Searched full:scfw (Results 1 – 22 of 22) sorted by relevance
18 The System Controller Firmware (SCFW) is a low-level system function30 The System Controller Firmware (SCFW) based power domain driver.
28 The i.MX System Controller Firmware (SCFW) owns and uses the i.MX8qm/qxp29 pixel link MSI bus controller and does not allow SCFW user to control it.30 So, the controller's registers cannot be accessed by SCFW user. Hence,31 the interrupts generated by the controller don't make any sense from SCFW
7 title: NXP i.MX System Controller Firmware (SCFW)13 The System Controller Firmware (SCFW) is a low-level system function
39 * It is called by client-side SCFW API function shims.
40 * It is called by client-side SCFW API function shims.
1 NXP i.MX System Controller Firmware (SCFW)4 The System Controller Firmware (SCFW) is a low-level system function
84 which supports SCFW
109 /* IPC handle when setup stop mode by System Controller firmware(scfw) */
147 * scfw disable clock access and keep it always on
506 * This pin is used in the SCFW as a UART. Using it from507 * Linux would require rewritting the SCFW board file.
18 * Software timer tick implemented in scfw side, support 10ms to 0xffffffff ms
272 * This pin is used in the SCFW as a UART. Using it from273 * Linux would require rewritting the SCFW board file.
21 + Say Y here to enable the imx8 gpio over SCFW MISC API
2463 + * this block can only be accessible using the SCFW API.3127 +MODULE_DESCRIPTION("NXP i.MX driver to handle SNVS secvio irq sent by SCFW");
1758 + /* Get muB partition id and enable irq in SCFW then */
122 The System Controller Firmware (SCFW) based power domain driver.
3615 + * A-core resources are special. SCFW reports they are not "owned" by
1018 /* Get partition id and enable irq in SCFW */ in imx_rproc_detect_mode()
5732 + /* voltage is maintained by SCFW, so no need here */
3391 * It is called by client-side SCFW API function shims.