1 /* SPDX-License-Identifier: GPL-2.0+ */ 2 /* 3 * Copyright 2016 Freescale Semiconductor 4 */ 5 6 #ifndef __LS1012A_COMMON_H 7 #define __LS1012A_COMMON_H 8 9 #define CONFIG_FSL_LAYERSCAPE 10 #define CONFIG_GICV2 11 12 #include <asm/arch/config.h> 13 #include <asm/arch/stream_id_lsch2.h> 14 15 #define CONFIG_SYS_CLK_FREQ 125000000 16 17 #define CONFIG_SKIP_LOWLEVEL_INIT 18 19 #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0) 20 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000) 21 22 #define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000 23 #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0 24 #define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE 25 #define CONFIG_SYS_DDR_BLOCK2_BASE 0x880000000ULL 26 27 /* Generic Timer Definitions */ 28 #define COUNTER_FREQUENCY 25000000 /* 25MHz */ 29 30 /* CSU */ 31 #define CONFIG_LAYERSCAPE_NS_ACCESS 32 33 /* Size of malloc() pool */ 34 #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024) 35 36 /*SPI device */ 37 #ifdef CONFIG_QSPI_BOOT 38 #define CONFIG_SYS_QE_FW_IN_SPIFLASH 39 #define CONFIG_SYS_FMAN_FW_ADDR 0x400d0000 40 #define CONFIG_ENV_SPI_BUS 0 41 #define CONFIG_ENV_SPI_CS 0 42 #define CONFIG_ENV_SPI_MAX_HZ 1000000 43 #define CONFIG_ENV_SPI_MODE 0x03 44 #define CONFIG_SPI_FLASH_SPANSION 45 #define CONFIG_FSL_SPI_INTERFACE 46 #define CONFIG_SF_DATAFLASH 47 48 #define CONFIG_FSL_QSPI 49 #define QSPI0_AMBA_BASE 0x40000000 50 #define CONFIG_SPI_FLASH_SPANSION 51 52 #define FSL_QSPI_FLASH_SIZE SZ_64M 53 #define FSL_QSPI_FLASH_NUM 2 54 55 /* 56 * Environment 57 */ 58 #define CONFIG_ENV_OVERWRITE 59 60 #define CONFIG_ENV_SIZE 0x40000 /* 256KB */ 61 #define CONFIG_ENV_OFFSET 0x300000 /* 3MB */ 62 #define CONFIG_ENV_SECT_SIZE 0x40000 63 #endif 64 65 /* SATA */ 66 #define CONFIG_SCSI_AHCI_PLAT 67 68 #define CONFIG_SYS_SATA AHCI_BASE_ADDR 69 70 #define CONFIG_SYS_SCSI_MAX_SCSI_ID 1 71 #define CONFIG_SYS_SCSI_MAX_LUN 1 72 #define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \ 73 CONFIG_SYS_SCSI_MAX_LUN) 74 75 /* I2C */ 76 #define CONFIG_SYS_I2C 77 78 #define CONFIG_SYS_NS16550_SERIAL 79 #define CONFIG_SYS_NS16550_REG_SIZE 1 80 #define CONFIG_SYS_NS16550_CLK (get_serial_clock()) 81 82 #define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 } 83 84 #define CONFIG_SYS_HZ 1000 85 86 #define CONFIG_HWCONFIG 87 #define HWCONFIG_BUFFER_SIZE 128 88 89 #ifndef CONFIG_SPL_BUILD 90 #define BOOT_TARGET_DEVICES(func) \ 91 func(SCSI, scsi, 0) \ 92 func(MMC, mmc, 0) \ 93 func(USB, usb, 0) 94 #include <config_distro_bootcmd.h> 95 #endif 96 97 /* Initial environment variables */ 98 #define CONFIG_EXTRA_ENV_SETTINGS \ 99 "verify=no\0" \ 100 "loadaddr=0x80100000\0" \ 101 "kernel_addr=0x100000\0" \ 102 "fdt_high=0xffffffffffffffff\0" \ 103 "initrd_high=0xffffffffffffffff\0" \ 104 "kernel_start=0x1000000\0" \ 105 "kernel_load=0xa0000000\0" \ 106 "kernel_size=0x2800000\0" \ 107 108 #undef CONFIG_BOOTCOMMAND 109 #define CONFIG_BOOTCOMMAND "pfe stop; sf probe 0:0; sf read $kernel_load "\ 110 "$kernel_start $kernel_size && "\ 111 "bootm $kernel_load" 112 113 /* Monitor Command Prompt */ 114 #define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */ 115 #define CONFIG_SYS_MAXARGS 64 /* max command args */ 116 117 #define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */ 118 119 #include <asm/arch/soc.h> 120 121 #endif /* __LS1012A_COMMON_H */ 122