Home
last modified time | relevance | path

Searched refs:echo (Results 1 – 25 of 35) sorted by relevance

12

/drivers/net/can/
Dvcan.c67 static bool echo; /* echo testing. Default: 0 (Off) */ variable
68 module_param(echo, bool, S_IRUGO);
69 MODULE_PARM_DESC(echo, "Echo sent frames (for testing). Default: 0 (Off)");
102 if (!echo) { in vcan_tx()
162 if (echo) in vcan_setup()
178 if (echo) in vcan_init_module()
/drivers/net/wireless/libertas/
DREADME77 echo "0xa123" > rdmac ; cat rdmac
78 echo "0xa123" > rdbbp ; cat rdbbp
79 echo "0xa123" > rdrf ; cat rdrf
90 echo "0xa123 0xaa" > wrmac
91 echo "0xa123 0xaa" > wrbbp
92 echo "0xa123 0xaa" > wrrf
102 echo "p1 p2 p3 p4 p5 p6" > sleepparams: writes the sleepclock configuration.
126 echo "60 2 1" > event
169 Usage: echo "SSID" > extscan
172 echo "LINKSYS-AP" > extscan
[all …]
/drivers/net/wireless/mwifiex/
DREADME170 echo " <type> <offset> [value]" > regrdwr
179 echo "1 0xa060" > regrdwr : Read the MAC register
180 echo "1 0xa060 0x12" > regrdwr : Write the MAC register
181 echo "1 0xa794 0x80000000" > regrdwr
187 echo "<offset> <length>" > rdeeprom
195 echo "0 20" > rdeeprom : Read 20 bytes of EEPROM data from offset 0
202 echo "<condition> [GPIO# [gap]]]" > hscfg
218 echo "-1" > hscfg : Cancel host sleep mode
219 echo "3" > hscfg : Broadcast and unicast data;
221 echo "2 3" > hscfg : Unicast data and GPIO 3;
[all …]
/drivers/media/rc/
Dir-sharp-decoder.c49 u32 msg, echo, address, command, scancode; in ir_sharp_decode() local
151 echo = data->bits & 0x7fff; in ir_sharp_decode()
152 if ((msg ^ echo) != 0x3ff) { in ir_sharp_decode()
155 msg, echo); in ir_sharp_decode()
/drivers/isdn/mISDN/
Ddsp_cmx.c168 odsp->name, odsp->echo.hardware, odsp->echo.software, in dsp_cmx_debug()
416 if (!dsp->echo.software && !dsp->echo.hardware) { in dsp_cmx_hardware()
435 dsp->echo.software = dsp->tx_data; in dsp_cmx_hardware()
436 dsp->echo.hardware = 0; in dsp_cmx_hardware()
440 dsp->echo.hardware = 1; in dsp_cmx_hardware()
455 dsp->echo.hardware = 1; in dsp_cmx_hardware()
485 dsp->echo.software = 1; in dsp_cmx_hardware()
499 dsp->echo.hardware = 1; in dsp_cmx_hardware()
569 if (member->dsp->echo.hardware || member->dsp->echo.software) { in dsp_cmx_hardware()
1327 dsp->echo.hardware) && /* OR hardware echo */
[all …]
DKconfig20 echo cancellation, tone generation, and Blowfish encryption and
Ddsp_core.c207 else if (dsp->echo.software) in dsp_rx_off_member()
424 dsp->echo.software = 1; /* soft echo */ in dsp_control_req()
433 dsp->echo.software = 0; in dsp_control_req()
434 dsp->echo.hardware = 0; in dsp_control_req()
Ddsp.h176 struct dsp_echo echo; member
/drivers/staging/lustre/lustre/obdecho/
Dlproc_echo.c40 LPROC_SEQ_FOPS_RO_TYPE(echo, uuid);
46 LPROC_SEQ_FOPS_RO_TYPE(echo, numrefs);
/drivers/misc/echo/
DKconfig5 This driver provides line echo cancelling support for mISDN and
9 will be called echo.
/drivers/pps/
Dkapi.c114 pps->info.echo == NULL) in pps_register_source()
115 pps->info.echo = pps_echo_client_default; in pps_register_source()
191 pps->info.echo(pps, event, data); in pps_event()
Dsysfs.c74 return sprintf(buf, "%d\n", !!pps->info.echo); in echo_show()
76 static DEVICE_ATTR_RO(echo);
/drivers/block/drbd/
DKconfig69 echo 16 > /sys/module/drbd/parameters/enable_faults
70 echo 1 > /sys/module/drbd/parameters/fault_devs
71 echo 5 > /sys/module/drbd/parameters/fault_rate
/drivers/net/wireless/ath/carl9170/
Dfwcmd.h226 struct carl9170_u32_list echo; member
313 struct carl9170_u32_list echo; member
/drivers/staging/speakup/
Dspkguide.txt427 volume, pitch, and rate, you can also echo values to the appropriate
442 echo 0 >/speakup/punc_level
443 echo 0 >/speakup/reading_punc
444 echo Punctuation level set to 0.
449 echo 1 >/speakup/punc_level
450 echo 1 >/speakup/reading_punc
451 echo Punctuation level set to 1.
456 echo 2 >/speakup/punc_level
457 echo 2 >/speakup/reading_punc
458 echo Punctuation level set to 2.
[all …]
/drivers/staging/vt6655/
Dtest8 test_dir = $(shell [ -e $(dir)/include/linux ] && echo $(dir))
/drivers/net/wireless/iwlegacy/
DKconfig81 To set a value, simply echo an 8-byte hex value to the same file:
83 % echo 0x43fff > /sys/class/net/wlan0/device/debug_level
/drivers/net/wireless/iwlwifi/
DKconfig113 To set a value, simply echo an 8-byte hex value to the same file:
115 % echo 0x43fff > /sys/module/iwlwifi/parameters/debug
/drivers/net/ethernet/broadcom/bnx2x/
Dbnx2x_hsi.h3635 __le32 echo; member
3700 __le32 echo; member
4127 __le32 echo; member
4160 __le32 echo; member
4529 __le32 echo; member
4746 u8 echo; member
5066 u32 echo; member
5110 u8 echo; member
5118 u8 echo; member
5279 u8 echo; member
Dbnx2x_sp.c799 hdr->echo = cpu_to_le32((cid & BNX2X_SWCID_MASK) | in bnx2x_vlan_mac_set_rdata_hdr_e2()
910 hdr->echo = cpu_to_le32((r->cid & BNX2X_SWCID_MASK) | in bnx2x_vlan_mac_set_rdata_hdr_e1x()
2144 hdr->echo = cpu_to_le32(cid); in bnx2x_rx_mode_set_rdata_hdr_e2()
2887 data->header.echo = cpu_to_le32((r->cid & BNX2X_SWCID_MASK) | in bnx2x_mcast_set_rdata_hdr_e2()
3240 data->hdr.echo = cpu_to_le32((r->cid & BNX2X_SWCID_MASK) | in bnx2x_mcast_set_rdata_hdr_e1()
4031 data->echo = cpu_to_le32((r->cid & BNX2X_SWCID_MASK) | in bnx2x_setup_rss()
5764 rdata->echo = SWITCH_UPDATE; in bnx2x_func_send_switch_update()
5797 rdata->echo = AFEX_UPDATE; in bnx2x_func_send_afex_update()
5835 rdata->echo = afex_vif_params->afex_vif_list_command; in bnx2x_func_send_afex_viflists()
/drivers/net/wireless/ipw2x00/
DKconfig136 % echo 1 > /sys/bus/pci/drivers/ipw2200/*/rtap_iface
191 % echo 0x00000FFO > /proc/net/ieee80211/debug_level
/drivers/net/fddi/skfp/
Dsmt.c100 static void smt_fill_echo(struct s_smc *smc, struct smt_p_echo *echo, u_long seed,
1531 static void smt_fill_echo(struct s_smc *smc, struct smt_p_echo *echo, u_long seed, in smt_fill_echo() argument
1537 SMTSETPARA(echo,SMT_P_ECHODATA) ; in smt_fill_echo()
1538 echo->para.p_len = len ; in smt_fill_echo()
1539 for (p = echo->ec_data ; len ; len--) { in smt_fill_echo()
/drivers/xen/
DKconfig50 [ "`cat "$i"`" = offline ] && echo online > "$i"; done
54 …SUBSYSTEM=="memory", ACTION=="add", RUN+="/bin/sh -c '[ -f /sys$devpath/state ] && echo online > /…
/drivers/message/fusion/
DKconfig118 echo [level] > /sys/class/scsi_host/host#/debug_level
/drivers/scsi/fnic/
Dfcpio.h491 struct fcpio_echo echo; member

12