Searched refs:UART_IER_RDI (Results 1 – 21 of 21) sorted by relevance
/drivers/staging/media/lirc/ |
D | lirc_sir.c | 849 (~(UART_IER_MSI|UART_IER_RLSI|UART_IER_THRI|UART_IER_RDI))); in init_hardware() 901 soutp(UART_IER, sinp(UART_IER)|UART_IER_RDI); in init_hardware() 915 outb(UART_IER_RDI, io + UART_IER); in init_hardware() 1144 soutp(UART_IER, sinp(UART_IER)|UART_IER_RDI); in init_act200() 1203 soutp(UART_IER, UART_IER_RDI); in init_act220()
|
D | lirc_serial.c | 785 (~(UART_IER_MSI|UART_IER_RLSI|UART_IER_THRI|UART_IER_RDI))); in hardware_init_port() 965 (~(UART_IER_MSI|UART_IER_RLSI|UART_IER_THRI|UART_IER_RDI))); in set_use_dec() 1107 (~(UART_IER_MSI|UART_IER_RLSI|UART_IER_THRI|UART_IER_RDI))); in lirc_serial_suspend()
|
/drivers/tty/serial/ |
D | m32r_sio_reg.h | 150 #define UART_IER_RDI 0x04 /* Enable receiver data interrupt */ macro
|
D | nwpserial.c | 82 dcr_write(up->dcr_host, UART_IER, up->ier & ~UART_IER_RDI); in nwpserial_console_write() 180 up->ier = UART_IER_RDI; in nwpserial_startup()
|
D | omap-serial.c | 412 up->ier &= ~(UART_IER_RDI | UART_IER_RLSI); in serial_omap_irq() 577 up->ier = UART_IER_RLSI | UART_IER_RDI; in serial_omap_startup() 1221 up->ier |= (UART_IER_RDI | UART_IER_RLSI); in serial_omap_rxdma_poll() 1242 up->ier |= (UART_IER_RDI | UART_IER_RLSI); in serial_omap_rxdma_poll()
|
D | pxa.c | 413 up->ier = UART_IER_RLSI | UART_IER_RDI | UART_IER_RTOIE | UART_IER_UUE; in serial_pxa_startup()
|
D | vr41xx_siu.c | 479 siu_write(port, UART_IER, UART_IER_RLSI | UART_IER_RDI); in siu_startup()
|
D | m32r_sio.c | 655 up->ier = UART_IER_MSI | UART_IER_RLSI | UART_IER_RDI; in m32r_sio_startup()
|
D | mfd.c | 794 up->ier = UART_IER_RLSI | UART_IER_RDI | UART_IER_RTOIE; in serial_hsu_startup()
|
D | sunsu.c | 696 up->ier = UART_IER_RLSI | UART_IER_RDI; in sunsu_startup()
|
/drivers/tty/ |
D | mxser.h | 108 #define MOXA_MUST_RECV_ISR (UART_IER_RDI | MOXA_MUST_IER_EGDAI)
|
D | mxser.c | 926 info->IER = UART_IER_MSI | UART_IER_RLSI | UART_IER_RDI; in mxser_activate()
|
/drivers/staging/speakup/ |
D | serialio.c | 110 outb(UART_IER_MSI|UART_IER_RLSI|UART_IER_RDI, in start_serial_interrupt()
|
/drivers/tty/serial/jsm/ |
D | jsm_neo.c | 1054 ier |= (UART_IER_RDI | UART_IER_RLSI); in neo_param() 1254 tmp &= ~(UART_IER_RDI); in neo_disable_receiver() 1270 tmp |= (UART_IER_RDI); in neo_enable_receiver()
|
/drivers/net/irda/ |
D | ali-ircc.c | 961 outb(UART_IER_RDI, iobase+UART_IER); in ali_ircc_sir_write_wakeup() 1376 outb(UART_IER_RDI , iobase+UART_IER); in ali_ircc_net_open() 2181 newMask = UART_IER_THRI | UART_IER_RDI; in SetCOMInterrupts() 2191 newMask = UART_IER_RDI; in SetCOMInterrupts()
|
D | smsc-ircc2.c | 1179 outb(UART_IER_RLSI | UART_IER_RDI | UART_IER_THRI, iobase + UART_IER); in smsc_ircc_set_sir_speed() 1935 outb(UART_IER_RLSI | UART_IER_RDI |UART_IER_THRI, sir_base + UART_IER); in smsc_ircc_sir_start() 2017 outb(UART_IER_RDI, iobase + UART_IER); in smsc_ircc_sir_write_wakeup()
|
/drivers/bluetooth/ |
D | dtl1_cs.c | 502 outb(UART_IER_RLSI | UART_IER_RDI | UART_IER_THRI, iobase + UART_IER); in dtl1_open()
|
D | btuart_cs.c | 387 outb(UART_IER_RLSI | UART_IER_RDI | UART_IER_THRI, iobase + UART_IER); in btuart_change_speed()
|
/drivers/isdn/hisax/ |
D | elsa_ser.c | 181 cs->hw.elsa.IER = UART_IER_MSI | UART_IER_RLSI | UART_IER_RDI; in mstartup()
|
/drivers/mmc/card/ |
D | sdio_uart.c | 671 port->ier = UART_IER_RLSI|UART_IER_RDI|UART_IER_RTOIE|UART_IER_UUE; in sdio_uart_activate()
|
/drivers/tty/serial/8250/ |
D | 8250.c | 2146 up->ier = UART_IER_RLSI | UART_IER_RDI; in serial8250_startup()
|