| /kernel/linux/linux-5.10/arch/arm/mach-s3c/ |
| D | mach-ncp.c | 46 /* REVISIT: NCP uses only serial 1, 2 */
92 MACHINE_START(NCP, "NCP")
|
| D | Kconfig.s3c64xx | 252 bool "NCP"
259 Machine support for the Samsung NCP
|
| D | Makefile.s3c64xx | 52 obj-$(CONFIG_MACH_NCP) += mach-ncp.o
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/regulator/ |
| D | qcom,rpm-regulator.yaml | 21 lvs0, lvs1, ncp
29 ncp
52 "^((s|l|lvs)[0-9]*|s[1-2][a-b]|ncp|mvs|usb-switch|hdmi-switch)$":
|
| /kernel/linux/linux-6.6/drivers/crypto/cavium/zip/ |
| D | zip_device.c | 84 union zip_nptr_s ncp; in zip_load_instr() local
133 ncp.u_reg64 = 0ull; in zip_load_instr()
134 ncp.s.addr = __pa(zip_dev->iq[queue].sw_head); in zip_load_instr()
135 *ncb_ptr = ncp.u_reg64; in zip_load_instr()
|
| /kernel/linux/linux-5.10/drivers/crypto/cavium/zip/ |
| D | zip_device.c | 84 union zip_nptr_s ncp; in zip_load_instr() local
133 ncp.u_reg64 = 0ull; in zip_load_instr()
134 ncp.s.addr = __pa(zip_dev->iq[queue].sw_head); in zip_load_instr()
135 *ncb_ptr = ncp.u_reg64; in zip_load_instr()
|
| /kernel/linux/linux-5.10/drivers/crypto/stm32/ |
| D | stm32-hash.c | 546 int err = 0, len = 0, reg, ncp = 0; in stm32_hash_dma_send() local
574 ncp = sg_pcopy_to_buffer( in stm32_hash_dma_send()
613 if (ncp) { in stm32_hash_dma_send()
614 memset(buffer + ncp, 0, in stm32_hash_dma_send()
615 DIV_ROUND_UP(ncp, sizeof(u32)) - ncp); in stm32_hash_dma_send()
617 DIV_ROUND_UP(ncp, sizeof(u32))); in stm32_hash_dma_send()
619 stm32_hash_set_nblw(hdev, ncp); in stm32_hash_dma_send()
|
| /kernel/linux/linux-6.6/sound/soc/codecs/ |
| D | mt6358.c | 974 /* Set NCP clock as 604kHz // 26MHz/43 = 604KHz */ in mtk_hp_enable()
978 /* Set NCP soft start mode as default mode: 100us */ in mtk_hp_enable()
980 /* Enable NCP */ in mtk_hp_enable()
1150 /* Disable NCP */ in mtk_hp_disable()
1183 /* Set NCP clock as 604kHz // 26MHz/43 = 604KHz */ in mtk_hp_spk_enable()
1187 /* Set NCP soft start mode as default mode: 100us */ in mtk_hp_spk_enable()
1189 /* Enable NCP */ in mtk_hp_spk_enable()
1341 /* Disable NCP */ in mtk_hp_spk_disable()
1430 /* Set NCP clock as 604kHz // 26MHz/43 = 604KHz */ in mt_rcv_event()
1434 /* Set NCP soft start mode as default mode: 100us */ in mt_rcv_event()
[all …]
|
| D | pcm512x.c | 526 * NCP target rate... in pcm512x_ncp_target()
531 * ...but if the DAC is in fact overclocked, bump the NCP target in pcm512x_ncp_target()
1078 /* run NCP no faster than 2048000 Hz, but why? */ in pcm512x_set_dividers()
1081 dev_err(dev, "Failed to find NCP divider\n"); in pcm512x_set_dividers()
1102 dev_err(dev, "Failed to write NCP divider: %d\n", ret); in pcm512x_set_dividers()
1155 dev_dbg(component->dev, "NCP divider %d\n", ncp_div); in pcm512x_set_dividers()
|
| /kernel/linux/linux-5.10/sound/soc/codecs/ |
| D | mt6358.c | 975 /* Set NCP clock as 604kHz // 26MHz/43 = 604KHz */ in mtk_hp_enable()
979 /* Set NCP soft start mode as default mode: 100us */ in mtk_hp_enable()
981 /* Enable NCP */ in mtk_hp_enable()
1151 /* Disable NCP */ in mtk_hp_disable()
1184 /* Set NCP clock as 604kHz // 26MHz/43 = 604KHz */ in mtk_hp_spk_enable()
1188 /* Set NCP soft start mode as default mode: 100us */ in mtk_hp_spk_enable()
1190 /* Enable NCP */ in mtk_hp_spk_enable()
1342 /* Disable NCP */ in mtk_hp_spk_disable()
1431 /* Set NCP clock as 604kHz // 26MHz/43 = 604KHz */ in mt_rcv_event()
1435 /* Set NCP soft start mode as default mode: 100us */ in mt_rcv_event()
[all …]
|
| D | pcm512x.c | 524 * NCP target rate... in pcm512x_ncp_target()
529 * ...but if the DAC is in fact overclocked, bump the NCP target in pcm512x_ncp_target()
1076 /* run NCP no faster than 2048000 Hz, but why? */ in pcm512x_set_dividers()
1079 dev_err(dev, "Failed to find NCP divider\n"); in pcm512x_set_dividers()
1100 dev_err(dev, "Failed to write NCP divider: %d\n", ret); in pcm512x_set_dividers()
1153 dev_dbg(component->dev, "NCP divider %d\n", ncp_div); in pcm512x_set_dividers()
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/mfd/ |
| D | qcom-rpm.txt | 159 lvs0, lvs1, ncp
169 ncp
|
| /kernel/linux/linux-5.10/arch/xtensa/variants/fsf/include/variant/ |
| D | tie.h | 45 /* Total save area for optional and custom state (NCP + CPn): */
|
| D | tie-asm.h | 28 #define XTHAL_SAS_ALL 0xFFFF /* include all default NCP contents */
|
| /kernel/linux/linux-6.6/arch/xtensa/variants/fsf/include/variant/ |
| D | tie.h | 45 /* Total save area for optional and custom state (NCP + CPn): */
|
| D | tie-asm.h | 28 #define XTHAL_SAS_ALL 0xFFFF /* include all default NCP contents */
|
| /kernel/linux/linux-6.6/drivers/regulator/ |
| D | qcom_rpm-regulator.c | 36 struct request_member enable_state; /* NCP and switch */
37 struct request_member comp_mode; /* NCP */
38 struct request_member freq; /* frequency: NCP and SMPS */
841 { "ncp", QCOM_RPM_PM8058_NCP, &pm8058_ncp, "vdd_ncp" },
914 { "ncp", QCOM_RPM_PM8921_NCP, &pm8921_ncp, "vdd_ncp" },
|
| /kernel/linux/linux-5.10/drivers/regulator/ |
| D | qcom_rpm-regulator.c | 36 struct request_member enable_state; /* NCP and switch */
37 struct request_member comp_mode; /* NCP */
38 struct request_member freq; /* frequency: NCP and SMPS */
841 { "ncp", QCOM_RPM_PM8058_NCP, &pm8058_ncp, "vdd_ncp" },
914 { "ncp", QCOM_RPM_PM8921_NCP, &pm8921_ncp, "vdd_ncp" },
|
| /kernel/linux/linux-5.10/arch/mips/include/asm/octeon/ |
| D | cvmx-pci-defs.h | 596 uint32_t ncp:8; member
600 uint32_t ncp:8;
657 uint32_t ncp:8; member
661 uint32_t ncp:8;
712 uint32_t ncp:8; member
716 uint32_t ncp:8;
|
| /kernel/linux/linux-6.6/arch/mips/include/asm/octeon/ |
| D | cvmx-pci-defs.h | 596 uint32_t ncp:8; member
600 uint32_t ncp:8;
657 uint32_t ncp:8; member
661 uint32_t ncp:8;
712 uint32_t ncp:8; member
716 uint32_t ncp:8;
|
| /kernel/linux/linux-6.6/drivers/crypto/stm32/ |
| D | stm32-hash.c | 656 int err = 0, reg, ncp = 0; in stm32_hash_dma_send() local
685 ncp = sg_pcopy_to_buffer( in stm32_hash_dma_send()
726 if (ncp) { in stm32_hash_dma_send()
727 memset(buffer + ncp, 0, in stm32_hash_dma_send()
728 DIV_ROUND_UP(ncp, sizeof(u32)) - ncp); in stm32_hash_dma_send()
730 DIV_ROUND_UP(ncp, sizeof(u32))); in stm32_hash_dma_send()
732 stm32_hash_set_nblw(hdev, ncp); in stm32_hash_dma_send()
|
| /kernel/linux/linux-5.10/arch/arm/tools/ |
| D | mach-types | 359 ncp MACH_NCP NCP 1933
|
| /kernel/linux/linux-6.6/arch/arm/tools/ |
| D | mach-types | 359 ncp MACH_NCP NCP 1933
|
| /kernel/linux/linux-5.10/include/net/ |
| D | ipx.h | 106 * To handle special ncp connection-handling sockets for mars_nwe,
|
| /kernel/linux/linux-5.10/drivers/crypto/ |
| D | n2_core.c | 2055 pr_info("Found NCP at %pOF\n", dev->dev.of_node); in n2_mau_probe()
2059 dev_err(&dev->dev, "%pOF: Unable to allocate ncp.\n", in n2_mau_probe()
2080 err = grab_mdesc_irq_props(mdesc, dev, &mp->mau_info, "ncp"); in n2_mau_probe()
2154 .name = "ncp",
2158 .name = "ncp",
2162 .name = "ncp",
2172 .name = "ncp",
|