Searched refs:LCR (Results 1 – 9 of 9) sorted by relevance
| /drivers/net/hamradio/ |
| D | yam.c | 170 #define LCR(iobase) (iobase+3) macro
310 outb(LCR_DLAB | LCR_BIT5, LCR(iobase)); in fpga_reset()
314 outb(LCR_BIT5, LCR(iobase)); in fpga_reset()
437 outb(LCR_DLAB | LCR_BIT8, LCR(dev->base_addr)); in yam_set_uart()
440 outb(LCR_BIT8, LCR(dev->base_addr)); in yam_set_uart()
|
| D | baycom_ser_fdx.c | 109 #define LCR(iobase) (iobase+3) macro
185 outb(0x81, LCR(dev->base_addr)); /* DLAB = 1 */ in ser12_set_divisor()
188 outb(0x01, LCR(dev->base_addr)); /* word length = 6 */ in ser12_set_divisor()
|
| D | baycom_ser_hdx.c | 97 #define LCR(iobase) (iobase+3) macro
172 outb(0x81, LCR(dev->base_addr)); /* DLAB = 1 */ in ser12_set_divisor()
175 outb(0x01, LCR(dev->base_addr)); /* word length = 6 */ in ser12_set_divisor()
|
| /drivers/usb/serial/ |
| D | io_16654.h | 38 #define LCR 3 // Line Control Register macro
|
| D | io_edgeport.c | 2492 MAKE_CMD_WRITE_REG(&currCmd, &cmdLen, number, LCR, LCR_DL_ENABLE); in send_cmd_write_baud_rate()
2499 MAKE_CMD_WRITE_REG(&currCmd, &cmdLen, number, LCR, in send_cmd_write_baud_rate()
2575 regNum == LCR) { in send_cmd_write_uart_register()
2743 status = send_cmd_write_uart_register(edge_port, LCR, in change_port_settings()
|
| /drivers/net/irda/ |
| D | nsc-ircc.h | 105 #define LCR 0x03 /* Link control register */ macro
|
| D | nsc-ircc.c | 998 outb(0x03, iobase+LCR); /* 8 bit word length */ in nsc_ircc_setup()
|
| /drivers/isdn/hisax/ |
| D | hisax.h | 566 u_char LCR; member
|
| /drivers/char/ |
| D | amiserial.c | 831 info->LCR = cval; /* Save LCR */ in change_speed()
|