Searched refs:RSSI (Results 1 – 8 of 8) sorted by relevance
53 * Called when the RSSI of the currently connected access point goes beyond the58 * @param currRssi RSSI of the currently connected access point.
48 * If set indicates that the RSSI monitor APIs are supported.332 * Start RSSI monitoring on the currently connected access point.335 * invoked to indicate if the RSSI goes above |maxRssi| or below |minRssi|.339 * @param maxRssi Maximum RSSI threshold.340 * @param minRssi Minimum RSSI threshold.354 * Stop RSSI monitoring.
124 * RSSI information.378 * is reached the highest RSSI results must be returned.429 * Access Point Beacon and Management frames RSSI (averaged).729 * RSSI values controlling clustering behavior per spec. RSSI values are specified without a sign,735 * RSSI value determining whether discovery is near (used if enabled in discovery by737 * RSSI values are specified without a sign, e.g. a value of -65dBm would be specified as 65.877 * Number of samples used to calculate RSSI.1432 * If RSSI filtering was enabled using |NanDiscoveryCommonConfig.useRssiThreshold| in discovery1433 * session setup then this field contains the received RSSI value. It will contain 0 if RSSI1435 * RSSI values are returned without sign, e.g. -70dBm will be returned as 70.
64 * -GERAN - RSSI65 * -CDMA2000 - RSSI
445 * UTRA carrier RSSI as defined in TS 25.225 5.1.4
113 /* Minimum qualifying RSSI to be considered for network selection (dBm) */
784 int32_t rssi; // Received RSSI in GSM,1248 uint32_t dbm; // This value is the actual RSSI1250 // actual RSSI is -75, then this response value will1260 // RSSI value multiplied by -1.1261 // Example: If the actual RSSI is -75,
131 int16 RSSI; /* receive signal strength (in dBm) */ member164 int16 RSSI; /* receive signal strength (in dBm) */ member206 int16 RSSI; /* receive signal strength (in dBm) */ member3902 int16 RSSI; /* receive signal strength (in dBm) */ member