Home
last modified time | relevance | path

Searched defs:result (Results 1 – 25 of 66) sorted by relevance

123

/hardware/invensense/mlsdk/mllite/
Dmlarray.c121 inv_error_t result = INV_SUCCESS; in inv_get_rot_mat() local
286 inv_error_t result = INV_SUCCESS; in inv_get_euler_angles_x() local
344 inv_error_t result = INV_SUCCESS; in inv_get_euler_angles_y() local
402 inv_error_t result = INV_SUCCESS; in inv_get_euler_angles_z() local
453 inv_error_t result = INV_SUCCESS; in inv_get_gyro_temp_slope() local
488 inv_error_t result = INV_SUCCESS; in inv_get_gyro_bias() local
518 inv_error_t result = INV_SUCCESS; in inv_get_accel_bias() local
549 inv_error_t result = INV_SUCCESS; in inv_get_mag_bias() local
611 inv_error_t result = INV_SUCCESS; in inv_get_mag_raw_data() local
643 inv_error_t result = INV_SUCCESS; in inv_get_magnetometer() local
[all …]
DmlBiasNoMotion.c79 inv_error_t result; in inv_turn_on_bias_from_no_motion() local
90 inv_error_t result; in inv_turn_off_bias_from_no_motion() local
101 inv_error_t result; in inv_update_bias() local
159 inv_error_t result; in MLAccelMotionDetection() local
227 inv_error_t result; in MLPollMotionStatus() local
363 inv_error_t result; in inv_enable_bias_no_motion() local
381 inv_error_t result; in inv_disable_bias_no_motion() local
Dmldl.c197 inv_error_t result; in inv_dl_open() local
222 inv_error_t result = INV_SUCCESS; in inv_dl_close() local
306 inv_error_t result = INV_SUCCESS; in inv_dl_start() local
349 inv_error_t result = INV_SUCCESS; in inv_dl_stop() local
423 inv_error_t result = INV_SUCCESS; in inv_get_dl_cfg_int() local
613 inv_error_t result; in inv_set_offsetTC() local
684 inv_error_t result; in inv_set_offset() local
735 inv_error_t result; in inv_get_mpu_memory_one_bank() local
781 inv_error_t result = INV_SUCCESS; in inv_set_mpu_memory_one_bank() local
826 inv_error_t result; in inv_get_mpu_memory() local
[all …]
Dml.c128 inv_error_t result; in inv_serial_start() local
157 inv_error_t result = INV_SUCCESS; in inv_serial_stop() local
198 inv_error_t result; in inv_apply_calibration() local
446 inv_error_t result; in inv_reset_motion() local
529 inv_error_t result = INV_SUCCESS; in inv_update_data() local
617 inv_error_t result; in inv_set_motion_interrupt() local
664 inv_error_t result; in inv_set_fifo_interrupt() local
767 inv_error_t result; in inv_set_accel_calibration() local
913 inv_error_t result; in inv_set_gyro_calibration() local
1110 inv_error_t result; in inv_set_dead_zone() local
[all …]
Dmlarray_legacy.c90 inv_error_t result; in inv_get_array() local
388 inv_error_t result; in inv_get_float_array() local
510 inv_error_t result; in inv_set_array() local
560 inv_error_t result; in inv_set_float_array() local
DmlFIFO.c234 inv_error_t result; in inv_construct3_fifo() local
266 int result; in inv_set_footer() local
465 inv_error_t result = INV_SUCCESS; in inv_state_change_fifo() local
525 inv_error_t result; in inv_init_fifo_param() local
551 inv_error_t result; in inv_close_fifo() local
596 inv_error_t result = INV_SUCCESS; in inv_read_and_process_fifo() local
791 inv_error_t result; in inv_get_temperature_raw() local
820 inv_error_t result; in inv_get_temperature() local
889 inv_error_t result; in inv_get_gyro_sensor() local
994 inv_error_t result; in inv_send_accel() local
[all …]
Dmldmp.c80 inv_error_t result; in inv_dmp_open() local
177 inv_error_t result; in inv_dmp_start() local
214 inv_error_t result; in inv_dmp_stop() local
256 inv_error_t result; in inv_dmp_close() local
Dmldl_cfg_mpu.c212 int result; in inv_mpu_open() local
245 int result = INV_SUCCESS; in inv_mpu_close() local
259 int result; in inv_mpu_resume() local
290 int result; in inv_mpu_suspend() local
338 int result; in inv_mpu_slave_read() local
382 int result; in inv_mpu_slave_config() local
441 int result; in inv_mpu_get_slave_config() local
Dmlstates.c76 inv_error_t result; in MLStateCloseCallbacks() local
120 inv_error_t result = INV_SUCCESS; in inv_state_transition() local
179 inv_error_t result; in inv_register_state_callback() local
222 inv_error_t result; in inv_unregister_state_callback() local
250 inv_error_t result; in inv_run_state_callbacks() local
DmlSetGyroBias.c113 inv_error_t result; in inv_set_gyro_bias_in_dps() local
134 inv_error_t result; in inv_set_gyro_bias_in_dps_float() local
145 inv_error_t result = INV_SUCCESS; in MLSetGyroBiasCB() local
180 inv_error_t result; in inv_enable_set_bias() local
195 inv_error_t result; in inv_disable_set_bias() local
Dcompass.c266 inv_error_t result; in inv_get_compass_data() local
366 inv_error_t result = INV_SUCCESS; in inv_set_compass_bias() local
421 inv_error_t result; in inv_compass_write_reg() local
455 inv_error_t result; in inv_compass_read_reg() local
489 inv_error_t result; in inv_compass_read_scale() local
513 inv_error_t result; in inv_set_compass_offset() local
555 inv_error_t result; in inv_compass_check_range() local
DmlFIFOHW.c114 inv_error_t result; in inv_get_fifo() local
208 inv_error_t result; in inv_get_fifo_length() local
253 inv_error_t result; in inv_read_fifo() local
279 inv_error_t result; in inv_reset_fifo() local
Dmlcontrol.c120 inv_error_t result; in inv_set_control_sensitivity() local
210 inv_error_t result; in inv_set_control_func() local
522 inv_error_t result; in inv_set_control_data() local
Dml_mputest.c101 inv_error_t result; in inv_self_test_factory_calibrate() local
/hardware/qcom/media/mm-video/vidc/venc/test/
Dcamera_test.cpp40 int result = 0; in CameraTest_Initialize() local
56 int result = 0; in CameraTest_Run() local
68 int result = 0; in CameraTest_ReleaseFrame() local
80 int result = 0; in CameraTest_Exit() local
Dvenc_test.cpp74 #define CHK(result) if (result != OMX_ErrorNone) { E("*************** error *************"); exit(0… argument
342 OMX_ERRORTYPE result = OMX_ErrorNone; in ConfigureEncoder() local
740 OMX_ERRORTYPE result = OMX_ErrorNone; in VencTest_Initialize() local
789 OMX_ERRORTYPE result = OMX_ErrorNone; in VencTest_RegisterYUVBuffer() local
824 OMX_ERRORTYPE result = OMX_ErrorUndefined; in VencTest_EncodeFrame() local
847 OMX_ERRORTYPE result = OMX_ErrorNone; in VencTest_Exit() local
913 OMX_ERRORTYPE result = OMX_ErrorNone; in VencTest_ReadAndEmpty() local
972 OMX_ERRORTYPE result; in PreviewCallback() local
1277 int result; in main() local
/hardware/invensense/mlsdk/platform/linux/
Dmlsl_linux_mpu.c160 inv_error_t result = INV_SUCCESS; in inv_serial_read_cal() local
191 inv_error_t result = INV_SUCCESS; in inv_serial_write_cal() local
284 inv_error_t result; in inv_serial_write() local
320 int result = INV_SUCCESS; in inv_serial_read() local
360 int result; in inv_serial_write_mem() local
392 int result; in inv_serial_read_mem() local
428 int result; in inv_serial_write_fifo() local
464 int result; in inv_serial_read_fifo() local
Dlog_linux.c48 int result; in _MLPrintLog() local
59 int result; in _MLPrintVaLog() local
/hardware/msm7k/libgralloc-qsd8k/tests/
Dpmemalloc_test.cpp130 int result = pma.init_pmem_area_locked(); in TEST() local
175 int result = pma.init_pmem_area_locked(); in TEST() local
201 int result = pma.init_pmem_area_locked(); in TEST() local
226 int result = pma.init_pmem_area_locked(); in TEST() local
239 int result = pma.init_pmem_area(); in TEST() local
252 int result = pma.init_pmem_area(); in TEST() local
265 int result = pma.init_pmem_area(); in TEST() local
279 int result = pma.init_pmem_area(); in TEST() local
330 int result = pma.alloc_pmem_buffer(size, flags, &base, &offset, &fd); in TEST() local
357 int result = pma.alloc_pmem_buffer(size, flags, &base, &offset, &fd); in TEST() local
[all …]
/hardware/invensense/mlsdk/mlutils/
Dmputest.c322 inv_error_t result; in inv_test_gyro_3050() local
572 inv_error_t result; in inv_test_gyro_6050() local
790 inv_error_t result; in test_get_mpu_id() local
974 inv_error_t result; in inv_device_power_mgmt() local
1110 int result = 0; in inv_mpu_test() local
1275 int result; in inv_factory_calibrate() local
1342 inv_error_t result; in test_get_data() local
/hardware/ril/mock-ril/src/cpp/
Dresponses.cpp75 const char **result = (const char **)alloca(result_len); in RspStrings() local
100 const char *result = rsp->strings(0).c_str(); in RspString() local
119 int32_t *result = (int32_t *)alloca(result_len); in RspIntegers() local
200 RIL_Call **result = (RIL_Call **)alloca(result_len); in RspGetCurrentCalls() local
321 const char *result[3] = { NULL, NULL, NULL }; in RspOperator() local
/hardware/libhardware_legacy/audio/
DAudioHardwareStub.cpp103 String8 result; in dumpInternals() local
144 String8 result; in dump() local
186 String8 result; in dump() local
DAudioHardwareGeneric.cpp170 String8 result; in dumpInternals() local
249 String8 result; in dump() local
357 String8 result; in dump() local
/hardware/qcom/media/mm-video/vidc/vdec/test/
Domx_vdec_test.cpp95 #define FAILED(result) (result != OMX_ErrorNone) argument
97 #define SUCCEEDED(result) (result == OMX_ErrorNone) argument
627 OMX_ERRORTYPE result; in EmptyBufferDone() local
689 OMX_ERRORTYPE result; in main() local
1197 OMX_ERRORTYPE result = OMX_FreeHandle(dec_handle); in run_tests() local
1815 OMX_ERRORTYPE result = OMX_FreeHandle(dec_handle); in do_freeHandle_and_clean_up() local
2275 int result; in drawBG() local
/hardware/qcom/gps/loc_api/libloc_api-rpc/gen-3200/
Dloc_api_cb_svc.c27 } result; in loc_apicbprog_0x00010001() local

123