Lines Matching refs:is

7  This software file (the "File") is distributed by Marvell International
11  is available along with the File in the license.txt file or on the worldwide
49               device.   When raw is enabled, then it dumps the raw EEPROM data
51               tain portions of the EEPROM.  Default is to dump the entire EEP-
71 	location that is to be read.  This parameter must be specified in
85 	location and the value that is to be written. This parameters must
95 	This command is used to set the sleepclock configurations
105 			p1 is Sleep clock error in ppm (0-65535)
106 			p2 is Wakeup offset in usec (0-65535)
107 			p3 is Clock stabilization time in usec (0-65535)
108 			p4 is Control periodic calibration (0-2)
109 			p5 is Control the use of external sleep clock (0-2)
110 			p6 is reserved for debug (0-65535)
119 	Each event is represented by a filename. Each filename consists of the
129 	If it is set to 0, then the event is reported only once, and then
130 	automatically unsubscribed. If it is set to 1, then the event is
131 	reported every time it occurs. If it is set to N, then the event is
136 	triggers the LINK_LOSS event. This event is generated only once after
138 	event is subscribed by default. The default value of MissedBeacons is
143 	triggers the generation of the MAX_FAIL event. Once this event is
144 	generated, the consecutive failure count is reset to 0.
145 	At initialization, the MAX_FAIL event is NOT subscribed by
149 	This event is generated when the average received RSSI in beacons goes
153 	This event is generated when the average received RSSI in beacons goes
157 	This event is generated when the average received SNR in beacons goes
161 	This event is generated when the average received SNR in beacons goes
165 	This command is used to do a specific scan.
229 	This command is used to enable/disable host sleep.