• Home
  • Line#
  • Scopes#
  • Navigate#
  • Raw
  • Download
1 /*
2  *	linux/arch/alpha/kernel/pci_impl.h
3  *
4  * This file contains declarations and inline functions for interfacing
5  * with the PCI initialization routines.
6  */
7 
8 struct pci_dev;
9 struct pci_controller;
10 struct pci_iommu_arena;
11 
12 /*
13  * We can't just blindly use 64K for machines with EISA busses; they
14  * may also have PCI-PCI bridges present, and then we'd configure the
15  * bridge incorrectly.
16  *
17  * Also, we start at 0x8000 or 0x9000, in hopes to get all devices'
18  * IO space areas allocated *before* 0xC000; this is because certain
19  * BIOSes (Millennium for one) use PCI Config space "mechanism #2"
20  * accesses to probe the bus. If a device's registers appear at 0xC000,
21  * it may see an INx/OUTx at that address during BIOS emulation of the
22  * VGA BIOS, and some cards, notably Adaptec 2940UW, take mortal offense.
23  */
24 
25 #define EISA_DEFAULT_IO_BASE	0x9000	/* start above 8th slot */
26 #define DEFAULT_IO_BASE		0x8000	/* start at 8th slot */
27 
28 /*
29  * We try to make the DEFAULT_MEM_BASE addresses *always* have more than
30  * a single bit set. This is so that devices like the broken Myrinet card
31  * will always have a PCI memory address that will never match a IDSEL
32  * address in PCI Config space, which can cause problems with early rev cards.
33  */
34 
35 /*
36  * An XL is AVANTI (APECS) family, *but* it has only 27 bits of ISA address
37  * that get passed through the PCI<->ISA bridge chip. Although this causes
38  * us to set the PCI->Mem window bases lower than normal, we still allocate
39  * PCI bus devices' memory addresses *below* the low DMA mapping window,
40  * and hope they fit below 64Mb (to avoid conflicts), and so that they can
41  * be accessed via SPARSE space.
42  *
43  * We accept the risk that a broken Myrinet card will be put into a true XL
44  * and thus can more easily run into the problem described below.
45  */
46 #define XL_DEFAULT_MEM_BASE ((16+2)*1024*1024) /* 16M to 64M-1 is avail */
47 
48 /*
49  * APECS and LCA have only 34 bits for physical addresses, thus limiting PCI
50  * bus memory addresses for SPARSE access to be less than 128Mb.
51  */
52 #define APECS_AND_LCA_DEFAULT_MEM_BASE ((16+2)*1024*1024)
53 
54 /*
55  * Because MCPCIA and T2 core logic support more bits for
56  * physical addresses, they should allow an expanded range of SPARSE
57  * memory addresses.  However, we do not use them all, in order to
58  * avoid the HAE manipulation that would be needed.
59  */
60 #define MCPCIA_DEFAULT_MEM_BASE ((32+2)*1024*1024)
61 #define T2_DEFAULT_MEM_BASE ((16+1)*1024*1024)
62 
63 /*
64  * Because CIA and PYXIS have more bits for physical addresses,
65  * they support an expanded range of SPARSE memory addresses.
66  */
67 #define DEFAULT_MEM_BASE ((128+16)*1024*1024)
68 
69 /* ??? Experimenting with no HAE for CIA.  */
70 #define CIA_DEFAULT_MEM_BASE ((32+2)*1024*1024)
71 
72 #define IRONGATE_DEFAULT_MEM_BASE ((256*8-16)*1024*1024)
73 
74 #define DEFAULT_AGP_APER_SIZE	(64*1024*1024)
75 
76 /*
77  * A small note about bridges and interrupts.  The DECchip 21050 (and
78  * later) adheres to the PCI-PCI bridge specification.  This says that
79  * the interrupts on the other side of a bridge are swizzled in the
80  * following manner:
81  *
82  * Dev    Interrupt   Interrupt
83  *        Pin on      Pin on
84  *        Device      Connector
85  *
86  *   4    A           A
87  *        B           B
88  *        C           C
89  *        D           D
90  *
91  *   5    A           B
92  *        B           C
93  *        C           D
94  *        D           A
95  *
96  *   6    A           C
97  *        B           D
98  *        C           A
99  *        D           B
100  *
101  *   7    A           D
102  *        B           A
103  *        C           B
104  *        D           C
105  *
106  *   Where A = pin 1, B = pin 2 and so on and pin=0 = default = A.
107  *   Thus, each swizzle is ((pin-1) + (device#-4)) % 4
108  *
109  *   pci_swizzle_interrupt_pin() swizzles for exactly one bridge.  The routine
110  *   pci_common_swizzle() handles multiple bridges.  But there are a
111  *   couple boards that do strange things.
112  */
113 
114 
115 /* The following macro is used to implement the table-based irq mapping
116    function for all single-bus Alphas.  */
117 
118 #define COMMON_TABLE_LOOKUP						\
119 ({ long _ctl_ = -1; 							\
120    if (slot >= min_idsel && slot <= max_idsel && pin < irqs_per_slot)	\
121      _ctl_ = irq_tab[slot - min_idsel][pin];				\
122    _ctl_; })
123 
124 
125 /* A PCI IOMMU allocation arena.  There are typically two of these
126    regions per bus.  */
127 /* ??? The 8400 has a 32-byte pte entry, and the entire table apparently
128    lives directly on the host bridge (no tlb?).  We don't support this
129    machine, but if we ever did, we'd need to parameterize all this quite
130    a bit further.  Probably with per-bus operation tables.  */
131 
132 struct pci_iommu_arena
133 {
134 	spinlock_t lock;
135 	struct pci_controller *hose;
136 #define IOMMU_INVALID_PTE 0x2 /* 32:63 bits MBZ */
137 #define IOMMU_RESERVED_PTE 0xface
138 	unsigned long *ptes;
139 	dma_addr_t dma_base;
140 	unsigned int size;
141 	unsigned int next_entry;
142 	unsigned int align_entry;
143 };
144 
145 #if defined(CONFIG_ALPHA_SRM) && \
146     (defined(CONFIG_ALPHA_CIA) || defined(CONFIG_ALPHA_LCA) || \
147      defined(CONFIG_ALPHA_AVANTI))
148 # define NEED_SRM_SAVE_RESTORE
149 #else
150 # undef NEED_SRM_SAVE_RESTORE
151 #endif
152 
153 #if defined(CONFIG_ALPHA_GENERIC) || defined(NEED_SRM_SAVE_RESTORE)
154 # define ALPHA_RESTORE_SRM_SETUP
155 #else
156 # undef ALPHA_RESTORE_SRM_SETUP
157 #endif
158 
159 #ifdef ALPHA_RESTORE_SRM_SETUP
160 /* Store PCI device configuration left by SRM here. */
161 struct pdev_srm_saved_conf
162 {
163 	struct pdev_srm_saved_conf *next;
164 	struct pci_dev *dev;
165 };
166 
167 extern void pci_restore_srm_config(void);
168 #else
169 #define pdev_save_srm_config(dev)	do {} while (0)
170 #define pci_restore_srm_config()	do {} while (0)
171 #endif
172 
173 /* The hose list.  */
174 extern struct pci_controller *hose_head, **hose_tail;
175 extern struct pci_controller *pci_isa_hose;
176 
177 extern unsigned long alpha_agpgart_size;
178 
179 extern void common_init_pci(void);
180 #define common_swizzle pci_common_swizzle
181 extern struct pci_controller *alloc_pci_controller(void);
182 extern struct resource *alloc_resource(void);
183 
184 extern struct pci_iommu_arena *iommu_arena_new_node(int,
185 						    struct pci_controller *,
186 					            dma_addr_t, unsigned long,
187 					            unsigned long);
188 extern struct pci_iommu_arena *iommu_arena_new(struct pci_controller *,
189 					       dma_addr_t, unsigned long,
190 					       unsigned long);
191 extern const char *const pci_io_names[];
192 extern const char *const pci_mem_names[];
193 extern const char pci_hae0_name[];
194 
195 extern unsigned long size_for_memory(unsigned long max);
196 
197 extern int iommu_reserve(struct pci_iommu_arena *, long, long);
198 extern int iommu_release(struct pci_iommu_arena *, long, long);
199 extern int iommu_bind(struct pci_iommu_arena *, long, long, struct page **);
200 extern int iommu_unbind(struct pci_iommu_arena *, long, long);
201 
202 
203