Searched full:drawn (Results 1 – 25 of 95) sorted by relevance
1234
66 Specifies max. load that can be drawn from VCC supply.70 Specifies max. load that can be drawn from VCCQ supply.74 Specifies max. load that can be drawn from VCCQ2 supply.
28 - vdda-phy-max-microamp : specifies max. load that can be drawn from phy supply29 - vdda-pll-max-microamp : specifies max. load that can be drawn from pll supply31 - vddp-ref-clk-max-microamp : specifies max. load that can be drawn from this supply
33 - vcc-max-microamp : specifies max. load that can be drawn from vcc supply34 - vccq-max-microamp : specifies max. load that can be drawn from vccq supply35 - vccq2-max-microamp : specifies max. load that can be drawn from vccq2 supply
29 the bottom of each hardware plane being drawn on the screen.37 plane, and the desktop is drawn in another plane. The video plane should
65 * reaching the end of the drawn picture the drawing starts in tidss_plane_atomic_check()67 * position of the drawn picture is (so there is no need to in tidss_plane_atomic_check()
59 * reaching the end of the drawn picture the drawing starts in tidss_plane_atomic_check()61 * position of the drawn picture is (so there is no need to in tidss_plane_atomic_check()
23 - vbus-regulator : should specifiy the regulator supplying current drawn from
41 description: Should specify the regulator supplying current drawn from
2 /* Make sure our payloads are always drawn below the driver node */
52 * (2^index_size * sizeof(pointer)) and allocations are drawn from
56 * (2^index_size * sizeof(pointer)) and allocations are drawn from
22 - ti,current-limit: The maximum current to be drawn from the charger's input
69 | shmfs memory drawn from the same pool
68 | shmfs memory drawn from the same pool
15 /* This is drawn from a dump from vgacon:startup in in xen_init_vga()
16 /* This is drawn from a dump from vgacon:startup in in xen_init_vga()
14 * advertisements using the following drawn from the 802.3 specs:
65 tgafb to XF86_TGA 3.3.x, the entire screen is not re-drawn and must be manually