• Home
  • Line#
  • Scopes#
  • Navigate#
  • Raw
  • Download
1 /*
2  * arch/arm/mach-ixp4xx/include/mach/platform.h
3  *
4  * Constants and functions that are useful to IXP4xx platform-specific code
5  * and device drivers.
6  *
7  * Copyright (C) 2004 MontaVista Software, Inc.
8  */
9 
10 #ifndef __ASM_ARCH_HARDWARE_H__
11 #error "Do not include this directly, instead #include <mach/hardware.h>"
12 #endif
13 
14 #ifndef __ASSEMBLY__
15 
16 #include <linux/reboot.h>
17 
18 #include <asm/types.h>
19 
20 #ifndef	__ARMEB__
21 #define	REG_OFFSET	0
22 #else
23 #define	REG_OFFSET	3
24 #endif
25 
26 /*
27  * Expansion bus memory regions
28  */
29 #define IXP4XX_EXP_BUS_BASE_PHYS	(0x50000000)
30 
31 /*
32  * The expansion bus on the IXP4xx can be configured for either 16 or
33  * 32MB windows and the CS offset for each region changes based on the
34  * current configuration. This means that we cannot simply hardcode
35  * each offset. ixp4xx_sys_init() looks at the expansion bus configuration
36  * as setup by the bootloader to determine our window size.
37  */
38 extern unsigned long ixp4xx_exp_bus_size;
39 
40 #define	IXP4XX_EXP_BUS_BASE(region)\
41 		(IXP4XX_EXP_BUS_BASE_PHYS + ((region) * ixp4xx_exp_bus_size))
42 
43 #define IXP4XX_EXP_BUS_END(region)\
44 		(IXP4XX_EXP_BUS_BASE(region) + ixp4xx_exp_bus_size - 1)
45 
46 /* Those macros can be used to adjust timing and configure
47  * other features for each region.
48  */
49 
50 #define IXP4XX_EXP_BUS_RECOVERY_T(x)	(((x) & 0x0f) << 16)
51 #define IXP4XX_EXP_BUS_HOLD_T(x)	(((x) & 0x03) << 20)
52 #define IXP4XX_EXP_BUS_STROBE_T(x)	(((x) & 0x0f) << 22)
53 #define IXP4XX_EXP_BUS_SETUP_T(x)	(((x) & 0x03) << 26)
54 #define IXP4XX_EXP_BUS_ADDR_T(x)	(((x) & 0x03) << 28)
55 #define IXP4XX_EXP_BUS_SIZE(x)		(((x) & 0x0f) << 10)
56 #define IXP4XX_EXP_BUS_CYCLES(x)	(((x) & 0x03) << 14)
57 
58 #define IXP4XX_EXP_BUS_CS_EN		(1L << 31)
59 #define IXP4XX_EXP_BUS_BYTE_RD16	(1L << 6)
60 #define IXP4XX_EXP_BUS_HRDY_POL		(1L << 5)
61 #define IXP4XX_EXP_BUS_MUX_EN		(1L << 4)
62 #define IXP4XX_EXP_BUS_SPLT_EN		(1L << 3)
63 #define IXP4XX_EXP_BUS_WR_EN		(1L << 1)
64 #define IXP4XX_EXP_BUS_BYTE_EN		(1L << 0)
65 
66 #define IXP4XX_EXP_BUS_CYCLES_INTEL	0x00
67 #define IXP4XX_EXP_BUS_CYCLES_MOTOROLA	0x01
68 #define IXP4XX_EXP_BUS_CYCLES_HPI	0x02
69 
70 #define IXP4XX_FLASH_WRITABLE	(0x2)
71 #define IXP4XX_FLASH_DEFAULT	(0xbcd23c40)
72 #define IXP4XX_FLASH_WRITE	(0xbcd23c42)
73 
74 /*
75  * Clock Speed Definitions.
76  */
77 #define IXP4XX_PERIPHERAL_BUS_CLOCK 	(66) /* 66Mhzi APB BUS   */
78 #define IXP4XX_UART_XTAL        	14745600
79 
80 /*
81  * This structure provide a means for the board setup code
82  * to give information to th pata_ixp4xx driver. It is
83  * passed as platform_data.
84  */
85 struct ixp4xx_pata_data {
86 	volatile u32	*cs0_cfg;
87 	volatile u32	*cs1_cfg;
88 	unsigned long	cs0_bits;
89 	unsigned long	cs1_bits;
90 	void __iomem	*cs0;
91 	void __iomem	*cs1;
92 };
93 
94 #define IXP4XX_ETH_NPEA		0x00
95 #define IXP4XX_ETH_NPEB		0x10
96 #define IXP4XX_ETH_NPEC		0x20
97 
98 /* Information about built-in Ethernet MAC interfaces */
99 struct eth_plat_info {
100 	u8 phy;		/* MII PHY ID, 0 - 31 */
101 	u8 rxq;		/* configurable, currently 0 - 31 only */
102 	u8 txreadyq;
103 	u8 hwaddr[6];
104 };
105 
106 /* Information about built-in HSS (synchronous serial) interfaces */
107 struct hss_plat_info {
108 	int (*set_clock)(int port, unsigned int clock_type);
109 	int (*open)(int port, void *pdev,
110 		    void (*set_carrier_cb)(void *pdev, int carrier));
111 	void (*close)(int port, void *pdev);
112 	u8 txreadyq;
113 };
114 
115 /*
116  * Frequency of clock used for primary clocksource
117  */
118 extern unsigned long ixp4xx_timer_freq;
119 
120 /*
121  * Functions used by platform-level setup code
122  */
123 extern void ixp4xx_map_io(void);
124 extern void ixp4xx_init_early(void);
125 extern void ixp4xx_init_irq(void);
126 extern void ixp4xx_sys_init(void);
127 extern void ixp4xx_timer_init(void);
128 extern void ixp4xx_restart(enum reboot_mode, const char *);
129 extern void ixp4xx_pci_preinit(void);
130 struct pci_sys_data;
131 extern int ixp4xx_setup(int nr, struct pci_sys_data *sys);
132 extern struct pci_ops ixp4xx_ops;
133 
134 #endif // __ASSEMBLY__
135 
136