Lines Matching refs:to

1 # This file allows user to override the factory
22 # Flag to allow STA send AddTspec even when ACM is Off
47 # Check if the AP to which we are roaming is better than current AP in
48 # terms of RSSI.  Checking is disabled if set to Zero.Otherwise it will
49 # use this value as to how better the RSSI of the new/roamable AP should
66 # Set gSetTxChainmask1x1=1 or gSetRxChainmask1x1=1 to select chain0.
67 # Set gSetTxChainmask1x1=2 or gSetRxChainmask1x1=2 to select chain1.
71 # MCC to SCC Switch mode:
132 # to disable set it to zero. ssdp = 0
141 # 0 to disable, 1 to enable, default: 1
145 # 0 to disable, 1 to enable
155 # Inactivity time (in ms) to end TX Service Period while in IBSS power save mode
182 # This ini is used to configure the number of Tx/Rx packets during the period of
187 # This ini is used to configure the number of Tx/Rx packet, below which
229 # LRO and GRO are exclusive to each other
238 # Enable flow steering to enable multiple CEs for Rx flows.
247 #Maximum number of HTT messages to be processed per NAPI poll
289 # Use this configuration to blanket drop broadcast/multicast packets at the hardware level
292 # Takes a bitmap of frame types to drop
301 # This ini is used to set default snr monitor
304 # Control to enable TCP limit output byte
305 # This ini is used to enable dynamic configuration of TCP limit output bytes
307 # Enabling this will let driver post message to cnss-daemon,
312 # This ini is used to enable or disable TWT support.
319 # Force 1x1 when connecting to certain peer
324 # This ini is used to enable/disable oce feature for STA
328 # This ini is used to enable/disable oce feature for SAP
335 # This ini is used to set probe request rate to 5.5Mbps as per OCE requirement in 2.4G band
341 # HE caps Weightage to calculate best candidate
342 # This ini is used to increase/decrease HE caps weightage in best candidate selection.
347 # PCL Weightage to calculate best candidate
348 # This ini is used to increase/decrease PCL weightage in best candidate selection.
353 # This ini is used to enable/disable ESP(Estimated service parameters) IE parsing and decides
357 # Bitmask to enable 11k offload to FW.
358 # This ini is used to set which of the 11k features is offloaded to FW
364 # Set channel selection logic for different concurrency combinations to DBS or inter band MCC.
375 # Bit 0: Enable/Disable the BTM offload. Set this to 1 will enable and 0 will disable BTM offload.
378 #           Based on below config firmware will decide whether to forward BTM frame to host or
379 #           consume with firmware and proceed with Roaming to candidate AP.
382 #           01 no scan and forward to host
388 # BIT 6: Set this to 1 will send BTM query frame and 0 not sent.
398 # Set external ACS Policy to Mandatory
438 # Enable or disable Probe Req Information Element whitelist. When enabled, IEs corresponding to bits
457 # Used to specify vendor specific OUIs
497 # Enable/Disable conversion from SARV1 to SARV2
500 #This ini is used to enable/disable ESE feature
510 # Used to specify action OUIs to reconnect when assoc timeout
513 # Limit to send request to the firmware at most once in a second
516 # This ini is used to enable/disable the HW assist feature in FW