Searched refs:already (Results 1 – 25 of 29) sorted by relevance
12
| /drivers/gpu/drm/amd/amdgpu/ |
| D | Kconfig | 8 CIK is already supported in radeon. CIK support in amdgpu
16 This option selects CONFIG_MMU_NOTIFIER if it isn't already
|
| /drivers/block/paride/ |
| D | Transition-notes | 62 In the first case the thread was already in the area. In the second,
64 mean that (2) was already not true.
70 (3) was already not true.
79 pd.c. It means that (4) was already not true.
87 we were acquiring the lock, (1) would be already false, since
90 already false.
118 can be killed. Indeed, we are not holding pd_lock and thus pd_busy is already
|
| /drivers/gpu/drm/radeon/ |
| D | Kconfig | 6 This option selects CONFIG_MMU_NOTIFIER if it isn't already
|
| /drivers/mfd/ |
| D | sm501.c | 333 goto already; in sm501_unit_power()
341 goto already; in sm501_unit_power()
349 goto already; in sm501_unit_power()
353 goto already; in sm501_unit_power()
372 goto already; in sm501_unit_power()
383 already: in sm501_unit_power()
|
| /drivers/gpu/drm/omapdrm/ |
| D | TODO | 11 already. Possibly this could be refactored out and made more common?
|
| /drivers/staging/slicoss/ |
| D | TODO | 8 - don't cast netdev_priv it is already void
|
| /drivers/staging/sm750fb/ |
| D | readme | 19 it will create fb0 and fb1 (or fb1,fb2 if fb0 already exist) under /dev
|
| /drivers/staging/media/lirc/ |
| D | TODO.lirc_zilog | 24 to lirc_zilog via struct IR_i2c_init_data. cx18 and ivtv already have routines
|
| /drivers/staging/android/ |
| D | TODO | 24 such cma regions must already be used by some device for dma. I.e. ion only
|
| /drivers/staging/speakup/ |
| D | TODO | 22 as was already done for the serial port driving part.
|
| /drivers/gpu/drm/nouveau/nvkm/subdev/pmu/fuc/ |
| D | kernel.fuc | 339 // if current process already has a timer set, bail
356 // check for a pending interrupt. if there's one already
364 // or if there's no timeout already set
|
| /drivers/mtd/ |
| D | nftlmount.c | 163 device is already correct. in find_boot_record()
230 The new DiskOnChip driver already scanned the bad block table. Just query it. in find_boot_record()
|
| /drivers/crypto/caam/ |
| D | Kconfig | 51 Note: the driver already provides adequate
|
| /drivers/scsi/aic7xxx/ |
| D | aic79xx.seq | 636 * already gone free prior to clearing
822 * already gone free prior to clearing
1429 * and that REQ is already set when inb_first is called. inb_{first,next}
1642 * unless we already know that we should be bitbucketing.
1659 * doesn't discard data already in the FIFO.
1717 * that the controller may have already transferred
1853 * after we have already trained for data-out, it is
1858 * we have already prefetched data into our FIFO (LQ/Data
1864 * a continuation of a transfer already setup in our FIFO
1885 * already seen and acked (REQINIT never comes true).
[all …]
|
| D | aic7xxx.seq | 55 * SCB that we've already pulled from the QINFIFO and started the selection
572 * the total for the command since we've already fetched
1042 * have already transferred some overrun bytes into
1080 * already correct. If we are not on the last
1970 * and that REQ is already set when inb_first is called. inb_{first,next}
|
| /drivers/net/wireless/ath/ath9k/ |
| D | Kconfig | 32 cards, laptops that already ship with these cards and
|
| /drivers/net/wireless/ipw2x00/ |
| D | Kconfig | 149 Note, normal debug code is already compiled in. This low level
|
| /drivers/net/hamradio/ |
| D | Kconfig | 13 the advantage that it is already supported by most modern TNCs
|
| /drivers/media/usb/pwc/ |
| D | philips.txt | 175 - If a device node is already occupied, registration will fail and
|
| /drivers/thermal/ |
| D | Kconfig | 133 reduction. An ACPI version of this already exists
|
| /drivers/tty/serial/8250/ |
| D | Kconfig | 45 they already did.
|
| /drivers/gpu/drm/nouveau/nvkm/engine/gr/fuc/ |
| D | hub.fuc | 547 // to change this state... The nouveau DRM already builds this list as
|
| /drivers/staging/unisys/Documentation/ |
| D | overview.txt | 45 guest, the already-existing efifb Linux driver is used to provide guest
|
| /drivers/block/ |
| D | rbd.c | 5545 bool already = false; in do_rbd_remove() local
5574 already = test_and_set_bit(RBD_DEV_FLAG_REMOVING, in do_rbd_remove()
5579 if (ret < 0 || already) in do_rbd_remove()
|
| /drivers/video/fbdev/ |
| D | Kconfig | 914 mostly initialized the card already. It is treated as a
927 mostly initialized the card already. It is treated as a
939 the system firmware has mostly initialized the card already. It
|
12