Lines Matching refs:_TPM_Init

102 …9.2     _TPM_Init.................................................................................…
752 …NOTE 2        The TPM may enter Failure mode during _TPM_Init processing, before TPM2_Startup(). S…
1332 9.2      _TPM_Init
1336 _TPM_Init initializes a TPM.
1341 NOTE 1           If the TPM performs self-tests after receiving _TPM_Init() and the TPM enters Fail…
1345 The means of signaling _TPM_Init shall be defined in the platform-specific specifications that defi…
1364      This function is used to process a _TPM_Init() indication.
1368  3   _TPM_Init(
1413 TPM2_Startup() is always preceded by _TPM_Init, which is the physical indication that TPM initializ…
1414 is necessary because of a system-wide reset. TPM2_Startup() is only valid after _TPM_Init. Addition…
1422 …          specific specification may allow t hese indications between _TPM_Init and TPM2_Startup().
1479 …NOTE 4           PCR may be initialized any time between _TPM_Init and the end of TPM2_Startup(). …
1928 TPM will remain in Failure mode until the next _TPM_Init.
15199 If lockoutRecovery is zero, then the recovery interval is a boot cycle (_TPM_Init followed by
15437 need to be reset (_TPM_Init and TPM2_Startup(TPM_SU_CLEAR)) before the new PCR settings take
15569 After a _TPM_Init, system software may not be able to resume the field upgrade that was in process
15575 after _TPM_Init matches either of those digests. If so, the firmware update process restarts and the
15591 commands until a _TPM_Init is received.
15595 …  manner, the TPM is able to indicate the digest of the next block. If a _TPM_Init occurs while the
15597 …not, then the TPM will not accept the original firmware until the next _TPM_Init when the TPM is in