Searched full:tamper (Results 1 – 25 of 78) sorted by relevance
1234
| /kernel/linux/linux-6.6/drivers/rtc/ |
| D | rtc-imxdi.c | 44 #define DCR_TDCHL (1 << 30) /* Tamper-detect configuration hard lock */
45 #define DCR_TDCSL (1 << 29) /* Tamper-detect configuration soft lock */
56 #define DSR_WTD (1 << 23) /* Wire-mesh tamper detected */
57 #define DSR_ETBD (1 << 22) /* External tamper B detected */
58 #define DSR_ETAD (1 << 21) /* External tamper A detected */
61 #define DSR_TTD (1 << 18) /* Temperature tamper detected */
62 #define DSR_CTD (1 << 17) /* Clock tamper detected */
63 #define DSR_VTD (1 << 16) /* Voltage tamper detected */
83 #define DTCR 0x28 /* DryIce Tamper Configuration Reg */
86 #define DTCR_WTE (1 << 7) /* wire-mesh tamper enabled */
[all …]
|
| D | rtc-pcf2127.c | 8 * Watchdog and tamper functions
67 /* Tamper timestamp1 registers */
126 /* Tamper timestamp1 registers */
128 /* Tamper timestamp2 registers */
130 /* Tamper timestamp3 registers */
132 /* Tamper timestamp4 registers */
1040 dev_err(dev, "%s: invalid tamper detection ID (%d)\n", in pcf2127_enable_ts()
1052 dev_err(dev, "%s: tamper detection config (ts%d_ctrl) failed\n", in pcf2127_enable_ts()
1066 dev_err(dev, "%s: tamper detection TSIE%d config failed\n", in pcf2127_enable_ts()
1232 * correct tamper timestamp and interrupt function. in pcf2127_probe()
[all …]
|
| /kernel/linux/linux-5.10/drivers/rtc/ |
| D | rtc-imxdi.c | 43 #define DCR_TDCHL (1 << 30) /* Tamper-detect configuration hard lock */
44 #define DCR_TDCSL (1 << 29) /* Tamper-detect configuration soft lock */
55 #define DSR_WTD (1 << 23) /* Wire-mesh tamper detected */
56 #define DSR_ETBD (1 << 22) /* External tamper B detected */
57 #define DSR_ETAD (1 << 21) /* External tamper A detected */
60 #define DSR_TTD (1 << 18) /* Temperature tamper detected */
61 #define DSR_CTD (1 << 17) /* Clock tamper detected */
62 #define DSR_VTD (1 << 16) /* Voltage tamper detected */
82 #define DTCR 0x28 /* DryIce Tamper Configuration Reg */
85 #define DTCR_WTE (1 << 7) /* wire-mesh tamper enabled */
[all …]
|
| D | rtc-pcf2127.c | 8 * Watchdog and tamper functions
67 /* Tamper timestamp registers */
640 * correct tamper timestamp and interrupt function. in pcf2127_probe()
661 dev_err(dev, "%s: tamper detection config (ts_ctrl) failed\n", in pcf2127_probe()
675 dev_err(dev, "%s: tamper detection config (ctrl2) failed\n", in pcf2127_probe()
682 dev_err(dev, "%s: tamper sysfs registering failed\n", in pcf2127_probe()
|
| /kernel/linux/linux-5.10/drivers/gpio/ |
| D | gpio-sama5d2-piobu.c | 24 * backup mode protection register for tamper detection
25 * normal mode protection register for tamper detection
55 * Do not consider pin for tamper detection (normal and backup modes)
56 * Do not consider pin as tamper wakeup interrupt source
|
| /kernel/linux/linux-6.6/drivers/gpio/ |
| D | gpio-sama5d2-piobu.c | 24 * backup mode protection register for tamper detection
25 * normal mode protection register for tamper detection
55 * Do not consider pin for tamper detection (normal and backup modes)
56 * Do not consider pin as tamper wakeup interrupt source
|
| /kernel/linux/linux-6.6/arch/arm/boot/dts/nxp/imx/ |
| D | imx7d-flex-concentrator.dts | 187 * Tamper IRQ trigger timestamp reading.
192 "", "", "", "", "rtc-tamper-irq", "", "", "",
207 /* RTC - Tamper IRQ */
|
| D | imx6qdl-gw5907.dtsi | 54 tamper {
55 label = "tamper";
|
| D | imx6qdl-gw5913.dtsi | 54 tamper {
55 label = "tamper";
|
| D | imx6qdl-gw5912.dtsi | 55 tamper {
56 label = "tamper";
|
| D | imx6qdl-gw552x.dtsi | 55 tamper {
56 label = "tamper";
|
| D | imx6qdl-gw5910.dtsi | 57 tamper {
58 label = "tamper";
|
| /kernel/linux/patches/linux-5.10/imx8mm_patch/patches/drivers/ |
| D | 0033_linux_drivers_soc_scsi_spi_tee_thermal.patch | 2569 + dev_err(dev, "Cannot read tamper 1 status: %d\n", ret);
2577 + dev_err(dev, "Cannot read tamper 2 status: %d\n", ret);
2665 + dev_err(dev, "Cannot clear tamper 1 status: %d\n", ret);
2672 + dev_err(dev, "Cannot clear tamper 2 status: %d\n", ret);
2720 + dev_info(dev, "SNVS tamper: External SV\n");
2722 + dev_info(dev, "SNVS tamper: Tamper 2\n");
2724 + dev_info(dev, "SNVS tamper: Tamper 1\n");
2726 + dev_info(dev, "SNVS tamper: Wire Mesh 2\n");
2728 + dev_info(dev, "SNVS tamper: Wire Mesh 1\n");
2730 + dev_info(dev, "SNVS tamper: Voltage\n");
[all …]
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/rtc/ |
| D | isil,isl1208.txt | 3 ISL12X9 have additional pins EVIN and #EVDET for tamper detection, while the
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/i915/ |
| D | i915_sw_fence_work.h | 55 * is published, and that no other threads try to tamper with the number
|
| /kernel/linux/linux-6.6/drivers/gpu/drm/i915/ |
| D | i915_sw_fence_work.h | 55 * is published, and that no other threads try to tamper with the number
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/rtc/ |
| D | isil,isl1208.yaml | 14 ISL12X9 have additional pins EVIN and EVDET for tamper detection, while the
|
| /kernel/linux/linux-5.10/arch/arm/boot/dts/ |
| D | imx6qdl-gw5913.dtsi | 56 tamper {
57 label = "tamper";
|
| D | imx6qdl-gw5907.dtsi | 56 tamper {
57 label = "tamper";
|
| D | imx6qdl-gw5912.dtsi | 57 tamper {
58 label = "tamper";
|
| D | imx6qdl-gw552x.dtsi | 57 tamper {
58 label = "tamper";
|
| /kernel/linux/linux-5.10/arch/arm/mach-omap2/ |
| D | powerdomains43xx_data.c | 73 .voltdm = { .name = "tamper" },
|
| /kernel/linux/linux-6.6/arch/arm/mach-omap2/ |
| D | powerdomains43xx_data.c | 73 .voltdm = { .name = "tamper" },
|
| /kernel/linux/linux-6.6/arch/arm64/boot/dts/freescale/ |
| D | imx8mm-venice-gw700x.dtsi | 46 key-tamper {
47 label = "tamper";
|
| D | imx8mp-venice-gw702x.dtsi | 50 key-tamper {
51 label = "tamper";
|
1234