Lines Matching refs:of

46 	  and the FPGA and the ASIC Tonga versions of the board are supported.
68 	  multiple words of data per PCI bus access cycle. Such a multi-word
79 	  may increase the cost of setting up a transfer such that the
182 	  The NICStAR chipset family is used in a large number of ATM NICs for
184 	  series. Say Y if you have one of those.
195 	  ForeRunner LE155 cards. This driver provides detection of cable~
207 	  you to control the loopback mode of the chip via a dedicated IOCTL.
208 	  This driver is required for proper handling of temporary carrier
224 	  Somewhat useful debugging messages are available. The choice of
227 	  the meanings of the bits in the mask.
230 	  speed of the driver, and the size of your syslog files! When
237 	  Enable receiving of all cells on the ATM link, that do not match
238 	  an open connection in the raw cell queue of the driver.  Useful
253 	  here if you have one of these cards.
259 	  Somewhat useful debugging messages are available. The choice of
264 	  <file:drivers/atm/ambassador.h> for the meanings of the bits in the
268 	  speed of the driver, and the size of your syslog files! When
277 	  named horizon) here if you have one of these cards.
283 	  Somewhat useful debugging messages are available. The choice of
288 	  <file:drivers/atm/horizon.h> for the meanings of the bits in the
292 	  speed of the driver, and the size of your syslog files! When
300 	  which include a variety of variants in term of the size of the
301 	  control memory (128K-1KVC, 512K-4KVC), the size of the packet
306 	  named iphase) here if you have one of these cards.
315 	  Somewhat useful debugging messages are available. The choice of
321 	  See the file <file:drivers/atm/iphase.h> for the meanings of the
325 	  speed of the driver, and the size of your syslog files! When
336 	  named fore_200e) here if you have one of these ATM adapters.
347 	  tasklet instead of handling everything at interrupt time.  This
348 	  may improve the responsive of the host.
351 	int "Maximum number of tx retries"
355 	  Specifies the number of times the driver attempts to transmit
356 	  a message before giving up, if the transmit queue of the ATM card
359 	  Saturation of the transmit queue may occur only under extreme
364 	  a saturation of the transmit queue, so the retry mechanism never
372 	  Specifies the level of debugging messages issued by the driver.
373 	  The verbosity of the driver increases with the value of this
377 	  the performances of the driver, and the size of your syslog files!