Lines Matching refs:to

1 # This file allows user to override the factory
22 # Flag to allow STA send AddTspec even when ACM is Off
47 # Check if the AP to which we are roaming is better than current AP in
48 # terms of RSSI.  Checking is disabled if set to Zero.Otherwise it will
49 # use this value as to how better the RSSI of the new/roamable AP should
65 # Set gSetTxChainmask1x1=1 or gSetRxChainmask1x1=1 to select chain0.
66 # Set gSetTxChainmask1x1=2 or gSetRxChainmask1x1=2 to select chain1.
70 # MCC to SCC Switch mode:
125 # to disable set it to zero. ssdp = 0
134 # 0 to disable, 1 to enable, default: 1
138 # 0 to disable, 1 to enable
148 # Inactivity time (in ms) to end TX Service Period while in IBSS power save mode
175 # This ini is used to configure the number of Tx/Rx packets during the period of
180 # This ini is used to configure the number of Tx/Rx packet, below which
222 # LRO and GRO are exclusive to each other
231 # Enable flow steering to enable multiple CEs for Rx flows.
240 #Maximum number of HTT messages to be processed per NAPI poll
282 # Use this configuration to blanket drop broadcast/multicast packets at the hardware level
285 # Takes a bitmap of frame types to drop
294 # This ini is used to set default snr monitor
297 # Control to enable TCP limit output byte
298 # This ini is used to enable dynamic configuration of TCP limit output bytes
300 # Enabling this will let driver post message to cnss-daemon,
305 # This ini is used to enable or disable TWT support.
312 # Force 1x1 when connecting to certain peer
317 # This ini is used to enable/disable oce feature for STA
321 # This ini is used to enable/disable oce feature for SAP
325 # This ini is used to set probe request rate to 5.5Mbps as per OCE requirement in 2.4G band
328 # HE caps Weightage to calculate best candidate
329 # This ini is used to increase/decrease HE caps weightage in best candidate selection.
334 # PCL Weightage to calculate best candidate
335 # This ini is used to increase/decrease PCL weightage in best candidate selection.
340 # This ini is used to enable/disable ESP(Estimated service parameters) IE parsing and decides
344 # Bitmask to enable 11k offload to FW.
345 # This ini is used to set which of the 11k features is offloaded to FW
351 # Set channel selection logic for different concurrency combinations to DBS or inter band MCC.
362 # Bit 0: Enable/Disable the BTM offload. Set this to 1 will enable and 0 will disable BTM offload.
365 #           Based on below config firmware will decide whether to forward BTM frame to host or
366 #           consume with firmware and proceed with Roaming to candidate AP.
369 #           01 no scan and forward to host
375 # BIT 6: Set this to 1 will send BTM query frame and 0 not sent.
382 # Set external ACS Policy to Mandatory
422 # Enable or disable Probe Req Information Element whitelist. When enabled, IEs corresponding to bits
441 # Used to specify vendor specific OUIs