| /kernel/linux/linux-5.10/drivers/staging/sm750fb/ |
| D | ddk750_sii164.c | 80 * 0 = Input data is falling edge latched (falling
81 * edge latched first in dual edge mode)
82 * 1 = Input data is rising edge latched (rising
83 * edge latched first in dual edge mode)
88 * 0 = Input data is single edge latched
89 * 1 = Input data is dual edge latched
|
| /kernel/linux/linux-6.6/drivers/staging/sm750fb/ |
| D | ddk750_sii164.c | 80 * 0 = Input data is falling edge latched (falling
81 * edge latched first in dual edge mode)
82 * 1 = Input data is rising edge latched (rising
83 * edge latched first in dual edge mode)
88 * 0 = Input data is single edge latched
89 * 1 = Input data is dual edge latched
|
| /kernel/linux/linux-6.6/sound/soc/codecs/ |
| D | tas2764.c | 66 u8 latched[6] = {0, 0, 0, 0, 0, 0}; in tas2764_irq() local
70 for (i = 0; i < ARRAY_SIZE(latched); i++) in tas2764_irq()
71 latched[i] = snd_soc_component_read(tas2764->component, in tas2764_irq()
75 if (latched[0] & BIT(i)) { in tas2764_irq()
82 if (latched[0]) { in tas2764_irq()
84 latched[1], latched[2], latched[3], latched[4], latched[5]); in tas2764_irq()
|
| D | tas2770.h | 94 /* Latched-Interrupt Reg0 */
98 /* Latched-Interrupt Reg1 */
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/gpio/ |
| D | gpio-latch.yaml | 42 The number of clk-gpios and latched-gpios is not fixed. The actual number
55 latched-gpios:
74 - latched-gpios
90 latched-gpios = <&gpio3 21 0>, <&gpio3 22 0>,
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/sound/ |
| D | tlv320adcx140.yaml | 70 0 - (default) Odd channel is latched on the negative edge and even
71 channel is latched on the positive edge.
72 1 - Odd channel is latched on the positive edge and even channel is
73 latched on the negative edge.
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/sound/ |
| D | tlv320adcx140.yaml | 69 0 - (default) Odd channel is latched on the negative edge and even
70 channel is latched on the the positive edge.
71 1 - Odd channel is latched on the positive edge and even channel is
72 latched on the the negative edge.
|
| /kernel/linux/linux-6.6/drivers/gpu/drm/i915/display/ |
| D | intel_vrr.c | 61 * Without VRR registers get latched at:
64 * With VRR the earliest registers can get latched is:
68 * The latest point registers can get latched is the vmax decision boundary:
72 * latched) ASAP after a push is sent.
|
| /kernel/linux/linux-5.10/arch/x86/kernel/ |
| D | nmi.c | 132 * can be latched at any given time. Walk the whole list in nmi_handle()
384 * Only one NMI can be latched at a time. To handle in default_do_nmi()
388 * while its real NMI is sitting latched. This will cause in default_do_nmi()
435 * 3) latched
447 * first one finishes. We set the state to "latched", and the exit of
452 * rerun the NMI handler again, and restart the 'latched' NMI.
|
| /kernel/linux/linux-5.10/drivers/net/ethernet/broadcom/bnx2x/ |
| D | bnx2x_init.h | 639 /* [28] MCP Latched rom_parity
640 * [29] MCP Latched ump_rx_parity
641 * [30] MCP Latched ump_tx_parity
642 * [31] MCP Latched scpad_parity
761 * [7] clears Latched rom_parity in bnx2x_clear_blocks_parity()
762 * [8] clears Latched ump_rx_parity in bnx2x_clear_blocks_parity()
763 * [9] clears Latched ump_tx_parity in bnx2x_clear_blocks_parity()
764 * [10] clears Latched scpad_parity (both ports) in bnx2x_clear_blocks_parity()
|
| D | bnx2x_reg.h | 1123 interrupt; [21] RBCR Latched attn; [22] RBCT Latched attn; [23] RBCN
1124 Latched attn; [24] RBCU Latched attn; [25] RBCP Latched attn; [26] GRC
1125 Latched timeout attention; [27] GRC Latched reserved access attention;
1126 [28] MCP Latched rom_parity; [29] MCP Latched ump_rx_parity; [30] MCP
1127 Latched ump_tx_parity; [31] MCP Latched scpad_parity; */
1137 RBCR Latched attn; [22] RBCT Latched attn; [23] RBCN Latched attn; [24]
1138 RBCU Latched attn; [25] RBCP Latched attn; [26] GRC Latched timeout
1139 attention; [27] GRC Latched reserved access attention; [28] MCP Latched
1140 rom_parity; [29] MCP Latched ump_rx_parity; [30] MCP Latched
1141 ump_tx_parity; [31] MCP Latched scpad_parity; */
[all …]
|
| /kernel/linux/linux-6.6/drivers/net/ethernet/broadcom/bnx2x/ |
| D | bnx2x_init.h | 639 /* [28] MCP Latched rom_parity
640 * [29] MCP Latched ump_rx_parity
641 * [30] MCP Latched ump_tx_parity
642 * [31] MCP Latched scpad_parity
761 * [7] clears Latched rom_parity in bnx2x_clear_blocks_parity()
762 * [8] clears Latched ump_rx_parity in bnx2x_clear_blocks_parity()
763 * [9] clears Latched ump_tx_parity in bnx2x_clear_blocks_parity()
764 * [10] clears Latched scpad_parity (both ports) in bnx2x_clear_blocks_parity()
|
| D | bnx2x_reg.h | 1123 interrupt; [21] RBCR Latched attn; [22] RBCT Latched attn; [23] RBCN
1124 Latched attn; [24] RBCU Latched attn; [25] RBCP Latched attn; [26] GRC
1125 Latched timeout attention; [27] GRC Latched reserved access attention;
1126 [28] MCP Latched rom_parity; [29] MCP Latched ump_rx_parity; [30] MCP
1127 Latched ump_tx_parity; [31] MCP Latched scpad_parity; */
1137 RBCR Latched attn; [22] RBCT Latched attn; [23] RBCN Latched attn; [24]
1138 RBCU Latched attn; [25] RBCP Latched attn; [26] GRC Latched timeout
1139 attention; [27] GRC Latched reserved access attention; [28] MCP Latched
1140 rom_parity; [29] MCP Latched ump_rx_parity; [30] MCP Latched
1141 ump_tx_parity; [31] MCP Latched scpad_parity; */
[all …]
|
| /kernel/linux/linux-6.6/drivers/net/ethernet/mellanox/mlxbf_gige/ |
| D | mlxbf_gige_intr.c | 27 /* This error condition is latched into MLXBF_GIGE_INT_STATUS in mlxbf_gige_error_intr()
40 * sent. The "tx_small_frame" condition is latched into the in mlxbf_gige_error_intr()
|
| /kernel/linux/linux-5.10/drivers/net/ethernet/intel/i40e/ |
| D | i40e_ptp.c | 240 /* Update the jiffies time for any newly latched timestamp. This in i40e_ptp_get_rx_events()
242 * was latched by the hardware. The service task will later determine in i40e_ptp_get_rx_events()
245 * events latched since the last time we checked, and not all events in i40e_ptp_get_rx_events()
246 * currently latched, so that the service task accounting remains in i40e_ptp_get_rx_events()
287 /* Check all the currently latched Rx events and see whether they have in i40e_ptp_rx_hang()
288 * been latched for over a second. It is assumed that any timestamp in i40e_ptp_rx_hang()
291 * clear any timestamp that has been latched for over 1 second. in i40e_ptp_rx_hang()
433 /* Clear the latched event since we're about to read its register */ in i40e_ptp_rx_hwtstamp()
|
| /kernel/linux/linux-6.6/arch/x86/kernel/ |
| D | nmi.c | 159 * can be latched at any given time. Walk the whole list in nmi_handle()
442 * Only one NMI can be latched at a time. To handle in default_do_nmi()
446 * while its real NMI is sitting latched. This will cause in default_do_nmi()
493 * 3) latched
505 * first one finishes. We set the state to "latched", and the exit of
510 * rerun the NMI handler again, and restart the 'latched' NMI.
|
| /kernel/linux/linux-5.10/sound/soc/codecs/ |
| D | tas2770.h | 94 /* Latched-Interrupt Reg0 */
98 /* Latched-Interrupt Reg1 */
|
| /kernel/linux/linux-5.10/drivers/staging/comedi/drivers/ |
| D | amplc_dio200_pci.c | 133 * 9. "Pattern occurred" latched signal, latches HIGH when pattern
135 * 10. "Pattern gone away" latched signal, latches LOW when pattern
139 * 12. Negated "pattern occurred" latched signal, latches LOW when
141 * 13. Negated "pattern gone away" latched signal, latches LOW when
|
| /kernel/linux/linux-6.6/drivers/comedi/drivers/ |
| D | amplc_dio200_pci.c | 133 * 9. "Pattern occurred" latched signal, latches HIGH when pattern
135 * 10. "Pattern gone away" latched signal, latches LOW when pattern
139 * 12. Negated "pattern occurred" latched signal, latches LOW when
141 * 13. Negated "pattern gone away" latched signal, latches LOW when
|
| /kernel/linux/linux-5.10/include/linux/mtd/ |
| D | latch-addr-flash.h | 2 * Interface for NOR flash driver whose high address lines are latched
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/input/touchscreen/ |
| D | eeti.txt | 10 latched. This is necessary for platforms that lack
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/input/touchscreen/ |
| D | eeti.txt | 10 latched. This is necessary for platforms that lack
|
| /kernel/linux/linux-6.6/drivers/net/phy/ |
| D | marvell-88q2xxx.c | 60 /* The link state is latched low so that momentary link in mv88q2xxx_read_link_gbit()
91 /* The link state is latched low so that momentary link in mv88q2xxx_read_link_100m()
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/interrupt-controller/ |
| D | brcm,l2-intc.txt | 8 "brcm,l2-intc" for latched interrupt controllers
|
| /kernel/linux/linux-6.6/drivers/pwm/ |
| D | pwm-imx-tpm.c | 9 * - Changes to polarity cannot be latched at the time of the
213 * is latched into hardware when the next period starts. in pwm_imx_tpm_apply_hw()
233 * is latched into hardware when the next period starts. in pwm_imx_tpm_apply_hw()
|