Lines Matching refs:authentication
22 fix wired IEEE 802.1X authentication
87 * fixed FT (IEEE 802.11r) authentication after a failed association to
89 * added support for configuring Phase 2 (inner/tunneled) authentication
177 only shared key/password authentication is supported in this version
221 * added support for EAP-FAST authentication with inner methods that
273 * added support for matching the subjectAltName of the authentication
276 * fixed EAP-SIM/AKA key derivation for re-authentication case (only
380 at the end of RSN pre-authentication and added unregistration of
442 * fixed EAPOL re-authentication for sessions that used PMKSA caching
447 * fixed a memory leak in EAP-TTLS re-authentication
465 * fixed TLS library deinitialization after RSN pre-authentication not
466 to disable TLS library for normal authentication
483 * fixed EAP-SIM and EAP-AKA pseudonym and fast re-authentication to
511 EAP-AKA authentication using SIM/USIM card under Windows
524 RC4-128-SHA for authentication and AES128-SHA for provisioning
548 * l2_packet_pcap: fixed wired IEEE 802.1X authentication with libpcap
550 * disable EAP state machine when IEEE 802.1X authentication is not used
581 * fixed RSN pre-authentication (it was broken in the clean up of WPA
607 authentication for the most common case of Authenticator starting
608 EAP authentication immediately after association
677 PEAPv0 since at least one RADIUS authentication server seems to be
701 * fixed a potential issue in RSN pre-authentication ending up using
702 freed memory if pre-authentication times out
704 authentication server certificate; new configuration variables
706 * driver_ndis: added support for IEEE 802.1X authentication with wired
738 authentication session
770 * added support for wired authentication (IEEE 802.1X on wired
779 interoperate with some authentication servers
795 wpa_supplicant events, e.g., when authentication has been completed
813 authentication servers
834 * fixed non-WPA IEEE 802.1X to use the same authentication timeout as
840 RSN pre-authentication; previously these were disabled and
841 pre-authentication would fail if the used authentication server
844 authentication in ap_scan=1 mode so that all APs are tried in cases
845 where the ones with strongest signal level are failing authentication
847 authentication attempt
849 in the previous authentication (previously, only Phase 1 success was
881 could cause a segfault when RSN pre-authentication was completed
887 authentication in case of failed PMKSA caching attempt
902 problems with new authentication getting ignored because of state
911 authentication
941 easier for drivers to configure authentication algorithm as part of
952 * PEAPv1: added support for terminating PEAP authentication on tunneled
965 * added support for configuring IEEE 802.11 authentication algorithm
966 (auth_alg; mainly for using Shared Key authentication with static
971 * added support for EAP-SIM pseudonyms and fast re-authentication
972 * added support for EAP-TLS/PEAP/TTLS fast re-authentication (TLS
980 * added support for matching subject of the authentication server
1047 re-authentication by allowing unencrypted EAPOL frames when not using
1062 * added support for new EAP authentication methods:
1074 information so that full authentication does not need to be
1097 * improved scan requesting and authentication timeout
1109 * added GSM SIM/USIM interface for GSM authentication algorithm for
1119 * added support for new EAP authentication methods:
1132 EAP-SIM (not yet complete; needs GSM/SIM authentication interface)
1141 * improved RSN pre-authentication to use a candidate list and process
1176 (i.e., complete IEEE 802.1X/EAP authentication and use IEEE 802.1X
1180 - PMKSA caching, pre-authentication