Searched refs:when (Results 1 – 25 of 126) sorted by relevance
123456
| /drivers/media/dvb/frontends/ |
| D | Kconfig | 26 A DVB-S/S2/DSS Multistandard demodulator. Say Y when you want
35 demodulator. Say Y when you want to support this tuner.
43 Say Y when you want to support these frontends.
62 Say Y when you want to support this frontend.
71 Say Y when you want to support this tuner.
81 A DVB-S tuner module. Say Y when you want to support this frontend.
88 A DVB-S tuner module. Say Y when you want to support this frontend.
95 A DVB-S tuner module. Say Y when you want to support this frontend.
102 A DVB-S tuner module. Say Y when you want to support this frontend.
109 A DVB-S tuner module. Say Y when you want to support this frontend.
[all …]
|
| /drivers/block/paride/ |
| D | Transition-notes | 3 only when ps_tq_active is 1.
14 A and each B is preceded by either A or C. Moments when we enter
25 case when pd_req is NULL.
37 * in ps_tq_int(): from the moment when we get ps_spinlock() to the
39 * in pi_schedule_claimed() when called from pi_do_claimed() called from
42 * in pi_do_claimed() when called from pd.c, everything until the call
46 the moment when pi_spinlock has been acquired.
58 Proof: consider the first moment when the above is not true.
68 d) ps_tq_int() can enter the area only when the thread is holding
77 f) pi_wake_up() can enter the area only when the thread is holding
[all …]
|
| /drivers/char/ |
| D | mmtimer.c | 680 unsigned long when, period, irqflags; in sgi_timer_set() local
690 when = timespec_to_ns(&new_setting->it_value); in sgi_timer_set()
693 if (when == 0) in sgi_timer_set()
707 if (when > now) in sgi_timer_set()
708 when -= now; in sgi_timer_set()
711 when = 0; in sgi_timer_set()
719 when = (when + sgi_clock_period - 1) / sgi_clock_period + rtc_time(); in sgi_timer_set()
740 timr->it.mmtimer.expires = when; in sgi_timer_set()
|
| /drivers/staging/media/solo6x10/ |
| D | TODO | 13 * switch between 4 frames/irq to 1 when using mjpeg (and then back
14 when not)
|
| /drivers/parisc/ |
| D | README.dino | 5 ** the behavior of five models of HP VISUALIZE workstations when
9 ** when data is transmitted through PCI I/O expansion cards on the
|
| /drivers/media/dvb/mantis/ |
| D | Kconfig | 25 Say Y when you have a Mantis based DVB card and want to use it.
36 Say Y when you have a Hopper based DVB card and want to use it.
|
| /drivers/tty/hvc/ |
| D | Kconfig | 18 pSeries machines when partitioned support a hypervisor virtual
83 This is meant to be used during HW bring up or debugging when
119 which will also be compiled when this driver is built as a
|
| /drivers/net/wireless/libertas/ |
| D | README | 150 This event is generated when the average received RSSI in beacons goes
154 This event is generated when the average received RSSI in beacons goes
158 This event is generated when the average received SNR in beacons goes
162 This event is generated when the average received SNR in beacons goes
226 All entries in the scan table (not just the new scan data when keep=1)
|
| /drivers/staging/android/ |
| D | Kconfig | 25 because it can discard shared memory units when under memory pressure.
67 Register processes to be killed when memory is low
|
| /drivers/mtd/nand/ |
| D | Kconfig | 35 This adds an extra check when data is written to the flash. The
64 Enable this option only when your board has first generation
161 Enable the use of the BF5XX's internal ECC generator when
212 Enable the use of the controller's internal ECC generator when
229 Stop the clock to the NAND controller when there is no chip
231 when the is NAND chip selected or released, but will save
232 approximately 5mA of power when there is nothing happening.
281 range which get upset when they are probed.
381 Use hardware ECC instead of software ECC when the chip
453 block, such as SD card. So pay attention to it when you enable
|
| /drivers/scsi/arm/ |
| D | acornscsi.h | 257 unsigned long when; member
266 host->status[(_q)][host->status_ptr[(_q)]].when = jiffies; \
|
| /drivers/staging/media/lirc/ |
| D | TODO.lirc_zilog | 13 lirc_zilog to prevent removal of lirc_zilog when the /dev/lircN device node
26 to bring the chip back to normal when it hangs, in the same places the
|
| /drivers/mtd/chips/ |
| D | Kconfig | 51 data bits when writing the 'magic' commands to the chips. Saying
52 'NO', which is the default when CONFIG_MTD_CFI_ADV_OPTIONS isn't
165 programmable (OTP) bits; when programmed, register bits cannot be
172 because the Lock Register bits themselves are OTP, when programmed,
173 Lock Register bits cannot be erased. Therefore, when a Protection
|
| /drivers/staging/media/easycap/ |
| D | README | 36 present for about a minute but will then freeze when this situation arises.
63 bars whether to display testcard bars when incoming video signal is lost
114 with conveniently relaxed permissions when the EasyCAP is plugged in, a file
|
| /drivers/usb/otg/ |
| D | Kconfig | 3 # or OTG-capable configurations when OTG transceivers or controllers
16 bool "Hold a wakelock when USB connected"
20 Select this to automatically hold a wakelock when USB is
|
| /drivers/cpufreq/ |
| D | Kconfig | 75 you to set the CPU frequency manually or when a userspace
139 Enable this cpufreq governor when you either want to set the
140 CPU frequency manually or when a userspace program shall
194 rather than jumping to 100% when speed is required.
|
| /drivers/staging/iio/ |
| D | TODO | 18 1) Open question of userspace vs kernel space balance when
65 CC the device-drivers-devel@blackfin.uclinux.org mailing list when
|
| /drivers/net/wireless/iwlwifi/ |
| D | Kconfig | 36 determine which directory FIRMWARE_DIR is set to when the script
101 If unsure, say Y so we can help you better when problems
127 support when it is loaded.
|
| /drivers/misc/altera-stapl/ |
| D | Kconfig | 8 An Altera FPGA module. Say Y when you want to support this tool.
|
| /drivers/staging/sbe-2t3e3/ |
| D | TODO | 4 when available, convert the driver to it
|
| /drivers/staging/mei/ |
| D | mei.txt | 26 even when the operating system running on the host processor has crashed or
180 IT knows when a platform crashes even when there is a hard failure on the host.
184 and sends an event when the heartbeats stop.
|
| /drivers/atm/ |
| D | nicstarmac.copyright | 6 * 10/1/97 - commented out CFG_PHYIE bit - we don't care when the PHY
11 * loss of link, and correctly re-enable PHY when link is
|
| /drivers/usb/musb/ |
| D | Kconfig | 95 Enable DMA transfers when TI CPPI DMA is available.
102 Enable DMA transfers on TUSB 6010 when OMAP DMA is available.
|
| /drivers/net/wireless/orinoco/ |
| D | Kconfig | 73 orinoco) driver when used in PLX9052 based PCI adaptors. These
84 orinoco) driver when used in TMD7160 based PCI adaptors. These
94 orinoco) driver when used in Nortel emobility PCI adaptors. These
|
| /drivers/media/common/tuners/ |
| D | Kconfig | 12 when needed, for analog mode.
73 A DVB-T silicon tuner module. Say Y when you want to support this tuner.
80 A silicon tuner module. Say Y when you want to support this tuner.
|
123456