Searched refs:decoding (Results 1 – 15 of 15) sorted by relevance
347 (!atomic_read(&itv->decoding) || in ivtv_firmware_check()348 (atomic_read(&itv->decoding) < 2 && test_bit(IVTV_F_I_DEC_YUV, in ivtv_firmware_check()378 !atomic_read(&itv->decoding)) { in ivtv_firmware_check()
770 atomic_inc(&itv->decoding); in ivtv_start_v4l2_decode_stream()968 atomic_dec(&itv->decoding); in ivtv_stop_v4l2_decode_stream()1008 atomic_inc(&itv->decoding); in ivtv_passthrough_mode()1030 atomic_dec(&itv->decoding); in ivtv_passthrough_mode()
116 if (atomic_read(&itv->decoding)) { in ivtv_g_pts_frame()
171 if (atomic_read(&itv->decoding) > 0) { in ivtv_set_speed()280 if (atomic_read(&itv->decoding) == 0) in ivtv_video_command()291 if (!atomic_read(&itv->decoding)) in ivtv_video_command()295 if (atomic_read(&itv->decoding) > 0) { in ivtv_video_command()305 if (!atomic_read(&itv->decoding)) in ivtv_video_command()1152 atomic_read(&itv->decoding) > 0) { in ivtv_s_std()
671 atomic_t decoding; /* count number of active decoding streams */ member
529 if (atomic_read(&itv->decoding) == 0) { in ivtv_start_decoding()
1426 if (atomic_read(&itv->decoding) > 0) { in ivtv_remove()
23 LIRC daemon handles protocol decoding for IR reception and65 uses the RC6 protocol, and you need software decoding support.75 uses the JVC protocol, and you need software decoding support.85 uses the Sony protocol, and you need software decoding support.95 and you need software decoding support.104 uses the Sharp protocol, and you need software decoding support.
19 cross connecting of bchannels, conferencing, dtmf decoding,
37 sense-decoding message. Setting to 2 will also print recoverable
13 and internal bus master decoding.
14 changes to the IR raw decoders for software decoding. This is much
248 Say Y here to support the default remote control decoding for the
69 the MCE decoding code in EDAC.
827 bool "NMI decoding support for the HP ProLiant iLO2+ Hardware Watchdog Timer"