offset-millicelsius = <(-273150)>; /* Kelvin to degrees Celsius */ 112 alpha-ppm-per-celsius = <4000>; /* 4 mV/K */
|
| /kernel/linux/linux-6.6/Documentation/hwmon/ |
| D | ds1621.rst | 67 degree Celsius to +125 in 0.5 increments. You may convert this into a 83 1.0 degree Celsius to avoid Tout "bouncing", though! 125 - DS1621: +/- 0.5 degree Celsius (from 0 to +70 degrees) 126 - DS1625: +/- 0.5 degree Celsius (from 0 to +70 degrees) 127 - DS1631: +/- 0.5 degree Celsius (from 0 to +70 degrees) 128 - DS1721: +/- 1.0 degree Celsius (from -10 to +85 degrees) 129 - DS1731: +/- 1.0 degree Celsius (from -10 to +85 degrees) 146 0 0 9 bits, 0.5 degrees Celsius 147 1 0 10 bits, 0.25 degrees Celsius 148 0 1 11 bits, 0.125 degrees Celsius [all …]
|
| D | w83773g.rst | 26 Temperature is measured in degrees Celsius. 28 range of -40 to +125 degrees Celsius (for local sensor) and -40 to +127 29 degrees Celsius (for remote sensors).
|
| D | sht21.rst | 40 0.2 degree Celsius) compared with the SHT21 (2.0% relative humidity, 41 0.3 degree Celsius). 64 Celsius, the device should not be active for more than 10% of the time,
|
| D | sht4x.rst | 25 and temperature sensor. Temperature is measured in degree celsius, relative 27 scaled by 1000, i.e. the value for 31.5 degrees celsius is 31500. 40 temp1_input Measured temperature in millidegrees Celsius
|
| /kernel/linux/linux-5.10/Documentation/hwmon/ |
| D | ds1621.rst | 67 degree Celsius to +125 in 0.5 increments. You may convert this into a 83 1.0 degree Celsius to avoid Tout "bouncing", though! 125 - DS1621: +/- 0.5 degree Celsius (from 0 to +70 degrees) 126 - DS1625: +/- 0.5 degree Celsius (from 0 to +70 degrees) 127 - DS1631: +/- 0.5 degree Celsius (from 0 to +70 degrees) 128 - DS1721: +/- 1.0 degree Celsius (from -10 to +85 degrees) 129 - DS1731: +/- 1.0 degree Celsius (from -10 to +85 degrees) 146 0 0 9 bits, 0.5 degrees Celsius 147 1 0 10 bits, 0.25 degrees Celsius 148 0 1 11 bits, 0.125 degrees Celsius [all …]
|
| D | w83773g.rst | 26 Temperature is measured in degrees Celsius. 28 range of -40 to +125 degrees Celsius (for local sensor) and -40 to +127 29 degrees Celsius (for remote sensors).
|
| D | sysfs-interface.rst | 445 Unit: millidegree Celsius (or millivolt, see below) 452 Unit: millidegree Celsius 459 Unit: millidegree Celsius 468 Unit: millidegree Celsius 478 Unit: millidegree Celsius 486 Unit: millidegree Celsius 493 Unit: millidegree Celsius 505 Unit: millidegree Celsius 512 Unit: millidegree Celsius 523 Unit: millidegree Celsius [all …]
|
| D | sht21.rst | 40 0.2 degree Celsius) compared with the SHT21 (2.0% relative humidity, 41 0.3 degree Celsius). 64 Celsius, the device should not be active for more than 10% of the time,
|
| /kernel/linux/linux-6.6/Documentation/ABI/testing/ |
| D | sysfs-class-hwmon | 380 Unit: millidegree Celsius (or millivolt, see below) 388 Unit: millidegree Celsius 396 Unit: millidegree Celsius 406 Unit: millidegree Celsius 417 Unit: millidegree Celsius 426 Unit: millidegree Celsius 448 Unit: millidegree Celsius 461 Unit: millidegree Celsius 469 Unit: millidegree Celsius 481 Unit: millidegree Celsius [all …]
|
| /kernel/linux/linux-6.6/drivers/gpu/drm/amd/pm/swsmu/inc/pmfw_if/ |
| D | smu11_driver_if_vangogh.h | 186 uint16_t CoreTemperature[8]; //[centi-Celsius] 188 uint16_t L3Temperature[2]; //[centi-Celsius] 190 uint16_t GfxTemperature; //[centi-Celsius] 191 uint16_t SocTemperature; //[centi-Celsius] 216 uint16_t CoreTemperature[4]; //[centi-Celsius] 218 uint16_t L3Temperature[1]; //[centi-Celsius] 220 uint16_t GfxTemperature; //[centi-Celsius] 221 uint16_t SocTemperature; //[centi-Celsius]
|
| D | smu11_driver_if_cyan_skillfish.h | 43 uint16_t CoreTemperature[6]; //[centi-Celsius] 45 uint16_t L3Temperature[2]; //[centi-Celsius] 50 uint16_t GfxTemperature; //[centi-Celsius] 64 uint16_t SocTemperature; //[centi-Celsius]
|
| /kernel/linux/linux-5.10/include/linux/ |
| D | power_supply.h | 23 * µA, µAh, µWh, seconds and tenths of degree Celsius unless otherwise 339 int temp; /* celsius */ 368 int ocv_temp[POWER_SUPPLY_OCV_TEMP_MAX];/* celsius */ 369 int temp_ambient_alert_min; /* celsius */ 370 int temp_ambient_alert_max; /* celsius */ 371 int temp_alert_min; /* celsius */ 372 int temp_alert_max; /* celsius */ 373 int temp_min; /* celsius */ 374 int temp_max; /* celsius */
|
| D | units.h | 73 * deci_kelvin_to_millicelsius_with_offset - convert Kelvin to Celsius 75 * @offset: difference between Kelvin and Celsius in millidegrees 77 * Return: temperature value in millidegrees Celsius
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/iio/temperature/ |
| D | mlx90632.txt | 7 temperature is in range between -20 to 200 degrees Celsius with relative error 8 of measurement below 1 degree Celsius in object temperature range for 10 in range of -20 to 85 degrees Celsius it is suitable also for outdoor use.
|
| /kernel/linux/linux-5.10/Documentation/driver-api/thermal/ |
| D | exynos_thermal.rst | 40 Trimming info for 25 degree Celsius (stored at TRIMINFO register) 41 Temperature code measured at 25 degree Celsius which is unchanged 43 Trimming info for 85 degree Celsius (stored at TRIMINFO register) 44 Temperature code measured at 85 degree Celsius which is unchanged
|
| /kernel/linux/linux-6.6/Documentation/driver-api/thermal/ |
| D | exynos_thermal.rst | 40 Trimming info for 25 degree Celsius (stored at TRIMINFO register) 41 Temperature code measured at 25 degree Celsius which is unchanged 43 Trimming info for 85 degree Celsius (stored at TRIMINFO register) 44 Temperature code measured at 85 degree Celsius which is unchanged
|
| /kernel/linux/linux-6.6/drivers/hwmon/ |
| D | lm70.c | 79 * Further, each bit represents 0.25 degrees Celsius; so, multiply in temp1_input_show() 81 * Celsius. in temp1_input_show() 86 * resolution 0.0625 degrees celsius. in temp1_input_show() 90 * resolution 0.0312 degrees celsius. in temp1_input_show() 95 * data format with a resolution of 0.25 degrees celsius per unit. in temp1_input_show() 118 status = sprintf(buf, "%d\n", val); /* millidegrees Celsius */ in temp1_input_show()
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/iio/temperature/ |
| D | melexis,mlx90632.yaml | 18 Celsius with relative error of measurement below 1 degree Celsius in 21 Celsius it is suitable also for outdoor use.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/ |
| D | property-units.txt | 39 -celsius : degree Celsius 40 -millicelsius : millidegree Celsius
|
12345678910>>...22