| /hardware/broadcom/wlan/bcmdhd/dhdutil/include/ |
| D | typedefs.h | 268 #ifndef OFF
269 #define OFF 0 macro
|
| /hardware/interfaces/audio/core/all-versions/default/ |
| D | PrimaryDevice.cpp | 216 case IPrimaryDevice::TtyMode::OFF: in convertTtyModeFromHIDL()
230 return IPrimaryDevice::TtyMode::OFF; in convertTtyModeToHIDL()
244 _hidl_cb(retval, TtyMode::OFF); in getTtyMode()
250 _hidl_cb(Result::INVALID_STATE, TtyMode::OFF); in getTtyMode()
|
| /hardware/interfaces/graphics/composer/2.1/vts/functional/ |
| D | VtsHalGraphicsComposerV2_1TargetTest.cpp | 446 mComposerClient->setPowerMode(mPrimaryDisplay, IComposerClient::PowerMode::OFF)); in TEST_F()
456 mComposerClient->setPowerMode(mPrimaryDisplay, IComposerClient::PowerMode::OFF)); in TEST_F()
540 modes.push_back(IComposerClient::PowerMode::OFF); in TEST_F()
563 modes.push_back(IComposerClient::PowerMode::OFF); in TEST_F()
565 modes.push_back(IComposerClient::PowerMode::OFF); in TEST_F()
572 modes.push_back(IComposerClient::PowerMode::OFF); in TEST_F()
573 modes.push_back(IComposerClient::PowerMode::OFF); in TEST_F()
|
| /hardware/qcom/sdm845/display/libhistogram/ |
| D | histogram_collector.cpp | 273 OFF, enumerator
506 if (state != CrtcPowerState::OFF) { in collecting_thread()
515 state = CrtcPowerState::OFF; in collecting_thread()
551 state = (state_raw) ? CrtcPowerState::ON : CrtcPowerState::OFF; in collecting_thread()
|
| /hardware/interfaces/graphics/composer/2.2/vts/functional/ |
| D | VtsHalGraphicsComposerV2_2TargetTest.cpp | 337 modes.push_back(IComposerClient::PowerMode::OFF); in TEST_F()
355 modes.push_back(IComposerClient::PowerMode::OFF); in TEST_F()
356 modes.push_back(IComposerClient::PowerMode::OFF); in TEST_F()
|
| D | VtsHalGraphicsComposerV2_2ReadbackTest.cpp | 204 ASSERT_NO_FATAL_FAILURE(mComposerClient->setPowerMode(mPrimaryDisplay, PowerMode::OFF)); in TearDown()
|
| /hardware/interfaces/graphics/composer/2.1/ |
| D | IComposerCallback.hal | 35 * Displays which have been connected are assumed to be in PowerMode::OFF,
|
| D | IComposerClient.hal | 74 OFF = 0,
542 * All displays must support PowerMode::ON and PowerMode::OFF. Whether a
|
| /hardware/interfaces/radio/1.0/ |
| D | IRadioIndication.hal | 449 * 2) RadioState:OFF->RadioState:UNAVAILABLE->RadioState:OFF
452 * to RadioState:ON/RadioState:OFF again.
453 * It must NOT be sent after the Radio state changes to RadioState:ON/RadioState:OFF after the
|
| D | types.hal | 234 OFF = 0, // Radio explicitly powered off (eg CFUN=0)
386 RADIO_OFF = 247, // Radio is OFF
685 OFF,
|
| D | IRadio.hal | 959 * @param off is the DTMF OFF length in milliseconds, or 0 to use default
|
| D | IRadioResponse.hal | 371 * LastCallFailCause:RADIO_OFF (Radio is OFF)
|
| /hardware/qcom/sdm845/display/libdrmutils/ |
| D | drm_interface.h | 362 OFF, enumerator
|
| /hardware/interfaces/audio/2.0/ |
| D | IPrimaryDevice.hal | 80 OFF,
|
| /hardware/interfaces/audio/5.0/ |
| D | IPrimaryDevice.hal | 133 OFF,
|
| /hardware/interfaces/audio/4.0/ |
| D | IPrimaryDevice.hal | 133 OFF,
|
| /hardware/interfaces/automotive/vehicle/2.0/ |
| D | types.hal | 2339 * Most XXX_LIGHTS_STATE properties will only report ON and OFF states. Only
2344 OFF = 0,
2357 OFF = 0,
2920 * Steering wheel is not locked, engine and all accessories are OFF. If
2921 * car can be in LOCK and OFF state at the same time than HAL must report
2924 OFF,
2993 * temperature when the whole HVAC unit is turned OFF.
|
| /hardware/qcom/sdm845/display/sdm/libs/core/drm/ |
| D | hw_device_drm.cpp | 416 drm_atomic_intf_->Perform(DRMOps::CONNECTOR_SET_POWER_MODE, token_.conn_id, DRMPowerMode::OFF); in Deinit()
781 drm_atomic_intf_->Perform(DRMOps::CONNECTOR_SET_POWER_MODE, token_.conn_id, DRMPowerMode::OFF); in PowerOff()
|
| /hardware/interfaces/camera/common/1.0/ |
| D | types.hal | 77 OFF = 0, // Turn off the flash
|
| /hardware/interfaces/radio/1.0/vts/functional/ |
| D | radio_hidl_hal_misc.cpp | 334 radio->setTTYMode(serial, TtyMode::OFF); in TEST_F()
|
| /hardware/interfaces/graphics/composer/2.2/ |
| D | IComposerClient.hal | 327 * All displays must support PowerMode::ON and PowerMode::OFF. Whether a
|
| /hardware/interfaces/audio/core/all-versions/vts/functional/ |
| D | AudioPrimaryHidlHalTest.h | 1352 "TTY mode", Initial{IPrimaryDevice::TtyMode::OFF}, in TEST_F()
|
| /hardware/qcom/camera/msm8998/QCamera2/stack/common/ |
| D | cam_types.h | 2724 OFF, enumerator
|
| /hardware/interfaces/camera/provider/2.4/vts/functional/ |
| D | VtsHalCameraProviderV2_4TargetTest.cpp | 2513 returnStatus = device3_x->setTorchMode(TorchMode::OFF); in TEST_F()
2563 returnStatus = device1->setTorchMode(TorchMode::OFF); in TEST_F()
|