Searched refs:UIM_DBG (Results 1 – 2 of 2) sorted by relevance
| /device/linaro/hikey/wpan/uim/ |
| D | uim.c | 189 UIM_DBG("Command complete done"); in read_command_complete()
230 UIM_DBG("set_baud_rate() done"); in set_baud_rate()
441 UIM_DBG("Installed N_TI_WL Line displine"); in st_uart_config()
444 UIM_DBG("Un-Installed N_TI_WL Line displine"); in st_uart_config()
513 UIM_DBG("unable to open %s(%s)", sysfs_install_entry, strerror(errno)); in main()
524 UIM_DBG("install set previously..."); in main()
528 UIM_DBG("begin polling..."); in main()
537 UIM_DBG("poll broke due to event %d(PRI:%d/ERR:%d)\n", p.revents, POLLPRI, POLLERR); in main()
547 UIM_DBG("unable to open %s (%s)", sysfs_install_entry, strerror(errno)); in main()
554 UIM_DBG("read %c from install \n", install); in main()
|
| D | uim.h | 82 #define UIM_DBG(fmt, arg...) printf("uim:"fmt"\n" , ## arg) macro
86 #define UIM_DBG(fmt, arg...) printf("uim:"fmt"\n" , ## arg) macro
90 #define UIM_DBG(fmt, arg...) macro
|