• Home
  • Line#
  • Scopes#
  • Navigate#
  • Raw
  • Download
1 #ifndef	_EPIC100_H_
2 # define _EPIC100_H_
3 
4 FILE_LICENCE ( GPL2_OR_LATER );
5 
6 #ifndef	PCI_VENDOR_SMC
7 # define PCI_VENDOR_SMC		0x10B8
8 #endif
9 
10 #ifndef	PCI_DEVICE_SMC_EPIC100
11 # define PCI_DEVICE_SMC_EPIC100	0x0005
12 #endif
13 
14 #define PCI_DEVICE_ID_NONE	0xFFFF
15 
16 /* Offsets to registers (using SMC names). */
17 enum epic100_registers {
18     COMMAND= 0,		/* Control Register */
19     INTSTAT= 4,		/* Interrupt Status */
20     INTMASK= 8,		/* Interrupt Mask */
21     GENCTL = 0x0C,	/* General Control */
22     NVCTL  = 0x10,	/* Non Volatile Control */
23     EECTL  = 0x14,	/* EEPROM Control  */
24     TEST   = 0x1C,	/* Test register: marked as reserved (see in source code) */
25     CRCCNT = 0x20,	/* CRC Error Counter */
26     ALICNT = 0x24,	/* Frame Alignment Error Counter */
27     MPCNT  = 0x28,	/* Missed Packet Counter */
28     MMCTL  = 0x30,	/* MII Management Interface Control */
29     MMDATA = 0x34,	/* MII Management Interface Data */
30     MIICFG = 0x38,	/* MII Configuration */
31     IPG    = 0x3C,	/* InterPacket Gap */
32     LAN0   = 0x40,	/* MAC address. (0x40-0x48) */
33     IDCHK  = 0x4C,	/* BoardID/ Checksum */
34     MC0    = 0x50,	/* Multicast filter table. (0x50-0x5c) */
35     RXCON  = 0x60,	/* Receive Control */
36     TXCON  = 0x70,	/* Transmit Control */
37     TXSTAT = 0x74,	/* Transmit Status */
38     PRCDAR = 0x84,	/* PCI Receive Current Descriptor Address */
39     PRSTAT = 0xA4,	/* PCI Receive DMA Status */
40     PRCPTHR= 0xB0,	/* PCI Receive Copy Threshold */
41     PTCDAR = 0xC4,	/* PCI Transmit Current Descriptor Address */
42     ETHTHR = 0xDC	/* Early Transmit Threshold */
43 };
44 
45 /* Command register (CR_) bits */
46 #define CR_STOP_RX		(0x00000001)
47 #define CR_START_RX		(0x00000002)
48 #define CR_QUEUE_TX		(0x00000004)
49 #define CR_QUEUE_RX		(0x00000008)
50 #define CR_NEXTFRAME		(0x00000010)
51 #define CR_STOP_TX_DMA		(0x00000020)
52 #define CR_STOP_RX_DMA		(0x00000040)
53 #define CR_TX_UGO		(0x00000080)
54 
55 /* Interrupt register bits. NI means No Interrupt generated */
56 
57 #define	INTR_RX_THR_STA		(0x00400000)	/* rx copy threshold status NI */
58 #define	INTR_RX_BUFF_EMPTY	(0x00200000)	/* rx buffers empty. NI */
59 #define	INTR_TX_IN_PROG		(0x00100000)	/* tx copy in progess. NI */
60 #define	INTR_RX_IN_PROG		(0x00080000)	/* rx copy in progress. NI */
61 #define	INTR_TXIDLE		(0x00040000)	/* tx idle. NI */
62 #define INTR_RXIDLE		(0x00020000)	/* rx idle. NI */
63 #define INTR_INTR_ACTIVE	(0x00010000)	/* Interrupt active. NI */
64 #define INTR_RX_STATUS_OK	(0x00008000)	/* rx status valid. NI */
65 #define INTR_PCI_TGT_ABT	(0x00004000)	/* PCI Target abort */
66 #define INTR_PCI_MASTER_ABT	(0x00002000)	/* PCI Master abort */
67 #define INTR_PCI_PARITY_ERR	(0x00001000)	/* PCI adress parity error */
68 #define INTR_PCI_DATA_ERR	(0x00000800)	/* PCI data parity error */
69 #define INTR_RX_THR_CROSSED	(0x00000400)	/* rx copy threshold crossed */
70 #define INTR_CNTFULL		(0x00000200)	/* Counter overflow */
71 #define INTR_TXUNDERRUN		(0x00000100)	/* tx underrun. */
72 #define INTR_TXEMPTY		(0x00000080)	/* tx queue empty */
73 #define INTR_TX_CH_COMPLETE	(0x00000040)	/* tx chain complete */
74 #define INTR_TXDONE		(0x00000020)	/* tx complete (w or w/o err) */
75 #define INTR_RXERROR		(0x00000010)	/* rx error (CRC) */
76 #define INTR_RXOVERFLOW		(0x00000008)	/* rx buffer overflow */
77 #define INTR_RX_QUEUE_EMPTY	(0x00000004)	/* rx queue empty. */
78 #define INTR_RXHEADER		(0x00000002)	/* header copy complete */
79 #define INTR_RXDONE		(0x00000001)	/* Receive copy complete */
80 
81 #define INTR_CLEARINTR		(0x00007FFF)
82 #define INTR_VALIDBITS		(0x007FFFFF)
83 #define INTR_DISABLE		(0x00000000)
84 #define INTR_CLEARERRS		(0x00007F18)
85 #define INTR_ABNINTR		(INTR_CNTFULL | INTR_TXUNDERRUN | INTR_RXOVERFLOW)
86 
87 /* General Control (GC_) bits */
88 
89 #define GC_SOFT_RESET		(0x00000001)
90 #define GC_INTR_ENABLE		(0x00000002)
91 #define GC_SOFT_INTR		(0x00000004)
92 #define GC_POWER_DOWN		(0x00000008)
93 #define GC_ONE_COPY		(0x00000010)
94 #define GC_BIG_ENDIAN		(0x00000020)
95 #define GC_RX_PREEMPT_TX	(0x00000040)
96 #define GC_TX_PREEMPT_RX	(0x00000080)
97 
98 /*
99  * Receive FIFO Threshold values
100  * Control the level at which the  PCI burst state machine
101  * begins to empty the receive FIFO. Possible values: 0-3
102  *
103  * 0 => 32, 1 => 64, 2 => 96 3 => 128 bytes.
104  */
105 #define GC_RX_FIFO_THR_32	(0x00000000)
106 #define GC_RX_FIFO_THR_64	(0x00000100)
107 #define GC_RX_FIFO_THR_96	(0x00000200)
108 #define GC_RX_FIFO_THR_128	(0x00000300)
109 
110 /* Memory Read Control (MRC_) values */
111 #define GC_MRC_MEM_READ		(0x00000000)
112 #define GC_MRC_READ_MULT	(0x00000400)
113 #define GC_MRC_READ_LINE	(0x00000800)
114 
115 #define GC_SOFTBIT0		(0x00001000)
116 #define GC_SOFTBIT1		(0x00002000)
117 #define GC_RESET_PHY		(0x00004000)
118 
119 /* Definitions of the Receive Control (RC_) register bits */
120 
121 #define RC_SAVE_ERRORED_PKT	(0x00000001)
122 #define RC_SAVE_RUNT_FRAMES	(0x00000002)
123 #define RC_RCV_BROADCAST	(0x00000004)
124 #define RC_RCV_MULTICAST	(0x00000008)
125 #define RC_RCV_INVERSE_PKT	(0x00000010)
126 #define RC_PROMISCUOUS_MODE	(0x00000020)
127 #define RC_MONITOR_MODE		(0x00000040)
128 #define RC_EARLY_RCV_ENABLE	(0x00000080)
129 
130 /* description of the rx descriptors control bits */
131 #define RD_FRAGLIST		(0x0001)	/* Desc points to a fragment list */
132 #define RD_LLFORM		(0x0002)	/* Frag list format */
133 #define RD_HDR_CPY		(0x0004)	/* Desc used for header copy */
134 
135 /* Definition of the Transmit CONTROL (TC) register bits */
136 
137 #define TC_EARLY_TX_ENABLE	(0x00000001)
138 
139 /* Loopback Mode (LM_) Select valuesbits */
140 #define TC_LM_NORMAL		(0x00000000)
141 #define TC_LM_INTERNAL		(0x00000002)
142 #define TC_LM_EXTERNAL		(0x00000004)
143 #define TC_LM_FULL_DPX		(0x00000006)
144 
145 #define TX_SLOT_TIME		(0x00000078)
146 
147 /* Bytes transferred to chip before transmission starts. */
148 #define TX_FIFO_THRESH		128	/* Rounded down to 4 byte units. */
149 
150 /* description of rx descriptors status bits */
151 #define RRING_PKT_INTACT	(0x0001)
152 #define RRING_ALIGN_ERR		(0x0002)
153 #define RRING_CRC_ERR		(0x0004)
154 #define RRING_MISSED_PKT	(0x0008)
155 #define RRING_MULTICAST		(0x0010)
156 #define RRING_BROADCAST		(0x0020)
157 #define RRING_RECEIVER_DISABLE	(0x0040)
158 #define RRING_STATUS_VALID	(0x1000)
159 #define RRING_FRAGLIST_ERR	(0x2000)
160 #define RRING_HDR_COPIED	(0x4000)
161 #define RRING_OWN		(0x8000)
162 
163 /* error summary */
164 #define RRING_ERROR		(RRING_ALIGN_ERR|RRING_CRC_ERR)
165 
166 /* description of tx descriptors status bits */
167 #define TRING_PKT_INTACT	(0x0001)	/* pkt transmitted. */
168 #define TRING_PKT_NONDEFER	(0x0002)	/* pkt xmitted w/o deferring */
169 #define TRING_COLL		(0x0004)	/* pkt xmitted w collisions */
170 #define TRING_CARR		(0x0008)	/* carrier sense lost */
171 #define TRING_UNDERRUN		(0x0010)	/* DMA underrun */
172 #define TRING_HB_COLL		(0x0020)	/* Collision detect Heartbeat */
173 #define TRING_WIN_COLL		(0x0040)	/* out of window collision */
174 #define TRING_DEFERRED		(0x0080)	/* Deferring */
175 #define TRING_COLL_COUNT	(0x0F00)	/* collision counter (mask) */
176 #define TRING_COLL_EXCESS	(0x1000)	/* tx aborted: excessive colls */
177 #define TRING_OWN		(0x8000)	/* desc ownership bit */
178 
179 /* error summary */
180 #define TRING_ABORT	(TRING_COLL_EXCESS|TRING_WIN_COLL|TRING_UNDERRUN)
181 #define TRING_ERROR	(TRING_DEFERRED|TRING_WIN_COLL|TRING_UNDERRUN|TRING_CARR/*|TRING_COLL*/ )
182 
183 /* description of the tx descriptors control bits */
184 #define TD_FRAGLIST		(0x0001)	/* Desc points to a fragment list */
185 #define TD_LLFORM		(0x0002)	/* Frag list format */
186 #define TD_IAF			(0x0004)	/* Generate Interrupt after tx */
187 #define TD_NOCRC		(0x0008)	/* No CRC generated */
188 #define TD_LASTDESC		(0x0010)	/* Last desc for this frame */
189 
190 #endif	/* _EPIC100_H_ */
191