| /kernel/linux/linux-6.6/drivers/pci/pcie/ |
| D | err.c | 54 pci_ers_result_t vote; in report_error_detected() local
60 vote = PCI_ERS_RESULT_DISCONNECT; in report_error_detected()
64 vote = PCI_ERS_RESULT_NONE; in report_error_detected()
74 vote = PCI_ERS_RESULT_NO_AER_DRIVER; in report_error_detected()
77 vote = PCI_ERS_RESULT_NONE; in report_error_detected()
81 vote = err_handler->error_detected(dev, state); in report_error_detected()
83 pci_uevent_ers(dev, vote); in report_error_detected()
84 *result = merge_result(*result, vote); in report_error_detected()
114 pci_ers_result_t vote, *result = data; in report_mmio_enabled() local
125 vote = err_handler->mmio_enabled(dev); in report_mmio_enabled()
[all …]
|
| /kernel/linux/linux-5.10/drivers/pci/pcie/ |
| D | err.c | 52 pci_ers_result_t vote; in report_error_detected() local
67 vote = PCI_ERS_RESULT_NO_AER_DRIVER; in report_error_detected()
70 vote = PCI_ERS_RESULT_NONE; in report_error_detected()
74 vote = err_handler->error_detected(dev, state); in report_error_detected()
76 pci_uevent_ers(dev, vote); in report_error_detected()
77 *result = merge_result(*result, vote); in report_error_detected()
94 pci_ers_result_t vote, *result = data; in report_mmio_enabled() local
104 vote = err_handler->mmio_enabled(dev); in report_mmio_enabled()
105 *result = merge_result(*result, vote); in report_mmio_enabled()
113 pci_ers_result_t vote, *result = data; in report_slot_reset() local
[all …]
|
| /kernel/linux/linux-6.6/drivers/gpu/drm/msm/disp/dpu1/ |
| D | dpu_core_perf.c | 334 * 1. new bandwidth vote - "ab or ib vote" is higher in dpu_core_perf_crtc_update()
335 * than current vote for update request. in dpu_core_perf_crtc_update()
336 * 2. new bandwidth vote - "ab or ib vote" is lower in dpu_core_perf_crtc_update()
337 * than current vote at end of commit or stop. in dpu_core_perf_crtc_update()
369 DPU_ERROR("crtc-%d: failed to update bus bw vote\n", in dpu_core_perf_crtc_update()
376 * Update the clock after bandwidth vote to ensure in dpu_core_perf_crtc_update()
418 /* run the driver with max clk and BW vote */ in _dpu_core_perf_mode_write()
|
| D | dpu_core_perf.h | 43 * @fix_core_ib_vote: fixed core ib vote in bps used in mode 2
44 * @fix_core_ab_vote: fixed core ab vote in bps used in mode 2
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/msm/disp/dpu1/ |
| D | dpu_core_perf.c | 358 * 1. new bandwidth vote - "ab or ib vote" is higher in dpu_core_perf_crtc_update()
359 * than current vote for update request. in dpu_core_perf_crtc_update()
360 * 2. new bandwidth vote - "ab or ib vote" is lower in dpu_core_perf_crtc_update()
361 * than current vote at end of commit or stop. in dpu_core_perf_crtc_update()
396 DPU_ERROR("crtc-%d: failed to update bus bw vote\n", in dpu_core_perf_crtc_update()
403 * Update the clock after bandwidth vote to ensure in dpu_core_perf_crtc_update()
444 /* run the driver with max clk and BW vote */ in _dpu_core_perf_mode_write()
|
| D | dpu_core_perf.h | 33 * @min_bus_vote: minimum bus vote
52 * @fix_core_ib_vote: fixed core ib vote in bps used in mode 2
53 * @fix_core_ab_vote: fixed core ab vote in bps used in mode 2
|
| /kernel/linux/linux-6.6/drivers/soc/tegra/ |
| D | common.c | 66 * disabled. This makes sure the OPP vote below gets cached in in tegra_core_dev_init_opp_state()
67 * GENPD for the device. Instead, the vote is done the next time in tegra_core_dev_init_opp_state()
81 /* first dummy rate-setting initializes voltage vote */ in tegra_core_dev_init_opp_state()
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/clock/ |
| D | qcom,lcc.yaml | 56 - description: PLL 4 Vote clock
90 - description: PLL 4 Vote clock
|
| /kernel/linux/linux-5.10/drivers/gpu/drm/msm/adreno/ |
| D | a6xx_hfi.h | 94 u32 vote; member
99 u32 vote; member
|
| D | a6xx_gmu.c | 150 * Send an invalid index as a vote for the bus bandwidth and let the in a6xx_gmu_set_freq()
151 * firmware decide on the right vote in a6xx_gmu_set_freq()
394 u32 vote; in a6xx_gmu_gfx_rail_on() local
400 vote = gmu->gx_arc_votes[gmu->nr_gpu_freqs - 1]; in a6xx_gmu_gfx_rail_on()
402 gmu_write(gmu, REG_A6XX_GMU_GX_VOTE_IDX, vote & 0xff); in a6xx_gmu_gfx_rail_on()
403 gmu_write(gmu, REG_A6XX_GMU_MX_VOTE_IDX, (vote >> 8) & 0xff); in a6xx_gmu_gfx_rail_on()
1095 /* Remove the bus vote */ in a6xx_gmu_stop()
1231 /* Construct a vote for each frequency */ in a6xx_gmu_rpmh_arc_votes_init()
1257 * nothing fits, use the maximum non zero vote in a6xx_gmu_rpmh_arc_votes_init()
1269 /* Construct the vote */ in a6xx_gmu_rpmh_arc_votes_init()
|
| D | a6xx_hfi.c | 220 msg.gx_votes[i].vote = gmu->gx_arc_votes[i]; in a6xx_hfi_send_perf_table_v1()
225 msg.cx_votes[i].vote = gmu->cx_arc_votes[i]; in a6xx_hfi_send_perf_table_v1()
242 msg.gx_votes[i].vote = gmu->gx_arc_votes[i]; in a6xx_hfi_send_perf_table()
248 msg.cx_votes[i].vote = gmu->cx_arc_votes[i]; in a6xx_hfi_send_perf_table()
|
| /kernel/linux/linux-6.6/drivers/clk/qcom/ |
| D | gdsc.h | 21 * @collapse_ctrl: APCS collapse-vote register
22 * @collapse_mask: APCS collapse-vote mask
|
| /kernel/linux/linux-6.6/drivers/gpu/drm/msm/adreno/ |
| D | a6xx_hfi.h | 105 u32 vote; member
110 u32 vote; member
|
| D | a6xx_gmu.c | 152 * Send an invalid index as a vote for the bus bandwidth and let the in a6xx_gmu_set_freq()
153 * firmware decide on the right vote in a6xx_gmu_set_freq()
405 u32 vote; in a6xx_gmu_gfx_rail_on() local
411 vote = gmu->gx_arc_votes[gmu->nr_gpu_freqs - 1]; in a6xx_gmu_gfx_rail_on()
413 gmu_write(gmu, REG_A6XX_GMU_GX_VOTE_IDX, vote & 0xff); in a6xx_gmu_gfx_rail_on()
414 gmu_write(gmu, REG_A6XX_GMU_MX_VOTE_IDX, (vote >> 8) & 0xff); in a6xx_gmu_gfx_rail_on()
1123 /* Remove the bus vote */ in a6xx_gmu_stop()
1259 /* Construct a vote for each frequency */ in a6xx_gmu_rpmh_arc_votes_init()
1285 * nothing fits, use the maximum non zero vote in a6xx_gmu_rpmh_arc_votes_init()
1297 /* Construct the vote */ in a6xx_gmu_rpmh_arc_votes_init()
|
| D | a6xx_hfi.c | 224 msg.gx_votes[i].vote = gmu->gx_arc_votes[i]; in a6xx_hfi_send_perf_table_v1()
229 msg.cx_votes[i].vote = gmu->cx_arc_votes[i]; in a6xx_hfi_send_perf_table_v1()
246 msg.gx_votes[i].vote = gmu->gx_arc_votes[i]; in a6xx_hfi_send_perf_table()
252 msg.cx_votes[i].vote = gmu->cx_arc_votes[i]; in a6xx_hfi_send_perf_table()
|
| /kernel/linux/linux-5.10/drivers/slimbus/ |
| D | messaging.c | 49 /* Remove runtime-pm vote now that response was received for TID txn */ in slim_msg_response()
117 * do not vote for runtime-PM if the transactions are part of clock in slim_do_transfer()
169 * remove runtime-pm vote if this was TX only, or in slim_do_transfer()
|
| /kernel/linux/linux-6.6/drivers/slimbus/ |
| D | messaging.c | 49 /* Remove runtime-pm vote now that response was received for TID txn */ in slim_msg_response()
117 * do not vote for runtime-PM if the transactions are part of clock in slim_do_transfer()
170 * remove runtime-pm vote if this was TX only, or in slim_do_transfer()
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/interconnect/ |
| D | qcom,bcm-voter.yaml | 15 Coordinators (RSC). Interconnect providers are able to vote for aggregated
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/interconnect/ |
| D | qcom,bcm-voter.yaml | 15 Coordinators (RSC). Interconnect providers are able to vote for aggregated
|
| /kernel/linux/linux-5.10/drivers/bluetooth/ |
| D | hci_qca.c | 103 /* HCI_IBS transmit and receive side clock state vote */
279 static void serial_clock_vote(unsigned long vote, struct hci_uart *hu) in serial_clock_vote() argument
287 switch (vote) { in serial_clock_vote()
330 BT_DBG("Vote serial clock %s(%s)", new_vote ? "true" : "false", in serial_clock_vote()
331 vote ? "true" : "false"); in serial_clock_vote()
381 /* Vote for serial clock */ in qca_wq_awake_device()
436 BT_DBG("hu %p rx clock vote off", hu); in qca_wq_serial_rx_clock_vote_off()
447 BT_DBG("hu %p tx clock vote off", hu); in qca_wq_serial_tx_clock_vote_off()
452 /* Now that message queued to tty driver, vote for tty clocks off. in qca_wq_serial_tx_clock_vote_off()
784 /* Vote off rx clock under workqueue */ in device_want_to_sleep()
|
| /kernel/linux/linux-5.10/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,smd-rpm.yaml | 12 to vote for state of the system resources, such as clocks, regulators and bus
|
| /kernel/linux/linux-6.6/drivers/net/wwan/ |
| D | qcom_bam_dmux.c | 730 /* Vote for power state */ in bam_dmux_runtime_resume()
815 /* Runtime PM manages our own power vote. in bam_dmux_probe()
871 /* Drop our own power vote */ in bam_dmux_remove()
877 /* Try to wait for remote side to drop power vote */ in bam_dmux_remove()
|
| /kernel/linux/linux-6.6/arch/arm/common/ |
| D | vlock.S | 63 strb r1, [r0, #VLOCK_OWNER_OFFSET] @ submit my vote
|
| /kernel/linux/linux-6.6/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,rpm.yaml | 12 to vote for state of the system resources, such as clocks, regulators and bus
|
| /kernel/linux/linux-5.10/arch/arm/common/ |
| D | vlock.S | 61 strb r1, [r0, #VLOCK_OWNER_OFFSET] @ submit my vote
|