Searched full:aquire (Results 1 – 23 of 23) sorted by relevance
39 If set, the sensor aquire data with low precision (not recommended).40 The driver aquire data with high precision by default.
17 The driver will attempt to aquire interrupts for all GPIOs to detect changes in
80 * call sched_set_itmt_support() from there as this function will aquire
111 * Enable clk and aquire spinlock
112 * Enable clk and aquire spinlock
363 int (*smu_i2c_bus_access)(struct pp_hwmgr *hwmgr, bool aquire);
879 * device_unregister tries to aquire the same lock. in siox_device_remove()
348 * mixed with other commands. Aquire a lock now. */ in blinkm_transfer_hw()
875 * device_unregister tries to aquire the same lock. in siox_device_remove()
2324 /* need to re-aquire the spin lock, though */ in _conn_request_state()2331 /* ... and re-aquire the spinlock. in _conn_request_state()2368 * so give up the spinlock, then re-aquire it */ in _conn_request_state()
1329 * but will re-aquire it before it returns here. in drbd_send_and_submit()
2319 /* need to re-aquire the spin lock, though */ in _conn_request_state()2326 /* ... and re-aquire the spinlock. in _conn_request_state()2363 * so give up the spinlock, then re-aquire it */ in _conn_request_state()
1315 * but will re-aquire it before it returns here. in drbd_send_and_submit()
40 * have to drop the lower ranking lock first and re-aquire it after having
563 /* aquire mutex again */ in radeon_vm_bo_set_addr()
564 /* aquire mutex again */ in radeon_vm_bo_set_addr()
1421 /* Release phy lock to allow ftgmac100_reset to aquire it, keeping lock in ftgmac100_adjust_link()
566 * It will release and re-aquire the lock while calling ACPI
673 * It will release and re-aquire the lock while calling ACPI
227 * The AQUIRE when reading the result code without holding sem_lock() is
1247 /* No need to aquire ce_lock for CE5, since this is the only place CE5 in ath10k_pci_process_htt_rx_cb()