##This file needs to be pushed into /vendor/etc/libese-nxp.conf

###############################################################################
# Application options
SE_DEBUG_ENABLED=0


#Timeout in secs
NXP_SWP_RD_TAG_OP_TIMEOUT=0xFF

#WTX Count in secs
NXP_WTX_COUNT_VALUE=90

# PN67T_PWR_SCHEME          0x01
# PN80T_LEGACY_PWR_SCHEME   0x02
# PN80T_EXT_PMU_SCHEME      0x03
NXP_POWER_SCHEME=0x02

# For SOF = 0x5A            0x01
# For SOF = 0x00            0x02
NXP_SOF_WRITE=0x01

#SPI Thorughput measurement log enabled(1)/disabled(0) in kernel
NXP_TP_MEASUREMENT=0x00

#Enable/Disable interface reset as part of SPI open
NXP_SPI_INTF_RST_ENABLE=0x01

###############################################################################
# SPI WRITE TIMEOUT for RF event synchronization
NXP_SPI_WRITE_TIMEOUT=0x14

###############################################################################
# SPI Device Node name
NXP_ESE_DEV_NODE="/dev/pn81a"

#MAX NO OF R_NACK RETRY ALLOWED IN CASE OF CRC FAILURE
NXP_MAX_RNACK_RETRY=0x0A