/external/arm-trusted-firmware/drivers/mtd/spi-mem/ |
D | spi_mem.c | 211 cuint = fdt_getprop(fdt, bus_subnode, "reg", NULL); in spi_mem_init_slave() 220 cuint = fdt_getprop(fdt, bus_subnode, in spi_mem_init_slave() 227 if ((fdt_getprop(fdt, bus_subnode, "spi-cpol", NULL)) != NULL) { in spi_mem_init_slave() 230 if ((fdt_getprop(fdt, bus_subnode, "spi-cpha", NULL)) != NULL) { in spi_mem_init_slave() 233 if ((fdt_getprop(fdt, bus_subnode, "spi-cs-high", NULL)) != in spi_mem_init_slave() 237 if ((fdt_getprop(fdt, bus_subnode, "spi-3wire", NULL)) != in spi_mem_init_slave() 241 if ((fdt_getprop(fdt, bus_subnode, "spi-half-duplex", NULL)) != in spi_mem_init_slave() 247 cuint = fdt_getprop(fdt, bus_subnode, "spi-tx-bus-width", NULL); in spi_mem_init_slave() 265 cuint = fdt_getprop(fdt, bus_subnode, "spi-rx-bus-width", NULL); in spi_mem_init_slave()
|
/external/arm-trusted-firmware/drivers/allwinner/axp/ |
D | common.c | 61 prop = fdt_getprop(fdt, node, "regulator-min-microvolt", NULL); in fdt_get_regulator_millivolt() 66 prop = fdt_getprop(fdt, node, "regulator-max-microvolt", NULL); in fdt_get_regulator_millivolt() 101 if (fdt_getprop(fdt, node, "phandle", NULL) != NULL) in should_enable_regulator() 103 if (fdt_getprop(fdt, node, "regulator-always-on", NULL) != NULL) in should_enable_regulator() 119 prop = fdt_getprop(fdt, node, "dr_mode", &length); in board_uses_usb0_host_mode() 143 if (fdt_getprop(fdt, node, "x-powers,drive-vbus-en", NULL) && in axp_setup_regulators()
|
/external/arm-trusted-firmware/drivers/st/gpio/ |
D | stm32_gpio.c | 40 if (fdt_getprop(fdt, pinctrl_subnode, in ckeck_gpio_bank() 45 cuint = fdt_getprop(fdt, pinctrl_subnode, "reg", NULL); in ckeck_gpio_bank() 73 cuint = fdt_getprop(fdt, node, "pinmux", &len); in dt_set_gpio_config() 83 slewrate = fdt_getprop(fdt, node, "slew-rate", NULL); in dt_set_gpio_config() 88 if (fdt_getprop(fdt, node, "bias-pull-up", NULL) != NULL) { in dt_set_gpio_config() 90 } else if (fdt_getprop(fdt, node, "bias-pull-down", NULL) != NULL) { in dt_set_gpio_config() 130 if (fdt_getprop(fdt, node, "drive-open-drain", NULL) != NULL) { in dt_set_gpio_config() 176 cuint = fdt_getprop(fdt, node, "pinctrl-0", &lenp); in dt_set_pinctrl_config()
|
/external/arm-trusted-firmware/drivers/st/pmic/ |
D | stm32mp_pmic.c | 86 cuint = fdt_getprop(fdt, pmic_node, "reg", NULL); in dt_pmic_i2c_config() 132 if ((fdt_getprop(fdt, regulator_node, "regulator-boot-on", 134 (fdt_getprop(fdt, regulator_node, "regulator-always-on", 137 if (fdt_getprop(fdt, regulator_node, "regulator-boot-on", 143 if (fdt_getprop(fdt, regulator_node, "regulator-pull-down", 152 if (fdt_getprop(fdt, regulator_node, "st,mask-reset", 161 cuint = fdt_getprop(fdt, regulator_node,
|
/external/dtc/tests/ |
D | path-references.c | 22 p = fdt_getprop(fdt, node, "ref", &len); in check_ref() 29 p = fdt_getprop(fdt, node, "lref", &len); in check_ref() 43 p = fdt_getprop(fdt, 0, "rref", &len); in check_rref() 73 p = fdt_getprop(fdt, 0, "multiref", &len); in main()
|
D | notfound.c | 37 fdt_getprop(fdt, 0, "nonexistant-property", &lenerr); in main() 44 fdt_getprop(fdt, subnode1_offset, "prop-str", &lenerr); in main()
|
D | nop_property.c | 37 intp = fdt_getprop(fdt, 0, "prop-int", &lenerr); in main() 50 strp = fdt_getprop(fdt, 0, "prop-str", &lenerr); in main()
|
D | references.c | 23 p = fdt_getprop(fdt, node, "ref", &len); in check_ref() 34 p = fdt_getprop(fdt, node, "lref", &len); in check_ref() 52 p = fdt_getprop(fdt, 0, "rref", &len); in check_rref()
|
D | phandle_format.c | 54 if (fdt_getprop(fdt, n4, "linux,phandle", NULL)) in main() 60 if (fdt_getprop(fdt, n4, "phandle", NULL)) in main()
|
D | del_property.c | 41 intp = fdt_getprop(fdt, 0, "prop-int", &lenerr); in main() 55 strp = fdt_getprop(fdt, 0, "prop-str", &lenerr); in main()
|
D | truncated_property.c | 28 prop = fdt_getprop(fdt, 0, "truncated", &len); in main()
|
D | subnode_iterate.c | 30 prop = fdt_getprop(fdt, parent_offset, "subnodes", &len); in test_node()
|
D | property_iterate.c | 33 prop = fdt_getprop(fdt, parent_offset, "test-properties", &len); in test_node()
|
D | sized_cells.c | 25 propval = fdt_getprop(fdt, 0, name_one, &proplen); in check_compare_properties()
|
D | integer-expressions.c | 84 res = fdt_getprop(fdt, 0, "expressions", &reslen); in main()
|
/external/arm-trusted-firmware/drivers/st/clk/ |
D | stm32mp_clkfunc.c | 49 cuint = fdt_getprop(fdt, subnode, "clock-frequency", in fdt_osc_read_freq() 104 if (fdt_getprop(fdt, subnode, prop_name, NULL) != NULL) { in fdt_osc_read_bool() 242 cuint = fdt_getprop(fdt, node, prop_name, &len); in fdt_rcc_read_prop() 286 cuint = fdt_getprop(fdt, node, "clocks", NULL); in fdt_get_clock_id()
|
/external/arm-trusted-firmware/drivers/st/mmc/ |
D | stm32_sdmmc2.c | 643 cuint = fdt_getprop(fdt, sdmmc_node, "reg", NULL); in stm32_sdmmc2_dt_get_config() 668 cuint = fdt_getprop(fdt, sdmmc_node, "clocks", NULL); in stm32_sdmmc2_dt_get_config() 676 cuint = fdt_getprop(fdt, sdmmc_node, "resets", NULL); in stm32_sdmmc2_dt_get_config() 684 if ((fdt_getprop(fdt, sdmmc_node, "st,use-ckin", NULL)) != NULL) { in stm32_sdmmc2_dt_get_config() 688 if ((fdt_getprop(fdt, sdmmc_node, "st,sig-dir", NULL)) != NULL) { in stm32_sdmmc2_dt_get_config() 692 if ((fdt_getprop(fdt, sdmmc_node, "st,neg-edge", NULL)) != NULL) { in stm32_sdmmc2_dt_get_config() 696 cuint = fdt_getprop(fdt, sdmmc_node, "bus-width", NULL); in stm32_sdmmc2_dt_get_config() 712 cuint = fdt_getprop(fdt, sdmmc_node, "max-frequency", NULL); in stm32_sdmmc2_dt_get_config()
|
/external/dtc/libfdt/ |
D | fdt_ro.c | 500 const void *fdt_getprop(const void *fdt, int nodeoffset, in fdt_getprop() function 513 php = fdt_getprop(fdt, nodeoffset, "phandle", &len); in fdt_get_phandle() 515 php = fdt_getprop(fdt, nodeoffset, "linux,phandle", &len); in fdt_get_phandle() 670 val = fdt_getprop(fdt, offset, propname, &len); in fdt_node_offset_by_prop_value() 726 list = fdt_getprop(fdt, nodeoffset, property, &length); in fdt_stringlist_count() 752 list = fdt_getprop(fdt, nodeoffset, property, &length); in fdt_stringlist_search() 783 list = fdt_getprop(fdt, nodeoffset, property, &length); in fdt_stringlist_get() 827 prop = fdt_getprop(fdt, nodeoffset, "compatible", &len); in fdt_node_check_compatible()
|
D | fdt_overlay.c | 33 val = fdt_getprop(fdto, fragment, "target", &len); in overlay_get_target_phandle() 73 path = fdt_getprop(fdto, fragment, "target-path", &path_len); in overlay_get_target() 123 val = fdt_getprop(fdt, node, name, &len); in overlay_phandle_add_offset() 245 tree_val = fdt_getprop(fdto, tree_node, name, &tree_len); in overlay_update_local_node_references() 382 symbol_path = fdt_getprop(fdt, symbols_off, label, in overlay_fixup_one_phandle()
|
D | version.lds | 18 fdt_getprop;
|
D | fdt_wip.c | 39 propval = fdt_getprop(fdt, nodeoffset, name, &proplen); in fdt_setprop_inplace()
|
D | fdt_addresses.c | 20 c = fdt_getprop(fdt, nodeoffset, name, &len); in fdt_cells()
|
/external/arm-trusted-firmware/drivers/st/iwdg/ |
D | stm32_iwdg.c | 100 if (fdt_getprop(fdt, node, "stm32,enable-on-stop", NULL) == in stm32_iwdg_init() 105 if (fdt_getprop(fdt, node, "stm32,enable-on-standby", NULL) == in stm32_iwdg_init()
|
/external/arm-trusted-firmware/common/ |
D | fdt_wrappers.c | 34 prop = fdt_getprop(dtb, node, prop_name, &value_len); in fdt_read_uint32_array() 259 prop = fdt_getprop(dtb, node, "reg", &len); in fdt_get_reg_props_by_index() 318 prop = fdt_getprop(dtb, node, "stdout-path", NULL); in fdt_get_stdout_node_offset()
|
D | fdt_fixup.c | 119 prop = fdt_getprop(fdt, offs, "device_type", &len); in dt_update_one_cpu_node() 126 prop = fdt_getprop(fdt, offs, "enable-method", &len); in dt_update_one_cpu_node()
|