1 // SPDX-License-Identifier: GPL-2.0+
2 /*
3 * Freescale i.MX23/i.MX28 LCDIF driver
4 *
5 * Copyright (C) 2011-2013 Marek Vasut <marex@denx.de>
6 */
7 #include <common.h>
8 #include <malloc.h>
9 #include <video_fb.h>
10
11 #include <asm/arch/imx-regs.h>
12 #include <asm/arch/clock.h>
13 #include <asm/arch/sys_proto.h>
14 #include <linux/errno.h>
15 #include <asm/io.h>
16
17 #include <asm/mach-imx/dma.h>
18
19 #include "videomodes.h"
20
21 #define PS2KHZ(ps) (1000000000UL / (ps))
22
23 static GraphicDevice panel;
24 struct mxs_dma_desc desc;
25
26 /**
27 * mxsfb_system_setup() - Fine-tune LCDIF configuration
28 *
29 * This function is used to adjust the LCDIF configuration. This is usually
30 * needed when driving the controller in System-Mode to operate an 8080 or
31 * 6800 connected SmartLCD.
32 */
mxsfb_system_setup(void)33 __weak void mxsfb_system_setup(void)
34 {
35 }
36
37 /*
38 * ARIES M28EVK:
39 * setenv videomode
40 * video=ctfb:x:800,y:480,depth:18,mode:0,pclk:30066,
41 * le:0,ri:256,up:0,lo:45,hs:1,vs:1,sync:100663296,vmode:0
42 *
43 * Freescale mx23evk/mx28evk with a Seiko 4.3'' WVGA panel:
44 * setenv videomode
45 * video=ctfb:x:800,y:480,depth:24,mode:0,pclk:29851,
46 * le:89,ri:164,up:23,lo:10,hs:10,vs:10,sync:0,vmode:0
47 */
48
mxs_lcd_init(GraphicDevice * panel,struct ctfb_res_modes * mode,int bpp)49 static void mxs_lcd_init(GraphicDevice *panel,
50 struct ctfb_res_modes *mode, int bpp)
51 {
52 struct mxs_lcdif_regs *regs = (struct mxs_lcdif_regs *)MXS_LCDIF_BASE;
53 uint32_t word_len = 0, bus_width = 0;
54 uint8_t valid_data = 0;
55
56 /* Kick in the LCDIF clock */
57 mxs_set_lcdclk(MXS_LCDIF_BASE, PS2KHZ(mode->pixclock));
58
59 /* Restart the LCDIF block */
60 mxs_reset_block(®s->hw_lcdif_ctrl_reg);
61
62 switch (bpp) {
63 case 24:
64 word_len = LCDIF_CTRL_WORD_LENGTH_24BIT;
65 bus_width = LCDIF_CTRL_LCD_DATABUS_WIDTH_24BIT;
66 valid_data = 0x7;
67 break;
68 case 18:
69 word_len = LCDIF_CTRL_WORD_LENGTH_24BIT;
70 bus_width = LCDIF_CTRL_LCD_DATABUS_WIDTH_18BIT;
71 valid_data = 0x7;
72 break;
73 case 16:
74 word_len = LCDIF_CTRL_WORD_LENGTH_16BIT;
75 bus_width = LCDIF_CTRL_LCD_DATABUS_WIDTH_16BIT;
76 valid_data = 0xf;
77 break;
78 case 8:
79 word_len = LCDIF_CTRL_WORD_LENGTH_8BIT;
80 bus_width = LCDIF_CTRL_LCD_DATABUS_WIDTH_8BIT;
81 valid_data = 0xf;
82 break;
83 }
84
85 writel(bus_width | word_len | LCDIF_CTRL_DOTCLK_MODE |
86 LCDIF_CTRL_BYPASS_COUNT | LCDIF_CTRL_LCDIF_MASTER,
87 ®s->hw_lcdif_ctrl);
88
89 writel(valid_data << LCDIF_CTRL1_BYTE_PACKING_FORMAT_OFFSET,
90 ®s->hw_lcdif_ctrl1);
91
92 mxsfb_system_setup();
93
94 writel((mode->yres << LCDIF_TRANSFER_COUNT_V_COUNT_OFFSET) | mode->xres,
95 ®s->hw_lcdif_transfer_count);
96
97 writel(LCDIF_VDCTRL0_ENABLE_PRESENT | LCDIF_VDCTRL0_ENABLE_POL |
98 LCDIF_VDCTRL0_VSYNC_PERIOD_UNIT |
99 LCDIF_VDCTRL0_VSYNC_PULSE_WIDTH_UNIT |
100 mode->vsync_len, ®s->hw_lcdif_vdctrl0);
101 writel(mode->upper_margin + mode->lower_margin +
102 mode->vsync_len + mode->yres,
103 ®s->hw_lcdif_vdctrl1);
104 writel((mode->hsync_len << LCDIF_VDCTRL2_HSYNC_PULSE_WIDTH_OFFSET) |
105 (mode->left_margin + mode->right_margin +
106 mode->hsync_len + mode->xres),
107 ®s->hw_lcdif_vdctrl2);
108 writel(((mode->left_margin + mode->hsync_len) <<
109 LCDIF_VDCTRL3_HORIZONTAL_WAIT_CNT_OFFSET) |
110 (mode->upper_margin + mode->vsync_len),
111 ®s->hw_lcdif_vdctrl3);
112 writel((0 << LCDIF_VDCTRL4_DOTCLK_DLY_SEL_OFFSET) | mode->xres,
113 ®s->hw_lcdif_vdctrl4);
114
115 writel(panel->frameAdrs, ®s->hw_lcdif_cur_buf);
116 writel(panel->frameAdrs, ®s->hw_lcdif_next_buf);
117
118 /* Flush FIFO first */
119 writel(LCDIF_CTRL1_FIFO_CLEAR, ®s->hw_lcdif_ctrl1_set);
120
121 #ifndef CONFIG_VIDEO_MXS_MODE_SYSTEM
122 /* Sync signals ON */
123 setbits_le32(®s->hw_lcdif_vdctrl4, LCDIF_VDCTRL4_SYNC_SIGNALS_ON);
124 #endif
125
126 /* FIFO cleared */
127 writel(LCDIF_CTRL1_FIFO_CLEAR, ®s->hw_lcdif_ctrl1_clr);
128
129 /* RUN! */
130 writel(LCDIF_CTRL_RUN, ®s->hw_lcdif_ctrl_set);
131 }
132
lcdif_power_down(void)133 void lcdif_power_down(void)
134 {
135 struct mxs_lcdif_regs *regs = (struct mxs_lcdif_regs *)MXS_LCDIF_BASE;
136 int timeout = 1000000;
137
138 if (!panel.frameAdrs)
139 return;
140
141 writel(panel.frameAdrs, ®s->hw_lcdif_cur_buf_reg);
142 writel(panel.frameAdrs, ®s->hw_lcdif_next_buf_reg);
143 writel(LCDIF_CTRL1_VSYNC_EDGE_IRQ, ®s->hw_lcdif_ctrl1_clr);
144 while (--timeout) {
145 if (readl(®s->hw_lcdif_ctrl1_reg) &
146 LCDIF_CTRL1_VSYNC_EDGE_IRQ)
147 break;
148 udelay(1);
149 }
150 mxs_reset_block((struct mxs_register_32 *)®s->hw_lcdif_ctrl_reg);
151 }
152
video_hw_init(void)153 void *video_hw_init(void)
154 {
155 int bpp = -1;
156 char *penv;
157 void *fb;
158 struct ctfb_res_modes mode;
159
160 puts("Video: ");
161
162 /* Suck display configuration from "videomode" variable */
163 penv = env_get("videomode");
164 if (!penv) {
165 puts("MXSFB: 'videomode' variable not set!\n");
166 return NULL;
167 }
168
169 bpp = video_get_params(&mode, penv);
170
171 /* fill in Graphic device struct */
172 sprintf(panel.modeIdent, "%dx%dx%d",
173 mode.xres, mode.yres, bpp);
174
175 panel.winSizeX = mode.xres;
176 panel.winSizeY = mode.yres;
177 panel.plnSizeX = mode.xres;
178 panel.plnSizeY = mode.yres;
179
180 switch (bpp) {
181 case 24:
182 case 18:
183 panel.gdfBytesPP = 4;
184 panel.gdfIndex = GDF_32BIT_X888RGB;
185 break;
186 case 16:
187 panel.gdfBytesPP = 2;
188 panel.gdfIndex = GDF_16BIT_565RGB;
189 break;
190 case 8:
191 panel.gdfBytesPP = 1;
192 panel.gdfIndex = GDF__8BIT_INDEX;
193 break;
194 default:
195 printf("MXSFB: Invalid BPP specified! (bpp = %i)\n", bpp);
196 return NULL;
197 }
198
199 panel.memSize = mode.xres * mode.yres * panel.gdfBytesPP;
200
201 /* Allocate framebuffer */
202 fb = memalign(ARCH_DMA_MINALIGN,
203 roundup(panel.memSize, ARCH_DMA_MINALIGN));
204 if (!fb) {
205 printf("MXSFB: Error allocating framebuffer!\n");
206 return NULL;
207 }
208
209 /* Wipe framebuffer */
210 memset(fb, 0, panel.memSize);
211
212 panel.frameAdrs = (u32)fb;
213
214 printf("%s\n", panel.modeIdent);
215
216 /* Start framebuffer */
217 mxs_lcd_init(&panel, &mode, bpp);
218
219 #ifdef CONFIG_VIDEO_MXS_MODE_SYSTEM
220 /*
221 * If the LCD runs in system mode, the LCD refresh has to be triggered
222 * manually by setting the RUN bit in HW_LCDIF_CTRL register. To avoid
223 * having to set this bit manually after every single change in the
224 * framebuffer memory, we set up specially crafted circular DMA, which
225 * sets the RUN bit, then waits until it gets cleared and repeats this
226 * infinitelly. This way, we get smooth continuous updates of the LCD.
227 */
228 struct mxs_lcdif_regs *regs = (struct mxs_lcdif_regs *)MXS_LCDIF_BASE;
229
230 memset(&desc, 0, sizeof(struct mxs_dma_desc));
231 desc.address = (dma_addr_t)&desc;
232 desc.cmd.data = MXS_DMA_DESC_COMMAND_NO_DMAXFER | MXS_DMA_DESC_CHAIN |
233 MXS_DMA_DESC_WAIT4END |
234 (1 << MXS_DMA_DESC_PIO_WORDS_OFFSET);
235 desc.cmd.pio_words[0] = readl(®s->hw_lcdif_ctrl) | LCDIF_CTRL_RUN;
236 desc.cmd.next = (uint32_t)&desc.cmd;
237
238 /* Execute the DMA chain. */
239 mxs_dma_circ_start(MXS_DMA_CHANNEL_AHB_APBH_LCDIF, &desc);
240 #endif
241
242 return (void *)&panel;
243 }
244