Lines Matching refs:STA

21 	* added AKMSuiteSelector into "STA <addr>" control interface data to
183 	  the STA has some more time to configure the key before this frame is
186 	* extended VLAN support (per-STA vif, etc.)
199 	    unassociated STA used that address
257 	* add support for learning STA IPv4/IPv6 addresses and configuring
278 	* expire hostapd STA entry if kernel does not have a matching entry
330 	* fixed STA validation step for WPS ER commands to prevent a potential
433 	* added AP-STA-DISCONNECTED ctrl_iface event
524 	  (do not send QoS frames if the STA did not negotiate use of QoS for
531 	* Delay STA entry removal until Deauth/Disassoc TX status in AP mode.
533 	  Disassociation frames when the STA is in power save sleep. Only
550 	* Add bridge handling for WDS STA interfaces. By default they are
555 	  - Add wds_bridge command for specifying bridge for WDS STA
558 	  - Send AP-STA-DISCONNECTED event when an AP disconnects a station
567 	  Use hostapd_cli ess_disassoc (STA addr) (URL) to send the
568 	  notification to the STA.
570 	  the data connection is not working properly, e.g., due to the STA
694 	* driver_nl80211: fixed STA accounting data collection (TX/RX bytes
898 	  for each STA based on RADIUS Access-Accept attributes); this requires
920 	* added 'hostapd_cli new_sta <addr>' command for adding a new STA into
1042 	* fixed PMKSA caching for the case where STA (re)associates without
1159 	* fixed EAPOL state machine to stop if STA is removed during
1198 	* fixed STA disassociation handler to mark next timeout state to
1200 	  and extra disassociation, if the STA disassociates without
1236 	  not start EAPOL state machines if the STA selected to use WPA-PSK)
1249 	  to the STA before sending a new one
1256 	  - allow different update intervals for each STA
1261 	  STA immediately (e.g., if STA deauthenticates and re-associates
1271 	  previously sent after the kernel entry for the STA (and/or IEEE