Home
last modified time | relevance | path

Searched +full:spi +full:- +full:cs +full:- +full:hold +full:- +full:delay +full:- +full:ns (Results 1 – 16 of 16) sorted by relevance

/kernel/linux/linux-6.6/Documentation/devicetree/bindings/spi/
Dspi-peripheral-props.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/spi/spi-peripheral-props.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Peripheral-specific properties for a SPI bus.
10 Many SPI controllers need to add properties to peripheral devices. They could
11 be common properties like spi-max-frequency, spi-cpha, etc. or they could be
12 controller specific like delay in clock or data lines, etc. These properties
13 need to be defined in the peripheral node because they are per-peripheral and
19 - Mark Brown <broonie@kernel.org>
[all …]
/kernel/linux/linux-6.6/arch/arm/boot/dts/st/
Dstm32mp15xx-dhcor-drc-compact.dtsi1 // SPDX-License-Identifier: (GPL-2.0 OR BSD-3-Clause)
21 stdout-path = "serial0:115200n8";
25 compatible = "gpio-leds";
29 default-state = "off";
35 default-state = "off";
40 compatible = "regulator-fixed";
41 regulator-name = "vio";
42 regulator-min-microvolt = <3300000>;
43 regulator-max-microvolt = <3300000>;
45 regulator-always-on;
[all …]
/kernel/linux/linux-5.10/drivers/spi/
Dspi.c1 // SPDX-License-Identifier: GPL-2.0-or-later
2 // SPI init/core code
11 #include <linux/dma-mapping.h>
16 #include <linux/clk/clk-conf.h>
19 #include <linux/spi/spi.h>
20 #include <linux/spi/spi-mem.h>
29 #include <linux/delay.h>
38 #include <trace/events/spi.h>
48 struct spi_device *spi = to_spi_device(dev); in spidev_release() local
50 spi_controller_put(spi->controller); in spidev_release()
[all …]
/kernel/linux/linux-6.6/arch/arm/boot/dts/ti/omap/
Domap3-pandora-common.dtsi1 // SPDX-License-Identifier: GPL-2.0-only
9 #include <dt-bindings/input/input.h>
14 cpu0-supply = <&vcc>;
29 #clock-cells = <0>;
30 compatible = "fixed-clock";
31 clock-frequency = <26000000>;
35 compatible = "connector-analog-tv";
40 remote-endpoint = <&venc_out>;
45 gpio-leds {
47 compatible = "gpio-leds";
[all …]
/kernel/linux/linux-5.10/arch/arm/boot/dts/
Domap3-pandora-common.dtsi1 // SPDX-License-Identifier: GPL-2.0-only
9 #include <dt-bindings/input/input.h>
14 cpu0-supply = <&vcc>;
29 #clock-cells = <0>;
30 compatible = "fixed-clock";
31 clock-frequency = <26000000>;
35 compatible = "connector-analog-tv";
40 remote-endpoint = <&venc_out>;
45 gpio-leds {
47 compatible = "gpio-leds";
[all …]
/kernel/linux/linux-6.6/drivers/spi/
Dspi.c1 // SPDX-License-Identifier: GPL-2.0-or-later
2 // SPI init/core code
9 #include <linux/clk/clk-conf.h>
10 #include <linux/delay.h>
13 #include <linux/dma-mapping.h>
34 #include <linux/spi/spi.h>
35 #include <linux/spi/spi-mem.h>
39 #include <trace/events/spi.h>
49 struct spi_device *spi = to_spi_device(dev); in spidev_release() local
51 spi_controller_put(spi->controller); in spidev_release()
[all …]
/kernel/linux/linux-6.6/arch/arm64/boot/dts/hisilicon/
Dhi6220.dtsi1 // SPDX-License-Identifier: GPL-2.0
8 #include <dt-bindings/interrupt-controller/arm-gic.h>
9 #include <dt-bindings/reset/hisi,hi6220-resets.h>
10 #include <dt-bindings/clock/hi6220-clock.h>
11 #include <dt-bindings/pinctrl/hisi.h>
12 #include <dt-bindings/thermal/thermal.h>
16 interrupt-parent = <&gic>;
17 #address-cells = <2>;
18 #size-cells = <2>;
21 compatible = "arm,psci-0.2";
[all …]
/kernel/linux/linux-5.10/arch/arm64/boot/dts/hisilicon/
Dhi6220.dtsi1 // SPDX-License-Identifier: GPL-2.0
8 #include <dt-bindings/interrupt-controller/arm-gic.h>
9 #include <dt-bindings/reset/hisi,hi6220-resets.h>
10 #include <dt-bindings/clock/hi6220-clock.h>
11 #include <dt-bindings/pinctrl/hisi.h>
12 #include <dt-bindings/thermal/thermal.h>
16 interrupt-parent = <&gic>;
17 #address-cells = <2>;
18 #size-cells = <2>;
21 compatible = "arm,psci-0.2";
[all …]
/kernel/linux/linux-6.6/arch/arm/common/
Dlocomo.c1 // SPDX-License-Identifier: GPL-2.0-only
18 #include <linux/delay.h>
46 /* DAC setup and hold times (expressed in us) */
53 #define DAC_DATA_SETUP_TIME 1 /* 250 ns */
54 #define DAC_DATA_HOLD_TIME 1 /* 300 ns */
55 #define DAC_LOW_SETUP_TIME 1 /* 300 ns */
56 #define DAC_HIGH_SETUP_TIME 1 /* 1000 ns */
79 /* All the locomo devices. If offset is non-zero, the mapbase for the
88 .name = "locomo-keyboard",
95 .name = "locomo-frontlight",
[all …]
/kernel/linux/linux-5.10/arch/arm/common/
Dlocomo.c1 // SPDX-License-Identifier: GPL-2.0-only
18 #include <linux/delay.h>
47 /* DAC setup and hold times (expressed in us) */
54 #define DAC_DATA_SETUP_TIME 1 /* 250 ns */
55 #define DAC_DATA_HOLD_TIME 1 /* 300 ns */
56 #define DAC_LOW_SETUP_TIME 1 /* 300 ns */
57 #define DAC_HIGH_SETUP_TIME 1 /* 1000 ns */
80 /* All the locomo devices. If offset is non-zero, the mapbase for the
89 .name = "locomo-keyboard",
96 .name = "locomo-frontlight",
[all …]
/kernel/linux/patches/linux-5.10/imx8mm_patch/patches/drivers/
D0030_linux_drivers_pci_misc_nvmem_of_mtd_mmc.patch7 Change-Id: Iec160bd007994d82f416debdccfbc0d9bdb40470
9 diff --git a/drivers/misc/Kconfig b/drivers/misc/Kconfig
11 --- a/drivers/misc/Kconfig
13 @@ -314,6 +314,26 @@ config ISL29020
40 diff --git a/drivers/misc/Makefile b/drivers/misc/Makefile
42 --- a/drivers/misc/Makefile
44 @@ -19,6 +19,8 @@ obj-$(CONFIG_TIFM_7XX1) += tifm_7xx1.o
45 obj-$(CONFIG_PHANTOM) += phantom.o
46 obj-$(CONFIG_QCOM_COINCELL) += qcom-coincell.o
47 obj-$(CONFIG_QCOM_FASTRPC) += fastrpc.o
[all …]
/kernel/linux/linux-6.6/drivers/scsi/aic7xxx/
Daic7xxx_core.c4 * Copyright (c) 1994-2002 Justin T. Gibbs.
5 * Copyright (c) 2000-2002 Adaptec Inc.
19 * 3. Neither the names of the above-listed copyright holders nor the names
78 { DPARERR, "Data-path Parity Error" },
87 { P_DATAOUT, NOP, "in Data-out phase" },
88 { P_DATAIN, INITIATOR_ERROR, "in Data-in phase" },
89 { P_DATAOUT_DT, NOP, "in DT Data-out phase" },
90 { P_DATAIN_DT, INITIATOR_ERROR, "in DT Data-in phase" },
92 { P_MESGOUT, NOP, "in Message-out phase" },
94 { P_MESGIN, MSG_PARITY_ERROR, "in Message-in phase" },
[all …]
/kernel/linux/linux-5.10/drivers/scsi/aic7xxx/
Daic7xxx_core.c4 * Copyright (c) 1994-2002 Justin T. Gibbs.
5 * Copyright (c) 2000-2002 Adaptec Inc.
19 * 3. Neither the names of the above-listed copyright holders nor the names
78 { DPARERR, "Data-path Parity Error" },
87 { P_DATAOUT, MSG_NOOP, "in Data-out phase" },
88 { P_DATAIN, MSG_INITIATOR_DET_ERR, "in Data-in phase" },
89 { P_DATAOUT_DT, MSG_NOOP, "in DT Data-out phase" },
90 { P_DATAIN_DT, MSG_INITIATOR_DET_ERR, "in DT Data-in phase" },
92 { P_MESGOUT, MSG_NOOP, "in Message-out phase" },
94 { P_MESGIN, MSG_PARITY_ERROR, "in Message-in phase" },
[all …]
/kernel/linux/patches/linux-5.10/yangfan_patch/
Ddrivers.patch1 diff --git a/drivers/Makefile b/drivers/Makefile
3 --- a/drivers/Makefile
5 @@ -6,6 +6,8 @@
6 # Rewritten to use lists instead of if-statements.
11 obj-y += irqchip/
12 obj-y += bus/
14 diff --git a/drivers/block/nbd.c b/drivers/block/nbd.c
16 --- a/drivers/block/nbd.c
18 @@ -2398,12 +2398,6 @@ static int nbd_genl_status(struct sk_buff *skb, struct genl_info *info)
22 - if (!dev_list) {
[all …]
/kernel/linux/patches/linux-5.10/unionpi_tiger_pacth/
Dlinux-5.10.patch1 diff -Naur a/arch/arm/boot/Makefile b/arch/arm/boot/Makefile
2 --- a/arch/arm/boot/Makefile 2022-05-27 17:20:13.781877650 +0800
3 +++ b/arch/arm/boot/Makefile 2022-05-31 11:56:47.693259679 +0800
4 @@ -16,6 +16,7 @@
12 @@ -24,10 +25,12 @@
13 ZRELADDR := $(zreladdr-y)
14 PARAMS_PHYS := $(params_phys-y)
15 INITRD_PHYS := $(initrd_phys-y)
16 +DTB_OBJS ?= $(dtb-y)
21 -targets := Image zImage xipImage bootpImage uImage
[all …]
/kernel/linux/patches/linux-5.10/imx8mm_patch/patches/
D0005_linux_include.patch7 Change-Id: Icf23f02df7b566848af808b9eeaed889d1773e71
9 diff --git a/include/drm/bridge/cdns-mhdp.h b/include/drm/bridge/cdns-mhdp.h
12 --- /dev/null
13 +++ b/include/drm/bridge/cdns-mhdp.h
14 @@ -0,0 +1,921 @@
15 +/* SPDX-License-Identifier: GPL-2.0 */
18 + * Author: Chris Zhong <zyw@rock-chips.com>
39 +#include <sound/hdmi-codec.h>
489 +#define F_HDMI_ENCODING(x) (((x) & ((1 << 2) - 1)) << 16)
490 +#define F_VIF_DATA_WIDTH(x) (((x) & ((1 << 2) - 1)) << 2)
[all …]