Lines Matching refs:at

55 	  you may take a look at "Serial ATA (prod) and Parallel ATA
127 	  If you say Y here, the CD-ROM drive will be identified at boot time
158 	  If you say Y here, the tape drive will be identified at boot time
207 	  and the controller is located at legacy ports, this driver
329 	  Please read the comments at the top of <file:drivers/ide/opti621.c>.
341 	  Linux. This may slow disk throughput by a few percent, but at least
366 	  Please read the comments at the top of
474 	  should use the fore mentioned option and call at LILO.
477 	  ide-probe at boot. It is reported to support DVD II drives, by the
529 	  Please read the comments at the top of <file:drivers/ide/ns87415.c>.
544 	  at boot-time for max-speed.  Ultra33 BIOS 1.25 or newer is required
547 	  Please read the comments at the top of
594 	  Please read the comments at the top of <file:drivers/ide/sis5513.c>.
616 	  Please read the comments at the top of
626 	  Please read the comments at the top of <file:drivers/ide/trm290.c>.
746 	  the Amiga's on-board IDE interface. The feature is enabled at kernel
817 	  of I/O ports at 0x1f0 to control up to four drives, instead of the
818 	  customary two drives per port. Support for this can be enabled at
827 	  This driver is enabled at runtime using the "ali14xx.probe" kernel
839 	  This driver is enabled at runtime using the "dtc2278.probe" kernel
850 	  This driver is enabled at runtime using the "ht6560b.probe" kernel
861 	  This driver is enabled at runtime using the "qd65xx.probe" kernel
871 	  This driver is enabled at runtime using the "umc8672.probe" kernel