Searched full:ldos (Results 1 – 25 of 136) sorted by relevance
123456
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/regulator/ |
| D | twl-regulator.txt | 4 For twl6030 regulators/LDOs
21 For twl6032 regulators/LDOs
35 For twl4030 regulators/LDOs
60 For twl4030 regulators/LDOs:
75 For twl6030 regulators/LDOs:
|
| D | rohm,bd71815-regulator.yaml | 57 comments below for bucks/LDOs which support this. 0 means
77 comments below for bucks/LDOs which support this. 0 means
86 comments below for bucks/LDOs which support this. 0 means
99 # Bucks 3-5 and ldos 1-5 support setting the RUN state voltage here.
|
| D | maxim,max77802.yaml | 31 regulators are:: bucks 2-4 and LDOs 1-35. Also, it only takes effect if the
43 LDOs supporting the regulator-initial-mode property and changing their
52 LDOs supporting the regulator-mode property (changing mode to Low Power
|
| D | sprd,sc2731-regulator.txt | 4 14 LDO and 3 DCDCs are designed for external use. All DCDCs/LDOs have
6 ceramic capacitors are recommended to use with these LDOs.
|
| D | regulator-max77620.txt | 3 Device has multiple DCDC(sd[0-3] and LDOs(ldo[0-8]). The input supply
38 There are also additional properties for SD/LDOs. These additional properties
39 are required to configure FPS configuration parameters for SDs and LDOs.
113 LDOs: 5mV/us, 100mV/us
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/regulator/ |
| D | twl-regulator.txt | 4 For twl6030 regulators/LDOs
21 For twl6032 regulators/LDOs
35 For twl4030 regulators/LDOs
60 For twl4030 regulators/LDOs:
75 For twl6030 regulators/LDOs:
|
| D | max77802.txt | 44 -LDOn : for LDOs, where n can lie in ranges 1-15, 17-21, 23-30
57 changing their mode during normal operation are: LDOs 1, 3, 20 and 21.
68 are: BUCKs 2-4 and LDOs 1-35. Also, it only takes effect if the regulator has
|
| D | sprd,sc2731-regulator.txt | 4 14 LDO and 3 DCDCs are designed for external use. All DCDCs/LDOs have
6 ceramic capacitors are recommended to use with these LDOs.
|
| D | regulator-max77620.txt | 3 Device has multiple DCDC(sd[0-3] and LDOs(ldo[0-8]). The input supply
38 Theres are also additional properties for SD/LDOs. These additional properties
39 are required to configure FPS configuration parameters for SDs and LDOs.
113 LDOs: 5mV/us, 100mV/us
|
| /kernel/linux/linux-5.10/drivers/regulator/ |
| D | Kconfig | 114 Say y here to support Freescale i.MX on-chip ANATOP LDOs
266 Say y here to support the BUCKs and LDOs regulators found on
280 Say y here to support the BUCKs and LDOs regulators found on
290 Say y here to support the BUCKs and LDOs regulators found on
300 Say y here to support the BUCKs and LDOs regulators found on
376 21 general purpose LDOs, 3 dedicated LDOs, and 5 BUCKs. All
386 provides 5 general purpose LDOs, and all of them come with support
417 Other LDOs are used for the display module.
501 regulator. The MAX77836 has two additional LDOs.
517 chip to control Step-Down DC-DC and LDOs. Say Y here to
[all …]
|
| D | max77802-regulator.c | 109 * Some LDOs support Low Power Mode while the system is running.
111 * LDOs 1, 3, 20, 21.
159 * Enable Control Logic1 by PWRREQ (BUCK 2-4 and LDOs 2, 4-19, 22-35)
160 * Enable Control Logic2 by PWRREQ (LDOs 1, 20, 21)
289 * LDOs 2, 4-19, 22-35
305 * LDOs 1, 20, 21, 3
364 /* LDOs 3-7, 9-14, 18-26, 28, 29, 32-34 */
385 /* LDOs 1, 2, 8, 15, 17, 27, 30, 35 */
|
| D | max77686-regulator.c | 42 * Values used for configuring LDOs and bucks.
52 /* Low power mode controlled by PWRREQ: All LDOs */
94 /* all LDOs */ in max77686_get_opmode_shift()
119 /* Some BUCKs and LDOs supports Normal[ON/OFF] mode during suspend */
138 /* Some LDOs supports [LPM/Normal]ON mode during suspend state */
173 /* Some LDOs supports LPM-ON/OFF/Normal-ON mode during suspend state */
|
| D | da9063-regulator.c | 46 /* LDOs on both DA9063 and DA9063L */
53 /* DA9063-only LDOs */
268 * LDOs use sleep flags - one for normal and one for suspend state.
521 /* The following LDOs are present only on DA9063, not on DA9063L */
615 /* The following LDOs are present only on DA9063, not on DA9063L */
828 /* LDOs overcurrent event support */ in da9063_regulator_probe()
|
| /kernel/linux/linux-6.6/drivers/regulator/ |
| D | Kconfig | 114 Say y here to support Freescale i.MX on-chip ANATOP LDOs
283 Say y here to support the BUCKs and LDOs regulators found on
297 Say y here to support the BUCKs and LDOs regulators found on
307 Say y here to support the BUCKs and LDOs regulators found on
317 Say y here to support the BUCKs and LDOs regulators found on
413 21 general purpose LDOs, 3 dedicated LDOs, and 5 BUCKs. All
423 provides 5 general purpose LDOs, and all of them come with support
463 Other LDOs are used for the display module.
547 regulator. The MAX77836 has two additional LDOs.
584 chip to control Step-Down DC-DC and LDOs. Say Y here to
[all …]
|
| D | max77802-regulator.c | 108 * Some LDOs support Low Power Mode while the system is running.
110 * LDOs 1, 3, 20, 21.
158 * Enable Control Logic1 by PWRREQ (BUCK 2-4 and LDOs 2, 4-19, 22-35)
159 * Enable Control Logic2 by PWRREQ (LDOs 1, 20, 21)
236 * LDOs 2, 4-19, 22-35
252 * LDOs 1, 20, 21, 3
310 /* LDOs 3-7, 9-14, 18-26, 28, 29, 32-34 */
331 /* LDOs 1, 2, 8, 15, 17, 27, 30, 35 */
|
| D | max77686-regulator.c | 42 * Values used for configuring LDOs and bucks.
52 /* Low power mode controlled by PWRREQ: All LDOs */
87 /* all LDOs */ in max77686_get_opmode_shift()
112 /* Some BUCKs and LDOs supports Normal[ON/OFF] mode during suspend */
131 /* Some LDOs supports [LPM/Normal]ON mode during suspend state */
166 /* Some LDOs supports LPM-ON/OFF/Normal-ON mode during suspend state */
|
| D | rohm-regulator.c | 118 * Other bucks and all LDOs must be disabled when voltage is changed.
119 * BD96801 - LDO voltage levels can be changed when LDOs are disabled.
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/mfd/ |
| D | da9062.txt | 11 da9062-regulator : : LDOs & BUCKs
22 da9062-regulator : : LDOs & BUCKs
54 - regulators : This node defines the settings for the LDOs and BUCKs.
|
| D | mediatek,mt6357.yaml | 15 converters and 29 LDOs. Supported features are audio codec,
44 List of MT6357 BUCKs and LDOs regulators.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mfd/ |
| D | da9062.txt | 11 da9062-regulator : : LDOs & BUCKs
22 da9062-regulator : : LDOs & BUCKs
53 - regulators : This node defines the settings for the LDOs and BUCKs.
|
| D | da9063.txt | 7 da9063-regulator : : LDOs & BUCKs
24 - regulators : This node defines the settings for the LDOs and BUCKs.
|
| /kernel/linux/linux-6.6/include/linux/mfd/ |
| D | twl.h | 702 #define TPS_SUBSET BIT(1) /* tps659[23]0 have fewer LDOs */
729 * the LDOs, and leave the three buck converters alone. VDD1 and VDD2
740 /* EXTERNAL LDOs */
753 /* INTERNAL LDOs */
773 /* EXTERNAL LDOs */
785 /* INTERNAL LDOs */
789 /* LDOs on 6025 have different names */
|
| /kernel/linux/linux-5.10/include/linux/mfd/ |
| D | twl.h | 760 #define TPS_SUBSET BIT(1) /* tps659[23]0 have fewer LDOs */
789 * the LDOs, and leave the three buck converters alone. VDD1 and VDD2
800 /* EXTERNAL LDOs */
813 /* INTERNAL LDOs */
833 /* EXTERNAL LDOs */
845 /* INTERNAL LDOs */
849 /* LDOs on 6025 have different names */
|
| /kernel/linux/linux-6.6/include/linux/regulator/ |
| D | mt6357-regulator.h | 17 /* LDOs */
|
| /kernel/linux/linux-6.6/drivers/mfd/ |
| D | lp8788.c | 77 /* 12 digital ldos */
91 /* 10 analog ldos */
|
123456