1if TARGET_APALIS_IMX6 2 3config SYS_BOARD 4 default "apalis_imx6" 5 6config SYS_CONFIG_NAME 7 default "apalis_imx6" 8 9config SYS_CPU 10 default "armv7" 11 12config SYS_SOC 13 default "mx6" 14 15config SYS_VENDOR 16 default "toradex" 17 18config TDX_CFG_BLOCK 19 default y 20 21config TDX_HAVE_MMC 22 default y 23 24config TDX_CFG_BLOCK_DEV 25 default "0" 26 27config TDX_CFG_BLOCK_PART 28 default "1" 29 30# Toradex config block in eMMC, at the end of 1st "boot sector" 31config TDX_CFG_BLOCK_OFFSET 32 default "-512" 33 34config TDX_CMD_IMX_MFGR 35 bool "Enable factory testing commands for Toradex iMX 6 modules" 36 help 37 This adds the commands 38 pf0100_otp_prog - Program the OTP fuses on the PMIC PF0100 39 If executed on already fused modules it doesn't change any fuse setting. 40 default y 41 42config TDX_APALIS_IMX6_V1_0 43 bool "Apalis iMX6 V1.0 HW" 44 help 45 Apalis iMX6 V1.0 HW has a different pinout for the UART. 46 The UARTs must be used in DCE mode, RTS/CTS are swapped and 47 thus unusable on standard carrier boards. 48 This option configures DCE mode unconditionally. Whithout this 49 option the config block stating V1.0 HW selects DCE mode, 50 otherwise the UARTs are configuered in DTE mode. 51 default n 52 53source "board/toradex/common/Kconfig" 54 55endif 56