Lines Matching refs:used

45 	The above command can be used to connect to an AP with a particular SSID.
48 …Note: Every time before connecting to an AP scan command (iw dev mlan0 scan) should be used by use…
51 	This command will be used to disconnect from an AP.
55 	The command will be used to join or create an ibss. Optionally, operating frequency,
60 	The command will be used to leave an ibss network.
63 	The command will be used to get the connection status. The command will return parameters
70 	The debugfs interface can be used for configurations and for getting
83 	The command will be used to change the regulatory domain.
86 	The command will be used to get current regulatory domain.
89 	This command is used to get driver info.
167 	This command is used to read/write the adapter register.
184 	This command is used to read the EEPROM contents of the card.
198 	This command is used to debug/simulate host sleep feature using
210 		[GPIO#]: pin number of GPIO used to wakeup the host.
212 			 will be used instead).
215 			 acknowledge required) when GPIO is used to wakeup host.
228         This command is used to get the statistics available in the station.
234 	This command is used to dump firmware memory into files.