Lines Matching refs:DDR

4 RAMBOOT literally means boot from DDR. But since DDR is volatile memory some
5 pre-mechanism is required to load the DDR with the bootloader binary.
9   which can initialize the DDR and get the complete bootloader copied to DDR.
11 In addition to the above there could be some more methods to initialize the DDR
15 1. Load the RAM based bootloader onto DDR via JTAG/BDI interface. And then
16    execute the bootloader from DDR.
22 2. Load the RAM based bootloader onto DDR using already existing bootloader on
23    the board.And then execute the bootloader from DDR.
29 	In this case you can get your test bootloader binary into DDR via tftp
51    Preconfigure DDR/L2SRAM through JTAG interface.
52 	- setup DDR controller registers.
53 	- setup DDR LAWs
54 	- setup DDR TLB
55    Load the RAM based boot loader to the proper location in DDR/L2SRAM.
60    get the rambased boot loader binary into DDR/L2SRAM via tftp.
65 Please note that L2SRAM can also be used instead of DDR if the SOC has