1config PPC_MPC52xx 2 bool "52xx-based boards" 3 depends on 6xx 4 select PPC_CLOCK 5 select PPC_PCI_CHOICE 6 7config PPC_MPC5200_SIMPLE 8 bool "Generic support for simple MPC5200 based boards" 9 depends on PPC_MPC52xx 10 select DEFAULT_UIMAGE 11 help 12 This option enables support for a simple MPC52xx based boards which 13 do not need a custom platform specific setup. Such boards are 14 supported assuming the following: 15 16 - GPIO pins are configured by the firmware, 17 - CDM configuration (clocking) is setup correctly by firmware, 18 - if the 'fsl,has-wdt' property is present in one of the 19 gpt nodes, then it is safe to use such gpt to reset the board, 20 - PCI is supported if enabled in the kernel configuration 21 and if there is a PCI bus node defined in the device tree. 22 23 Boards that are compatible with this generic platform support 24 are: 25 intercontrol,digsy-mtc 26 phytec,pcm030 27 phytec,pcm032 28 promess,motionpro 29 schindler,cm5200 30 tqc,tqm5200 31 32config PPC_EFIKA 33 bool "bPlan Efika 5k2. MPC5200B based computer" 34 depends on PPC_MPC52xx 35 select PPC_RTAS 36 select RTAS_PROC 37 select PPC_NATIVE 38 39config PPC_LITE5200 40 bool "Freescale Lite5200 Eval Board" 41 depends on PPC_MPC52xx 42 select DEFAULT_UIMAGE 43 44config PPC_MEDIA5200 45 bool "Freescale Media5200 Eval Board" 46 depends on PPC_MPC52xx 47 select DEFAULT_UIMAGE 48 49config PPC_MPC5200_BUGFIX 50 bool "MPC5200 (L25R) bugfix support" 51 depends on PPC_MPC52xx 52 help 53 Enable workarounds for original MPC5200 errata. This is not required 54 for MPC5200B based boards. 55 56 It is safe to say 'Y' here 57 58config PPC_MPC5200_LPBFIFO 59 tristate "MPC5200 LocalPlus bus FIFO driver" 60 depends on PPC_MPC52xx 61 select PPC_BESTCOMM_GEN_BD 62