| /arch/arm/mach-omap2/ |
| D | omap-headsmp.S | 30 hold: ldr r12,=0x103 label
37 bne hold
|
| /arch/mips/include/asm/mach-bcm63xx/ |
| D | bcm63xx_cs.h | 6 unsigned int setup, unsigned int hold);
|
| /arch/mips/include/asm/txx9/ |
| D | ndfmc.h | 19 unsigned int hold; /* hold time in nanosecond */ member
|
| D | tx4938.h | 294 void tx4938_ndfmc_init(unsigned int hold, unsigned int spw);
|
| D | tx4939.h | 547 void tx4939_ndfmc_init(unsigned int hold, unsigned int spw,
|
| /arch/mips/bcm63xx/ |
| D | cs.c | 66 unsigned int setup, unsigned int hold) in bcm63xx_set_cs_timing() argument
81 val |= hold << MPI_CSCTL_HOLD_SHIFT; in bcm63xx_set_cs_timing()
|
| /arch/ia64/ |
| D | module.lds | 6 * Create place-holder sections to hold the PLTs, GOT, and
|
| /arch/cris/include/arch-v10/arch/ |
| D | svinto.h | 54 IO_STATE( R_DMA_CH0_CMD, cmd, hold ) )
|
| /arch/arm/mach-prima2/ |
| D | clock.c | 224 u32 hold = (cfg >> 20) & (BIT(4) - 1); in dmn_get_rate() local
226 clk->rate = fin / (wait + hold + 2); in dmn_get_rate()
235 unsigned ratio, wait, hold, reg; in dmn_set_rate() local
247 hold = ratio - wait - 2; in dmn_set_rate()
251 reg |= (wait << 16) | (hold << 20) | BIT(25); in dmn_set_rate()
|
| /arch/c6x/lib/ |
| D | divi.S | 32 ;; divi uses B5 to hold the original return address during
34 ;; remi uses B2 and A5 to hold the input values during the
|
| D | remi.S | 32 ;; divi uses B5 to hold the original return address during
34 ;; remi uses B2 and A5 to hold the input values during the
|
| D | remu.S | 32 ;; divi uses B5 to hold the original return address during
34 ;; remi uses B2 and A5 to hold the input values during the
|
| D | divu.S | 32 ;; divi uses B5 to hold the original return address during
34 ;; remi uses B2 and A5 to hold the input values during the
|
| /arch/mn10300/mm/ |
| D | cache.inc | 16 # A0: Should hold CHCTR
77 # A0: Should hold CHCTR
|
| /arch/mips/txx9/generic/ |
| D | setup_tx4938.c | 382 void __init tx4938_ndfmc_init(unsigned int hold, unsigned int spw) in tx4938_ndfmc_init() argument
387 .hold = hold, in tx4938_ndfmc_init()
|
| D | setup_tx4939.c | 452 void __init tx4939_ndfmc_init(unsigned int hold, unsigned int spw, in tx4939_ndfmc_init() argument
458 .hold = hold, in tx4939_ndfmc_init()
|
| /arch/mips/include/asm/sn/sn0/ |
| D | hubio.h | 544 hold: 1, /* entry is gathering inval acks */ member
592 hold: 1, /* entry is gathering inval acks */ member
891 hold: 1, /* 16: crb gathering invalidate acks*/ member
|
| /arch/mn10300/kernel/ |
| D | entry.S | 211 # - note that there will not be a stack, D0/A0 will hold EPSW/PC as were
|
| /arch/powerpc/platforms/pseries/ |
| D | Kconfig | 110 by allocating pages of memory and put them "on hold". This only
|
| /arch/m68k/fpsp040/ |
| D | bugfix.S | 304 | The frame returned is idle. We must build a busy frame to hold
430 | The frame returned is idle. We must build a busy frame to hold
|
| D | scale.S | 53 smi L_SCR1(%a6) |use L_SCR1 to hold sign
|
| /arch/arm/nwfpe/ |
| D | softfloat-specialize | 263 `high' and `low' values hold the most- and least-significant bits,
|
| /arch/microblaze/ |
| D | Kconfig | 244 page size to hold its contents and the difference between the
|
| /arch/s390/ |
| D | Kconfig | 473 by allocating pages of memory and put them "on hold". This only
|
| /arch/m68k/ifpsp060/src/ |
| D | ilsp.S | 329 clr.l %d1 # %d1 will hold trial quotient
|