| /hardware/invensense/mlsdk/mllite/ |
| D | mlarray.c | 121 inv_error_t result = INV_SUCCESS; in inv_get_rot_mat() local
286 inv_error_t result = INV_SUCCESS; in inv_get_euler_angles_x() local
344 inv_error_t result = INV_SUCCESS; in inv_get_euler_angles_y() local
402 inv_error_t result = INV_SUCCESS; in inv_get_euler_angles_z() local
453 inv_error_t result = INV_SUCCESS; in inv_get_gyro_temp_slope() local
488 inv_error_t result = INV_SUCCESS; in inv_get_gyro_bias() local
518 inv_error_t result = INV_SUCCESS; in inv_get_accel_bias() local
549 inv_error_t result = INV_SUCCESS; in inv_get_mag_bias() local
611 inv_error_t result = INV_SUCCESS; in inv_get_mag_raw_data() local
643 inv_error_t result = INV_SUCCESS; in inv_get_magnetometer() local
[all …]
|
| D | mlBiasNoMotion.c | 79 inv_error_t result; in inv_turn_on_bias_from_no_motion() local
90 inv_error_t result; in inv_turn_off_bias_from_no_motion() local
101 inv_error_t result; in inv_update_bias() local
159 inv_error_t result; in MLAccelMotionDetection() local
227 inv_error_t result; in MLPollMotionStatus() local
363 inv_error_t result; in inv_enable_bias_no_motion() local
381 inv_error_t result; in inv_disable_bias_no_motion() local
|
| D | mldl.c | 197 inv_error_t result; in inv_dl_open() local
222 inv_error_t result = INV_SUCCESS; in inv_dl_close() local
306 inv_error_t result = INV_SUCCESS; in inv_dl_start() local
349 inv_error_t result = INV_SUCCESS; in inv_dl_stop() local
423 inv_error_t result = INV_SUCCESS; in inv_get_dl_cfg_int() local
613 inv_error_t result; in inv_set_offsetTC() local
684 inv_error_t result; in inv_set_offset() local
735 inv_error_t result; in inv_get_mpu_memory_one_bank() local
781 inv_error_t result = INV_SUCCESS; in inv_set_mpu_memory_one_bank() local
826 inv_error_t result; in inv_get_mpu_memory() local
[all …]
|
| D | mlarray_legacy.c | 90 inv_error_t result; in inv_get_array() local
388 inv_error_t result; in inv_get_float_array() local
510 inv_error_t result; in inv_set_array() local
560 inv_error_t result; in inv_set_float_array() local
|
| D | ml.c | 128 inv_error_t result; in inv_serial_start() local
157 inv_error_t result = INV_SUCCESS; in inv_serial_stop() local
198 inv_error_t result; in inv_apply_calibration() local
457 inv_error_t result; in inv_reset_motion() local
540 inv_error_t result = INV_SUCCESS; in inv_update_data() local
628 inv_error_t result; in inv_set_motion_interrupt() local
675 inv_error_t result; in inv_set_fifo_interrupt() local
778 inv_error_t result; in inv_set_accel_calibration() local
924 inv_error_t result; in inv_set_gyro_calibration() local
1121 inv_error_t result; in inv_set_dead_zone() local
[all …]
|
| D | mlFIFO.c | 234 inv_error_t result; in inv_construct3_fifo() local
266 int result; in inv_set_footer() local
465 inv_error_t result = INV_SUCCESS; in inv_state_change_fifo() local
525 inv_error_t result; in inv_init_fifo_param() local
551 inv_error_t result; in inv_close_fifo() local
596 inv_error_t result = INV_SUCCESS; in inv_read_and_process_fifo() local
791 inv_error_t result; in inv_get_temperature_raw() local
820 inv_error_t result; in inv_get_temperature() local
889 inv_error_t result; in inv_get_gyro_sensor() local
994 inv_error_t result; in inv_send_accel() local
[all …]
|
| D | mldmp.c | 80 inv_error_t result; in inv_dmp_open() local
179 inv_error_t result; in inv_dmp_start() local
216 inv_error_t result; in inv_dmp_stop() local
258 inv_error_t result; in inv_dmp_close() local
|
| D | mldl_cfg_mpu.c | 212 int result; in inv_mpu_open() local
245 int result = INV_SUCCESS; in inv_mpu_close() local
259 int result; in inv_mpu_resume() local
290 int result; in inv_mpu_suspend() local
338 int result; in inv_mpu_slave_read() local
382 int result; in inv_mpu_slave_config() local
441 int result; in inv_mpu_get_slave_config() local
|
| D | mlstates.c | 76 inv_error_t result; in MLStateCloseCallbacks() local
120 inv_error_t result = INV_SUCCESS; in inv_state_transition() local
179 inv_error_t result; in inv_register_state_callback() local
222 inv_error_t result; in inv_unregister_state_callback() local
250 inv_error_t result; in inv_run_state_callbacks() local
|
| D | mlSetGyroBias.c | 113 inv_error_t result; in inv_set_gyro_bias_in_dps() local
134 inv_error_t result; in inv_set_gyro_bias_in_dps_float() local
145 inv_error_t result = INV_SUCCESS; in MLSetGyroBiasCB() local
180 inv_error_t result; in inv_enable_set_bias() local
195 inv_error_t result; in inv_disable_set_bias() local
|
| D | compass.c | 266 inv_error_t result; in inv_get_compass_data() local
366 inv_error_t result = INV_SUCCESS; in inv_set_compass_bias() local
421 inv_error_t result; in inv_compass_write_reg() local
455 inv_error_t result; in inv_compass_read_reg() local
489 inv_error_t result; in inv_compass_read_scale() local
513 inv_error_t result; in inv_set_compass_offset() local
555 inv_error_t result; in inv_compass_check_range() local
|
| D | mlFIFOHW.c | 114 inv_error_t result; in inv_get_fifo() local
208 inv_error_t result; in inv_get_fifo_length() local
253 inv_error_t result; in inv_read_fifo() local
279 inv_error_t result; in inv_reset_fifo() local
|
| /hardware/qcom/gps/loc_api/libloc_api_50001/ |
| D | loc_eng_dmn_conn_thread_helper.c | 54 int result; in thelper_signal_init() local
89 int result, ret_result = 0; in thelper_signal_destroy() local
124 int result = 0; in thelper_signal_wait() local
159 int result; in thelper_signal_ready() local
191 int result = thelper->thread_ready; in thelper_signal_block() local
222 int result = 0; in thelper_main() local
304 int result; in loc_eng_dmn_conn_launch_thelper() local
385 int result; in loc_eng_dmn_conn_join_thelper() local
|
| D | loc_eng_dmn_conn_glue_pipe.c | 64 int result; in loc_eng_dmn_conn_glue_pipeget() local
132 int result; in loc_eng_dmn_conn_glue_pipewrite() local
194 int result; in loc_eng_dmn_conn_glue_pipeunblock() local
|
| D | loc_eng_dmn_conn_glue_msg.c | 86 int result; in loc_eng_dmn_conn_glue_msgremove() local
113 int result; in loc_eng_dmn_conn_glue_msgsnd() local
148 int result; in loc_eng_dmn_conn_glue_msgrcv() local
|
| /hardware/qcom/media/mm-video/vidc/venc/test/ |
| D | camera_test.cpp | 40 int result = 0; in CameraTest_Initialize() local
56 int result = 0; in CameraTest_Run() local
68 int result = 0; in CameraTest_ReleaseFrame() local
80 int result = 0; in CameraTest_Exit() local
|
| /hardware/ti/wlan/wl1271/CUDK/os/linux/src/ |
| D | os_trans.c | 68 TI_SIZE_T result; in os_bind() local
91 TI_SIZE_T result; in os_sockWaitForConnection() local
127 TI_SIZE_T result; in os_sockSend() local
153 TI_SIZE_T result; in os_sockRecv() local
|
| /hardware/invensense/libsensors_iio/software/core/mllite/linux/ |
| D | ml_stored_data.c | 44 inv_error_t result = INV_SUCCESS; in inv_read_cal() local
86 inv_error_t result = INV_SUCCESS; in inv_write_cal() local
139 inv_error_t result; in inv_load_cal_V0() local
279 inv_error_t result = 0; in inv_load_calibration() local
314 inv_error_t result; in inv_store_calibration() local
|
| D | ml_load_dmp.c | 247 inv_error_t result = INV_SUCCESS; in inv_write_dmp_data() local
272 inv_error_t result = INV_SUCCESS; in inv_load_dmp() local
|
| /hardware/invensense/mlsdk/platform/linux/ |
| D | mlsl_linux_mpu.c | 160 inv_error_t result = INV_SUCCESS; in inv_serial_read_cal() local
191 inv_error_t result = INV_SUCCESS; in inv_serial_write_cal() local
284 inv_error_t result; in inv_serial_write() local
320 int result = INV_SUCCESS; in inv_serial_read() local
360 int result; in inv_serial_write_mem() local
392 int result; in inv_serial_read_mem() local
428 int result; in inv_serial_write_fifo() local
464 int result; in inv_serial_read_fifo() local
|
| /hardware/msm7k/libgralloc-qsd8k/tests/ |
| D | pmemalloc_test.cpp | 130 int result = pma.init_pmem_area_locked(); in TEST() local
175 int result = pma.init_pmem_area_locked(); in TEST() local
201 int result = pma.init_pmem_area_locked(); in TEST() local
226 int result = pma.init_pmem_area_locked(); in TEST() local
239 int result = pma.init_pmem_area(); in TEST() local
252 int result = pma.init_pmem_area(); in TEST() local
265 int result = pma.init_pmem_area(); in TEST() local
279 int result = pma.init_pmem_area(); in TEST() local
330 int result = pma.alloc_pmem_buffer(size, flags, &base, &offset, &fd); in TEST() local
357 int result = pma.alloc_pmem_buffer(size, flags, &base, &offset, &fd); in TEST() local
[all …]
|
| /hardware/qcom/gps/loc_api/libloc_api-rpc-50001/libloc_api-rpc-stub/src/ |
| D | loc_api_rpcgen_cb_svc.c | 55 } result; in loc_apicbprog_0x00050001() local
102 } result; in loc_apicbprog_0x00050002() local
149 } result; in loc_apicbprog_0x00050003() local
196 } result; in loc_apicbprog_0x00050004() local
243 } result; in loc_apicbprog_0x00050005() local
290 } result; in loc_apicbprog_0x00050006() local
|
| /hardware/qcom/camera/QCamera/stack/mm-camera-test/src/ |
| D | mm_qcamera_unit_test.c | 52 int result = 0; in mm_app_tc_0() local
116 int result = 0; in mm_app_tc_1() local
178 int result = 0; in mm_app_tc_2() local
245 int result = 0; in mm_app_tc_3() local
|
| D | mm_qcamera_dual_test.c | 53 int result = 0; in mm_app_dtc_0() local
122 int result = 0; in mm_app_dtc_1() local
184 int result = 0; in mm_app_dtc_2() local
251 int result = 0; in mm_app_dtc_3() local
|
| /hardware/samsung_slsi/exynos5/exynos_omx/openmax/exynos_omx/osal/ |
| D | Exynos_OSAL_Mutex.c | 69 int result; in Exynos_OSAL_MutexLock() local
83 int result; in Exynos_OSAL_MutexUnlock() local
|