Lines Matching full:freebsd

3 The FreeBSD port of sg3_utils contains those utilities that are _not_
4 specific to Linux. In some cases the FreeBSD camcontrol command supplies
11 for FreeBSD.
84 hopefully will not confuse the FreeBSD users.
88 In FreeBSD disks have block names like '/dev/da0' with a corresponding
93 FreeBSD is relatively unique in this respect and support for this
103 has for CAM devices. In FreeBSD release 12 the nda driver was
109 FreeBSD installation
112 top level of the unpacked tarball will work on FreeBSD. But the man pages
119 FreeBSD 9.0 has a "ports" entry for sg3_utils under the
144 The sg_pt_freebsd.c file uses the FreeBSD CAM SCSI pass through mechanism.
145 Hence only FreeBSD device nodes that support CAM can be used. These can be
151 and larger failed on a FreeBSD 7.0 with an "argument list too long" error
154 DFLTPHYS(65536). Still a problem in FreeBSD 8.1 . Due to CAM overhead the
158 FreeBSD 9.0 is the most recent version of FreeBSD tested with these