Searched full:achieved (Results 1 – 25 of 490) sorted by relevance
12345678910>>...20
11 * For the DC in LS7A2000, clearing interrupt status is achieved by14 * For the DC in LS7A1000, clear interrupt status is achieved by write "0"
230 or 0 if completion was achieved. There is a _timeout variant as well::247 achieved calls complete() to signal exactly one of the waiters that it can257 a thread starts waiting. This is achieved by the waiter "consuming"
16 modules. This is achieved by adding multi-led nodes layer to the
32 This is the lowest possible system power state, achieved only when CPU is in
37 due to the PWM specificity, where lower brightness is achieved
12 1) TC filter directing traffic to a set of queues is achieved
11 and controls the sensor directly. This is achieved by having a lot of code
7 communication is achieved through a set of registers for message storage and18 is achieved through the appropriate programming of the rx and tx interrupt
23 * L1 I$ fetch block boundary which can be achieved by using
37 * the same can be achieved by means of CMD_START_MEAS which takes
21 API. Cropping a smaller image from a larger one is achieved by setting
12 However, a similar kind of flexibility can be achieved by using VRFs and
21 * GOT references). This is achieved by defining STATIC_RW_DATA to
14 Thermal management is achieved in devicetree by describing the sensor hardware
23 Specifically when selecting a high performance profile the actual achieved
53 better behavior with mplayer can be achieved by setting to a higher