Lines Matching refs:replaceable

18 <arg choice="opt">-c <replaceable/count/</arg>
19 <arg choice="opt">-F <replaceable/flowlabel/</arg>
20 <arg choice="opt">-i <replaceable/interval/</arg>
21 <arg choice="opt">-I <replaceable/interface/</arg>
22 <arg choice="opt">-l <replaceable/preload/</arg>
23 <arg choice="opt">-m <replaceable/mark/</arg>
24 <arg choice="opt">-M <replaceable/pmtudisc_option/</arg>
25 <arg choice="opt">-N <replaceable/nodeinfo_option/</arg>
26 <arg choice="opt">-w <replaceable/deadline/</arg>
27 <arg choice="opt">-W <replaceable/timeout/</arg>
28 <arg choice="opt">-p <replaceable/pattern/</arg>
29 <arg choice="opt">-Q <replaceable/tos/</arg>
30 <arg choice="opt">-s <replaceable/packetsize/</arg>
31 <arg choice="opt">-S <replaceable/sndbuf/</arg>
32 <arg choice="opt">-t <replaceable/ttl/</arg>
33 <arg choice="opt">-T <replaceable/timestamp option/</arg>
34 <arg choice="opt" rep="repeat"><replaceable/hop/</arg>
35 <arg choice="req"><replaceable/destination/</arg>
49 Intermediate <replaceable/hop/s may not be allowed, because IPv6 source routing was deprecated (RFC…
85   <term><option><anchor id="ping.count">-c <replaceable/count/</option></term>
87 Stop after sending <replaceable/count/ ECHO_REQUEST
89 <link linkend="ping.deadline"><replaceable/deadline/</link>
91 <replaceable/count/ ECHO_REPLY packets, until the timeout expires.
121   <term><option>-F <replaceable/flow label/</option></term>
135   <term><option>-i <replaceable/interval/</option></term>
137 Wait <replaceable/interval/ seconds between sending each packet.
144   <term><option>-I <replaceable/interface/</option></term>
146 <replaceable/interface/ is either an address, or an interface name.
147 If <replaceable/interface/ is an address, it sets source address
149 If <replaceable/interface/ in an interface name, it sets
153 <replaceable/destination/, or by this option) is required.
157   <term><option>-l <replaceable/preload/</option></term>
159 If <replaceable/preload/ is specified,
172   <term><option>-m <replaceable/mark/</option></term>
174 use <replaceable/mark/ to tag the packets going out. This is useful
180   <term><option>-M <replaceable/pmtudisc_opt/</option></term>
183 <replaceable/pmtudisc_option/ may be either <replaceable/do/
185 <replaceable/want/ (do PMTU discovery, fragment locally when packet size
186 is large), or <replaceable/dont/ (do not set DF flag).
190   <term><option>-N <replaceable/nodeinfo_option/</option></term>
252      <term><option>subject-ipv6=<replaceable/ipv6addr/</option></term>
258      <term><option>subject-ipv4=<replaceable/ipv4addr/</option></term>
264      <term><option>subject-name=<replaceable/nodename/</option></term>
271      <term><option>subject-fqdn=<replaceable/nodename/</option></term>
294   <term><option>-p <replaceable/pattern/</option></term>
311   <term><option>-Q <replaceable/tos/</option></term>
314 	<replaceable/tos/ can be decimal (<command/ping/ only) or hex number.
353   <term><option>-s <replaceable/packetsize/</option></term>
361   <term><option>-S <replaceable/sndbuf/</option></term>
368   <term><option>-t <replaceable/ttl/</option></term>
375   <term><option>-T <replaceable/timestamp option/</option></term>
378 <replaceable/timestamp option/ may be either 
379 <replaceable/tsonly/ (only timestamps), 
380 <replaceable/tsandaddr/ (timestamps and addresses) or 
381 <replaceable/tsprespec host1 [host2 [host3 [host4]]]/
407   <term><option><anchor id="ping.deadline">-w <replaceable/deadline/</option></term>
415 <link linkend="ping.count"><replaceable/count/</link>
417 <link linkend="ping.deadline"><replaceable/deadline/</link>
419 <link linkend="ping.count"><replaceable/count/</link>
424   <term><option>-W <replaceable/timeout/</option></term>
450 <link linkend="ping.count"><replaceable/count/</link>
452 <link linkend="ping.deadline"><replaceable/deadline/</link>
454 <link linkend="ping.count"><replaceable/count/</link>
456 <link linkend="ping.deadline"><replaceable/deadline/</link>
480 When a <replaceable/packetsize/ is given, this indicated the size of this