Searched refs:size (Results 1 – 25 of 586) sorted by relevance
12345678910>>...24
| /Documentation/filesystems/pohmelfs/ |
| D | network_protocol.txt | 8 __u16 csize; /* Attached crypto information size */
9 __u16 cpad; /* Attached padding size */
11 __u32 size; /* Size of the attached data */
47 like partial size of the embedded objects or creation flags.
49 @size - size of the attached data. For NETFS_READ_PAGE and NETFS_READ_PAGES no data is attached,
50 but size of the requested data is incorporated here. It does not include size of the command
57 @csize, @cpad - size and padding size of the (attached if needed) crypto information.
65 @size - the same.
72 Data size does not exceed local page cache size.
76 @size - number of bytes to read plus length of the path to object.
[all …]
|
| /Documentation/devicetree/bindings/mtd/ |
| D | atmel-nand.txt | 5 - reg : should specify localbus address and size used for the chip,
7 If the hardware ECC is PMECC, it should contain address and size for
11 - #address-cells, #size-cells : Must be present if the device has sub-nodes
25 - atmel,pmecc-sector-size : sector size for ECC computation. Supported values
28 for different sector size. First one is for sector size 512, the next is for
29 sector size 1024.
37 #size-cells = <1>;
58 #size-cells = <1>;
59 reg = < 0x40000000 0x10000000 /* bus addr & size */
60 0xffffe000 0x00000600 /* PMECC addr & size */
[all …]
|
| D | partition.txt | 8 #address-cells & #size-cells must both be present in the mtd device. There are
11 size/address (aka the value is below 4 GiB)
13 size/address (aka the value is 4 GiB or greater).
16 - reg : The partition's offset and size within the mtd bank.
31 #size-cells = <1>;
46 #size-cells = <2>;
57 #size-cells = <2>;
|
| /Documentation/devicetree/bindings/misc/ |
| D | at25.txt | 7 - pagesize : size of the eeprom page
8 - size : total eeprom size in bytes
16 Obsolete legacy properties are can be used in place of "size", "pagesize",
18 - at25,byte-len : total eeprom size in bytes
20 - at25,page-size : size of the eeprom page
33 size = <32768>;
|
| /Documentation/devicetree/bindings/powerpc/4xx/ |
| D | emac.txt | 32 - max-frame-size : 1 cell, maximum frame size supported in bytes
33 - rx-fifo-size : 1 cell, Rx fifo size in bytes for 10 and 100 Mb/sec
36 - tx-fifo-size : 1 cell, Tx fifo size in bytes for 10 and 100 Mb/sec
39 - fifo-entry-size : 1 cell, size of a fifo entry (used to calculate
42 - mal-burst-size : 1 cell, MAL burst size (used to calculate thresholds)
74 - rx-fifo-size-gige : 1 cell, Rx fifo size in bytes for 1000 Mb/sec
76 rx-fifo-size). For Axon, either absent or 2048.
77 - tx-fifo-size-gige : 1 cell, Tx fifo size in bytes for 1000 Mb/sec
79 tx-fifo-size). For Axon, either absent or 2048.
98 max-frame-size = <5dc>;
[all …]
|
| /Documentation/mmc/ |
| D | mmc-dev-attrs.txt | 27 erase_size Erase group size
28 preferred_erase_size Preferred erase size
29 raw_rpmb_size_mult RPMB partition size
34 "erase_size" is the minimum size, in bytes, of an erase
35 operation. For MMC, "erase_size" is the erase group size
37 to trim or secure trim operations where the minimum size is
53 which is multiplied by the size of the erase area,
60 size for erasing large areas.
63 erase size if a card specifies one, otherwise it is
67 size specified by the card.
[all …]
|
| /Documentation/device-mapper/ |
| D | dm-service-time.txt | 8 The service time for each path is estimated by dividing the total size
27 Status for each path: <status> <fail-count> <in-flight-size> \
31 <in-flight-size>: The size of in-flight I/Os on the path.
39 dm-service-time adds the I/O size to 'in-flight-size' when the I/O is
44 ('in-flight-size' + 'size-of-incoming-io') / 'relative_throughput'
50 the division and just compare the 'in-flight-size'.
52 2. If the paths have the same 'in-flight-size', skip the division
|
| D | striped.txt | 10 Parameters: <num devs> <chunk size> [<dev path> <offset>]+
12 <chunk size>: Size of each chunk of data. Must be at least as
18 One or more underlying devices can be specified. The striped device size must
19 be a multiple of the chunk size multiplied by the number of underlying devices.
28 # will be called "stripe_dev" and have a chunk-size of 128k.
|
| /Documentation/devicetree/bindings/powerpc/fsl/ |
| D | mpc5121-psc.txt | 25 - fsl,rx-fifo-size : the size of the RX fifo slice (a multiple of 4)
26 - fsl,tx-fifo-size : the size of the TX fifo slice (a multiple of 4)
51 fsl,rx-fifo-size = <16>;
52 fsl,tx-fifo-size = <16>;
61 fsl,rx-fifo-size = <16>;
62 fsl,tx-fifo-size = <16>;
|
| /Documentation/ABI/testing/ |
| D | sysfs-block | 68 Storage devices may report a physical block size that is
69 bigger than the logical block size (for instance a drive
79 Storage devices may report a physical block size that is
80 bigger than the logical block size (for instance a drive
99 block size but may be bigger. One example is SATA
101 block size to the operating system. For stacked block
110 minimum I/O size which is the smallest request the
113 block size. For RAID arrays it is often the stripe
114 chunk size. A properly aligned multiple of
115 minimum_io_size is the preferred request size for
[all …]
|
| /Documentation/devicetree/bindings/net/ |
| D | mdio-mux-mmioreg.txt | 13 multiplexer. The size field in the 'reg' property is the size of
31 #size-cells = <1>;
40 #size-cells = <0>;
47 #size-cells = <0>;
58 #size-cells = <0>;
71 #size-cells = <0>;
|
| D | mdio-mux.txt | 10 - #size-cells = <0>;
17 - #size-cells = <0>;
27 #size-cells = <0>;
41 #size-cells = <0>;
46 #size-cells = <0>;
93 #size-cells = <0>;
|
| /Documentation/devicetree/bindings/usb/ |
| D | samsung-usbphy.txt | 29 - #size-cells: should be '1' when usbphy node has a child node with 'reg'
38 The size of this register is the total sum of size of all PHY_CONTROL
39 registers that the SoC has. For example, the size will be
51 #size-cells = <1>;
85 - #size-cells: should be '1' when usbphy node has a child node with 'reg'
94 The size of this register is the total sum of size of all PHY_CONTROL
95 registers that the SoC has. For example, the size will be
107 #size-cells = <1>;
|
| /Documentation/devicetree/bindings/i2c/ |
| D | i2c-mux.txt | 10 - #size-cells = <0>;
14 - #size-cells = <0>;
34 #size-cells = <0>;
38 #size-cells = <0>;
50 #size-cells = <0>;
|
| D | i2c-pxa-pci-ce4100.txt | 17 address space (first group of 2) and the size of
33 #size-cells = <1>;
44 * followed by size of the mapping. The bar address
54 #size-cells = <0>;
67 #size-cells = <0>;
82 #size-cells = <0>;
|
| /Documentation/x86/ |
| D | mtrr.txt | 44 reg00: base=0x00000000 ( 0MB), size= 128MB: write-back, count=1
45 reg01: base=0x08000000 ( 128MB), size= 64MB: write-back, count=1
48 # echo "base=0xf8000000 size=0x400000 type=write-combining" >! /proc/mtrr
50 # echo "base=0xf8000000 size=0x400000 type=write-combining" >| /proc/mtrr
54 reg00: base=0x00000000 ( 0MB), size= 128MB: write-back, count=1
55 reg01: base=0x08000000 ( 128MB), size= 64MB: write-back, count=1
56 reg02: base=0xf8000000 (3968MB), size= 4MB: write-combining, count=1
58 This is for video RAM at base address 0xf8000000 and size 4 megabytes. To
69 To find out the size of your framebuffer (what, you don't actually
82 %echo "base=0xfb000000 size=0x1000000 type=write-combining" >/proc/mtrr
[all …]
|
| /Documentation/devicetree/bindings/spi/ |
| D | sh-msiof.txt | 11 - renesas,tx-fifo-size : Overrides the default tx fifo size given in words
12 - renesas,rx-fifo-size : Overrides the default rx fifo size given in words
|
| /Documentation/devicetree/bindings/input/touchscreen/ |
| D | mms114.txt | 7 - x-size: horizontal resolution of touchscreen
8 - y-size: vertical resolution of touchscreen
25 x-size = <720>;
26 y-size = <1280>;
|
| D | auo_pixcir_ts.txt | 9 - x-size: horizontal resolution of touchscreen
10 - y-size: vertical resolution of touchscreen
25 x-size = <800>;
26 y-size = <600>;
|
| /Documentation/devicetree/bindings/sound/ |
| D | davinci-mcasp-audio.txt | 24 - sram-size-playback : size of sram to be allocated during playback
25 - sram-size-capture : size of sram to be allocated during capture
32 #size-cells = <0>;
|
| D | omap-mcbsp.txt | 8 - reg: Register location and size, for OMAP4+ as an array:
9 <MPU access base address, size>,
10 <L3 interconnect address, size>;
19 - ti,buffer-size: Size of the FIFO on the port (OMAP2430 and newer SoC)
35 ti,buffer-size = <1280>;
|
| /Documentation/networking/ |
| D | iphase.txt | 80 The (i)Chip boards have 3 different packet RAM size variants: 128K, 512K and
81 1M. The RAM size decides the number of buffers and buffer size. The default
82 size and number of buffers are set as following:
85 RAM size size size size size cnt cnt
98 RX_SIZE = size of receive buffers in the range (48-64K)
100 TX_SIZE = size of transmit buffers in the range (48-64K)
102 1. Transmit and receive buffer size must be a multiple of 4.
|
| /Documentation/RCU/ |
| D | arrayRCU.txt | 58 int size = ids->entries->size;
62 if(newsize <= size)
68 return size;
69 new->size = newsize;
71 sizeof(struct kern_ipc_perm *)*size +
73 for(i=size;i<newsize;i++) {
97 required on the Alpha CPU. Since the size of the array is stored
98 with the array itself, there can be no array-size mismatches, so
113 if(lid >= entries->size) {
|
| /Documentation/trace/ |
| D | kprobetrace.txt | 61 offset, and container-size (usually 32). The syntax is;
63 b<bit-width>@<bit-offset>/<container-size>
120 field:unsigned short common_type; offset:0; size:2; signed:0;
121 field:unsigned char common_flags; offset:2; size:1; signed:0;
122 field:unsigned char common_preempt_count; offset:3; size:1;signed:0;
123 field:int common_pid; offset:4; size:4; signed:1;
125 field:unsigned long __probe_ip; offset:12; size:4; signed:0;
126 field:int __probe_nargs; offset:16; size:4; signed:1;
127 field:unsigned long dfd; offset:20; size:4; signed:0;
128 field:unsigned long filename; offset:24; size:4; signed:0;
[all …]
|
| /Documentation/connector/ |
| D | cn_test.c | 57 int size, size0;
64 size = NLMSG_SPACE(size0);
66 skb = alloc_skb(size, GFP_ATOMIC);
68 pr_err("failed to allocate new skb with size=%u\n", size);
72 nlh = nlmsg_put(skb, 0, 0x123, NLMSG_DONE, size - sizeof(*nlh), 0);
|
12345678910>>...24