| /drivers/input/serio/ |
| D | libps2.c | 188 int receive = (command >> 8) & 0xf; in __ps2_command() local
192 if (receive > sizeof(ps2dev->cmdbuf)) { in __ps2_command()
204 ps2dev->cmdcnt = receive; in __ps2_command()
205 if (receive && param) in __ps2_command()
206 for (i = 0; i < receive; i++) in __ps2_command()
207 ps2dev->cmdbuf[(receive - 1) - i] = param[i]; in __ps2_command()
239 for (i = 0; i < receive; i++) in __ps2_command()
240 param[i] = ps2dev->cmdbuf[(receive - 1) - i]; in __ps2_command()
|
| /drivers/net/ethernet/ibm/emac/ |
| D | Kconfig | 11 int "Number of receive buffers"
35 Additional receive skb headroom. Note, that driver
|
| /drivers/isdn/hisax/ |
| D | hfc_2bs0.c | 331 int receive, transmit, count = 5; in main_irq_hfc() local
342 receive = 0; in main_irq_hfc()
352 receive = 1; in main_irq_hfc()
355 if (receive || (bcs->mode == L1_MODE_TRANS)) { in main_irq_hfc()
373 receive = 1; in main_irq_hfc()
393 if ((receive || transmit) && count) in main_irq_hfc()
|
| D | hfc_pci.c | 454 int receive, count = 5; in main_rec_hfcpci() local
502 receive = 1; in main_rec_hfcpci()
504 receive = 0; in main_rec_hfcpci()
506 receive = hfcpci_empty_fifo_trans(bcs, bz, bdata); in main_rec_hfcpci()
508 receive = 0; in main_rec_hfcpci()
510 if (count && receive) in main_rec_hfcpci()
832 int receive, count = 5; in receive_emsg() local
914 receive = 1; in receive_emsg()
916 receive = 0; in receive_emsg()
918 receive = 0; in receive_emsg()
[all …]
|
| D | hfc_2bds0.c | 356 int receive, count = 5; in main_rec_2bds0() local
393 receive = 1; in main_rec_2bds0()
395 receive = 0; in main_rec_2bds0()
397 receive = 0; in main_rec_2bds0()
399 if (count && receive) in main_rec_2bds0()
|
| D | arcofi.c | 73 if (cs->dc.isac.arcofi_list->receive) { in arcofi_fsm()
|
| /drivers/net/ |
| D | macvlan.c | 127 return vlan->receive(skb); in macvlan_broadcast_one()
228 ret = vlan->receive(skb); in macvlan_handle_frame()
663 int (*receive)(struct sk_buff *skb), in macvlan_common_newlink()
709 vlan->receive = receive; in macvlan_common_newlink()
|
| /drivers/s390/crypto/ |
| D | ap_bus.c | 839 ap_dev->drv->receive(ap_dev, ap_msg, ERR_PTR(-ENODEV)); in __ap_flush_queue()
844 ap_dev->drv->receive(ap_dev, ap_msg, ERR_PTR(-ENODEV)); in __ap_flush_queue()
1332 ap_dev->drv->receive(ap_dev, ap_msg, ap_dev->reply); in ap_poll_read()
1453 ap_dev->drv->receive(ap_dev, ap_msg, ERR_PTR(-EINVAL)); in __ap_queue_message()
1456 ap_dev->drv->receive(ap_dev, ap_msg, ERR_PTR(-ENODEV)); in __ap_queue_message()
1485 ap_dev->drv->receive(ap_dev, ap_msg, ERR_PTR(-ENODEV)); in ap_queue_message()
|
| D | ap_bus.h | 140 void (*receive)(struct ap_device *, struct ap_message *, member
|
| /drivers/net/ethernet/marvell/ |
| D | Kconfig | 72 transmit and receive rings.
107 transmit and receive rings.
|
| /drivers/scsi/ |
| D | 53c700.scr | 30 ABSOLUTE StatusAddress = 0 ; Addr to receive status return
31 ABSOLUTE ReceiveMsgAddress = 0 ; Addr to receive msg
185 ; receive it correctly
|
| /drivers/rapidio/ |
| D | Kconfig | 19 enable and a Input port receive enable. The recommended state
|
| /drivers/net/team/ |
| D | team_mode_activebackup.c | 108 .receive = ab_receive,
|
| D | team.c | 324 !team->mode || !team->mode->ops->receive) in team_adjust_ops()
325 team->ops.receive = team_dummy_receive; in team_adjust_ops()
327 team->ops.receive = team->mode->ops->receive; in team_adjust_ops()
428 res = team->ops.receive(team, port, skb); in team_handle_frame()
|
| /drivers/atm/ |
| D | Kconfig | 76 receive (RX) direction.
121 Burst sixteen words at once in the receive direction. This may work
128 Burst eight words at once in the receive direction. This may work
136 Burst four words at once in the receive direction. This is the
144 Burst two words at once in the receive direction. You may want to
|
| /drivers/net/hamradio/ |
| D | Kconfig | 42 radio. If you say Y here, you will be able to send and receive AX.25
54 modem), in order to send and receive AX.25 packet radio network
108 Some transmitters feed the transmitted signal back to the receive
|
| D | baycom_epp.c | 561 static int receive(struct net_device *dev, int cnt) in receive() function
693 if (receive(dev, cnt)) in epp_bh()
735 if (receive(dev, cnt)) in epp_bh()
746 if (receive(dev, 1)) in epp_bh()
|
| /drivers/spi/ |
| D | spi-fsl-espi.c | 34 __be32 receive; /* 0x014 - eSPI receive FIFO access register*/ member
524 rx_data = mpc8xxx_spi_read_reg(®_base->receive); in fsl_espi_cpu_irq()
529 rx_data_8 = in_8((u8 *)®_base->receive); in fsl_espi_cpu_irq()
|
| /drivers/scsi/libsas/ |
| D | Kconfig | 46 Allows sas hosts to receive SMP frames. Selecting this
|
| /drivers/infiniband/ |
| D | Kconfig | 19 userspace processes to send and receive MADs. You will also
|
| /drivers/net/ethernet/adi/ |
| D | Kconfig | 54 int "Number of receive buffer packets"
|
| /drivers/dma/ |
| D | Kconfig | 269 bool "Network: TCP receive copy offload"
274 offload receive copy-to-user operations, freeing CPU cycles.
|
| /drivers/staging/rtl8192e/ |
| D | license | 30 wish), that you receive source code or can get it if you want it, that you
41 must make sure that they, too, receive or can get the source code. And you
84 as you receive it, in any medium, provided that you conspicuously and
208 receive copies directly or indirectly through you, then the only way you
|
| /drivers/staging/rtl8192u/ |
| D | copying | 24 this service if you wish), that you receive source code or can get it
35 you have. You must make sure that they, too, receive or can get the
80 source code as you receive it, in any medium, provided that you
206 all those who receive copies directly or indirectly through you, then
|
| /drivers/staging/usbip/userspace/ |
| D | COPYING | 24 this service if you wish), that you receive source code or can get it
35 you have. You must make sure that they, too, receive or can get the
80 source code as you receive it, in any medium, provided that you
206 all those who receive copies directly or indirectly through you, then
|