Lines Matching full:phone

37     # Time in seconds to wait for the phone to settle
41     # Default time in seconds to wait for the phone to attach to the basestation
159         # Enable roaming on the phone
162         # Make sure airplane mode is on so the phone won't attach right away
177         """ Attach the phone to the basestation.
180         and waits for the phone to attach.
183             True if the phone was able to attach, False if not.
193         # Provide a good signal power for the phone to attach easily
200         # Try to attach the phone.
208                 # Wait for the phone to attach.
213                 # The phone failed to attach
218                 # Turn airplane mode on to prepare the phone for a retry.
232                 # The phone attached successfully.
241         """ Detach the phone from the basestation.
258         """  Detach phone from the basestation by stopping the simulation.
274         """ Start the simulation by attaching the phone and setting the
466                         "Cannot achieve phone DL Rx power of {} dBm. Requested TX "
475                     "Requested phone DL Rx power of {} dBm, setting callbox Tx "
480                     "Phone downlink received power is {0:.2f} dBm".format(
484             self.log.info("Phone downlink received power set to {} (link is "
515                         "Cannot achieve phone UL Tx power of {} dBm. Requested UL "
524                     "Requested phone UL Tx power of {} dBm, setting callbox Rx "
529                     "Phone uplink transmitted power is {0:.2f} dBm".format(
533             self.log.info("Phone uplink transmitted power set to {} (link is "
550         # Attach the phone to the base station
553                     "Skipping calibration because the phone failed to attach.")
570             configured in the phone.
588                 the phone)
590                 reported by the phone to dBm. needs to take two arguments: the
602                     "reported by the phone.")
712         # Phone only supports 1x1 Uplink so always chain 0