Home
last modified time | relevance | path

Searched refs:ipath_dbg (Results 1 – 13 of 13) sorted by relevance

/drivers/infiniband/hw/ipath/
Dipath_intr.c145 ipath_dbg("Ignoring packet errors %llx, because link not " in handle_e_sum_errs()
358 ipath_dbg("IB linkrecov up %Lx (%s %s) recov %Lu\n", in handle_e_ibstatuschanged()
488 ipath_dbg("Suppressed %u messages for %s\n", in handle_supp_msgs()
539 ipath_dbg("errors %lx (%s)\n", (unsigned long)errs, msg); in handle_sdma_errors()
573 ipath_dbg("%s SDmaDisabled intr\n", in handle_sdma_intr()
682 ipath_dbg("Ignoring packet errors %llx, because link not " in handle_errors()
719 ipath_dbg("Temporarily disabling reporting " in handle_errors()
752 ipath_dbg("%lu special trigger hits\n", in handle_errors()
843 ipath_dbg("Lost link, link now down (%s)\n", in handle_errors()
946 ipath_dbg("free_irq of irq %d\n", in ipath_bad_intr()
[all …]
Dipath_eeprom.c238 ipath_dbg("get bit failed!\n"); in sda_in()
506 ipath_dbg("Failed EEPROM startcmd\n"); in ipath_eeprom_internal_read()
521 ipath_dbg("Failed startcmd for dev %02X\n", icd->eeprom_dev); in ipath_eeprom_internal_read()
565 ipath_dbg("Failed to start cmd offset %u\n", in ipath_eeprom_internal_write()
572 ipath_dbg("Failed EEPROM startcmd\n"); in ipath_eeprom_internal_write()
589 ipath_dbg("no ack after byte %u/%u (%u " in ipath_eeprom_internal_write()
613 ipath_dbg("Did not get successful read to " in ipath_eeprom_internal_write()
740 ipath_dbg("nguid %u, so adding %u to device 0 guid, " in ipath_get_eeprom_info()
1047 ipath_dbg("Failed tempsense startcmd\n"); in ipath_tempsense_internal_read()
1061 ipath_dbg("Failed tempsense RD startcmd\n"); in ipath_tempsense_internal_read()
[all …]
Dipath_driver.c172 ipath_dbg("Read bar0 %x bar1 %x\n", *bar0, *bar1); in read_bars()
376 ipath_dbg("PIO buffer bandwidth %u MiB/sec is OK\n", in ipath_verify_pioperf()
482 ipath_dbg("No 64bit DMA mask, used 32 bit mask\n"); in ipath_init_one()
549 ipath_dbg("Unable to map io addr %llx to kvirt, failing\n", in ipath_init_one()
773 ipath_dbg("irq is 0, not doing free_irq " in ipath_remove_one()
1224 ipath_dbg("Bug: Expected TID, opcode %x; ignored\n", in ipath_kreceive()
1350 ipath_dbg("Update shadow pioavail, but regs_dma NULL!\n"); in ipath_update_pio_bufs()
1433 ipath_dbg("shadow[%d] was %Lx, now %lx\n", in ipath_reset_availshadow()
1463 ipath_dbg("Error: can't set protocol header size %u " in ipath_setrcvhdrsize()
1495 ipath_dbg("%u tries no piobufavail ts%lx; dmacopy: " in no_pio_bufs()
[all …]
Dipath_iba6110.c435 ipath_dbg("HT linkctrl0 0x%x%s%s\n", ctrl0, in hwerr_crcbits()
447 ipath_dbg("HT linkctrl1 0x%x%s%s\n", ctrl1, in hwerr_crcbits()
456 ipath_dbg("HT crc errs: %s\n", msg); in hwerr_crcbits()
458 ipath_dbg("ignoring HT crc errors 0x%llx, " in hwerr_crcbits()
575 ipath_dbg("Clearing freezemode on ignored or " in ipath_ht_handle_hwerrors()
781 ipath_dbg("Failed write to clear HT " in ipath_check_htlink()
799 ipath_dbg("No reset possible for this InfiniPath hardware\n"); in ipath_setup_ht_reset()
872 ipath_dbg("Failed write to clear HT " in slave_or_pri_blk()
920 ipath_dbg("Will ignore HT lane1 errors\n"); in slave_or_pri_blk()
1307 ipath_dbg("MemBIST corrected\n"); in ipath_ht_init_hwerrors()
[all …]
Dipath_wc_x86_64.c101 ipath_dbg("pioaddr %llx not on right boundary for size " in ipath_enable_wc()
113 ipath_dbg("changing WC base from %llx to %llx, " in ipath_enable_wc()
Dipath_init_chip.c253 ipath_dbg("Configured to use %u ports out of %u in chip\n", in init_chip_first()
258 ipath_dbg("Tried to configured to use %u ports; chip " in init_chip_first()
321 ipath_dbg("%u 2k(%x) piobufs @ %p, %u 4k(%x) @ %p " in init_chip_first()
328 else ipath_dbg("%u 2k piobufs @ %p\n", in init_chip_first()
657 ipath_dbg("%s", dd->ipath_boardversion); in init_housekeeping()
776 ipath_dbg("%u pbufs/port leaves some unused, add 1 buffer to " in ipath_init_chip()
1014 ipath_dbg("Failed (%d) to initialize chip\n", ret); in ipath_init_chip()
Dipath_stats.c184 ipath_dbg("%s\n", buf); in ipath_qcheck()
236 ipath_dbg("errormask fixed(%u) %lx -> %lx, no freeze\n", in ipath_chk_errormask()
319 ipath_dbg( in ipath_get_faststats()
Dipath_file_ops.c312 ipath_dbg("After copyin, tidcnt 0, tidlist %llx\n", in ipath_tid_update()
360 ipath_dbg("Fail vaddr %p, %u pages, !access_ok\n", in ipath_tid_update()
368 ipath_dbg("Failed to lock addr %p, %u pages " in ipath_tid_update()
398 ipath_dbg("Not enough free TIDs for %u pages " in ipath_tid_update()
435 ipath_dbg("After failure (ret=%d), undo %d of %d entries\n", in ipath_tid_update()
487 ipath_dbg("Failed to map %u TID pages, failing with %d\n", in ipath_tid_update()
578 ipath_dbg("Unused tid %u, ignoring\n", tid); in ipath_tid_free()
581 ipath_dbg("passed in tidcnt %d, only %d bits set in map\n", in ipath_tid_free()
585 ipath_dbg("Failed to unmap %u TID pages, failing with %d\n", in ipath_tid_free()
654 ipath_dbg("All pkeys for port %u already in use, " in ipath_set_part_key()
[all …]
Dipath_sdma.c68 ipath_dbg("vl15 watchdog timeout - clearing\n"); in vl15_watchdog_timeout()
72 ipath_dbg("vl15 watchdog timeout - " in vl15_watchdog_timeout()
253 ipath_dbg("give up waiting for SDMADISABLED intr\n"); in sdma_abort_task()
345 ipath_dbg("looping with status 0x%08lx\n", in sdma_abort_task()
615 ipath_dbg("invalid attempt to restart SDMA, status 0x%08lx\n", in ipath_restart_sdma()
679 ipath_dbg("packet size %X > ibmax %X, fail\n", in ipath_sdma_verbs_send()
Dipath_keys.c64 ipath_dbg("LKEY table full\n"); in ipath_alloc_lkey()
Dipath_kernel.h1350 # define ipath_dbg(fmt,...) \ macro
1357 # define ipath_dbg(fmt,...) macro
Dipath_diag.c415 ipath_dbg("Pkt len 0x%x > ibmaxlen %x\n", in ipath_diagpkt_write()
Dipath_user_sdma.c751 ipath_dbg("packet size %X > ibmax %X, fail\n", in ipath_user_sdma_push_pkts()