45 #define PFX			DRV_NAME " "  macro
149 	DBG(PFX "%s: phy write timeout\n", hw->dev[port]->name);  in gm_phy_write()
153 	DBG(PFX "%s: phy I/O error\n", hw->dev[port]->name);  in gm_phy_write()
177 	DBG(PFX "%s: phy read timeout\n", hw->dev[port]->name);  in __gm_phy_read()
180 	DBG(PFX "%s: phy I/O error\n", hw->dev[port]->name);  in __gm_phy_read()
899 	DBGIO(PFX "queue %#x idx <- %d\n", q, idx);  in sky2_put_idx()
979 	DBG(PFX "%s: receiver stop failed\n", sky2->netdev->name);  in sky2_rx_stop()
1169 		DBG2(PFX "%s: ram buffer %dK\n", dev->name, ramsize);  in sky2_up()
1206 	DBGIO(PFX "%s: le bases: st %p [%x], rx %p [%x], tx %p [%x]\n",  in sky2_up()
1253 	DBGIO(PFX "%s: tx queued, slot %d, len %d\n", dev->name,  in sky2_xmit_frame()
1293 			DBGIO(PFX "%s: tx done %d\n", dev->name, idx);  in sky2_tx_complete()
1323 	DBG2(PFX "%s: disabling interface\n", dev->name);  in sky2_down()
1433 	DBG(PFX "%s: Link is up at %d Mbps, %s duplex, flow control %s\n",  in sky2_link_up()
1456 	DBG(PFX "%s: Link is down.\n", sky2->netdev->name);  in sky2_link_down()
1470 		DBG(PFX "%s: remote fault\n", sky2->netdev->name);  in sky2_autoneg_done()
1475 		DBG(PFX "%s: speed/duplex mismatch\n", sky2->netdev->name);  in sky2_autoneg_done()
1519 	DBGIO(PFX "%s: phy interrupt status 0x%x 0x%x\n",  in sky2_phy_intr()
1577 	DBGIO(PFX "%s: rx slot %d status 0x%x len %d\n",  in sky2_receive()
1611 	DBG2(PFX "%s: rx length error: status %#x length %d\n",  in sky2_receive()
1621 		DBG2(PFX "%s: FIFO overflow error\n", dev->name);  in sky2_receive()
1626 	DBG2(PFX "%s: rx error, status 0x%x length %d\n",  in sky2_receive()
1682 			DBG2(PFX "status OP_RXCHKS but checksum offloading disabled\n");  in sky2_status_intr()
1696 			DBG(PFX "unknown status opcode 0x%x\n", opcode);  in sky2_status_intr()
1714 	DBGIO(PFX "%s: hw error interrupt status 0x%x\n", dev->name, status);  in sky2_hw_error()
1717 		DBG(PFX "%s: ram data read parity error\n", dev->name);  in sky2_hw_error()
1723 		DBG(PFX "%s: ram data write parity error\n", dev->name);  in sky2_hw_error()
1728 		DBG(PFX "%s: MAC parity error\n", dev->name);  in sky2_hw_error()
1733 		DBG(PFX "%s: RX parity error\n", dev->name);  in sky2_hw_error()
1738 		DBG(PFX "%s: TCP segmentation error\n", dev->name);  in sky2_hw_error()
1758 		DBG(PFX "PCI hardware error (0x%x)\n", pci_err);  in sky2_hw_intr()
1773 		DBG(PFX "PCI-Express error (0x%x)\n", err);  in sky2_hw_intr()
1791 	DBGIO(PFX "%s: mac interrupt status 0x%x\n", dev->name, status);  in sky2_mac_intr()
1819 	DBG(PFX "%s: descriptor error q=%#x get=%d [%llx] last=%d put=%d should be %d\n",  in sky2_le_error()
1831 	DBG(PFX "error interrupt status=%#x\n", status);  in sky2_err_intr()
1906 		DBG(PFX "unknown chip ID!\n");  in sky2_mhz()
1954 			DBG(PFX "unsupported revision Yukon-EC rev A1\n");  in sky2_init()
1984 		DBG(PFX "unsupported chip type 0x%x\n", hw->chip_id);  in sky2_init()
2039 			DBG(PFX "ignoring stuck error report bit\n");  in sky2_reset()
2190 		DBG(PFX "etherdev alloc failed\n");  in sky2_init_netdev()
2220 	DBG2(PFX "%s: addr %s\n", dev->name, netdev_addr(dev));  in sky2_show_addr()
2280 		DBG(PFX "cannot allocate hardware struct\n");  in sky2_probe()
2288 		DBG(PFX "cannot map device registers\n");  in sky2_probe()
2304 	DBG2(PFX "Yukon-2 %s chip revision %d\n",  in sky2_probe()
2320 		DBG(PFX "cannot register net device\n");  in sky2_probe()
2333 			DBG(PFX "allocation for second device failed\n");  in sky2_probe()
2335 			DBG(PFX "register of second port failed (%d)\n", err);  in sky2_probe()